2
INSTALLATION
PRIOR TO CONNECTING
CH C HE K T AT T EHVOLTAGE on the rating plate
corresponds to the voltage in your home.
AFTER CONNECTING
T HE OVEN CAN BE OPERATED ONLY if the oven door is
rmly closed.
DO NOT RE T E I MOVE H M CROWAVE INLET PROTECTION
PLATES located on the side of the oven cavity
wall. They prevent grease & food particles from
entering the microwave inlet channels.
ENSURE T T E APPLIAN E IS NOT AGED HAT H C DAM. Check
that the oven door closes rmly against the
door support and that the internal door seal is
not damaged. Empty the oven and clean the
interior with a soft, damp cloth.
IMPORTANT!
A PER ANENTM C CONNE TION REQUIRES the installation
of a separating device. The separating device
must have an omnipolar contact opening of
more than 3 mm including LS switches, safety
valves and relays. The separating device must
be connected directly to the terminal.
The manufacturers are not liable for any
problems caused by the user’s failure to
observe these instructions.
TH H H CE EART ING OF T IS APPLIAN E is compulsory.
The manufacturer will accept no responsibility
for injury to persons, animals or damage to
objects arising from the non-observance of this
requirement.
I ,N T EH CASE OF A PER ANENTM C CONNE TION the
appliance should be installed by a quali ed
technician.
ENSURE the oven cavity is empty before
mounting.
DO NOT OPERATE T IS APPLIAN E H C if it has a damaged
mains cord or plug, if it is not working properly,
or if it has been damaged or dropped. Do not
immerse the mains cord or plug in water. Keep
the cord away from hot surfaces. Electrical
shock, re or other hazards may result.
Follow the supplied separate mounting instructions
when installing the appliance.
D O NOT USE EXTENSION CORD:
IF T E H POWER SUPPLY CORD IS TOO SHORT, have
a qualified electrician or serviceman in-
stall an outlet near the appliance.