Bauknecht GSIK 6518 BR Manual

Bauknecht Opvaskemaskine GSIK 6518 BR

Læs gratis den danske manual til Bauknecht GSIK 6518 BR (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 11 anmeldelser. Har du et spørgsmål om Bauknecht GSIK 6518 BR, eller vil du spørge andre brugere om produktet?

Side 1/8
5019 496 01062
1
GB GSIK 6518
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison
test and other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 - November 2001.
1. OVERVIEW
Programme selector
START button
The indicator lights up during operation, flashes when a
fault occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected
programme and options are cancelled. Main failure
displays (repeated flashing of the START indicator lamp)
can be cancelled by RESETTING. Detailed instructions
are given in chapter 5 “What to do, in the event of...”.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Fault indication and wash time display
In normal operation it indicates the remaining time
(h:mm), whereas with “Delayed start” selected it
indicates the time remaining until programme start (hh).
If “F..” appears on the display, see chapter 5 What to do,
in the event of.
“Delayed start” button
Press the button (repeatedly) to delay the start of the
programme. Adjustable from 1 to 24 hours. With each
press of the button, the delayed start indicator increases
by one hour and after 24 restarts from 00. Then press
the START button. The dishwasher will start after the set
time.
On / Off button
Table 1.1.
Table of programmes Detergent
dispenser Consumption 1)
PProgrammes Selectable
extra
functions Loading instructions large small Litres kWh Minutes
1Rapid 40°C Slightly soiled crockery,, without dry
residuals. X 10.0 0.65 30 ± 1)
2Bio Normal 2) 50°C Normally soiled crockery,. Energy-saving
programme. X X 13.0 1.05 165 ± 1)
3Intensive 70°C Recommended programme for heavily
soiled crockery, especially suitable for pans
and saucepans. X X 14.0 1.55 155 ± 1)
4Hygienic +3)
Normally or heavily soiled crockery, with
additional antibacterial wash. An interruption
of the programme (e.g. due to door opening)
can compromise elimination of germs.
X X 13.0 1.50 115 ± 1)
5Half load 50°C Ideal for washing a half load of lightly or
normally soiled crockery. X X 10.0 1.04 145 ± 1)
2
2. QUICK REFERENCE GUIDE
Detailed instructions are given on the following pages; also see section “5. What to do, in case of...
1. Switch on the
appliance Press the ON/OFF button.
2. Select a programme Press the button “Select programme” or the programme selector to display the
selected programme. If required, select possible options.
3. Select the type of
detergent The detergent selection procedure varies depending on the dishwasher model.
Chapter “1. Overview” provides instructions for selecting detergent type.
4. Fill in the detergent 4a. Powder/gel/tabs
Fill the detergent dispenser compartments in
accordance with the wash programme selected.
Large compartment A for every wash cycle, additional
small compartment B for programmes with pre-wash
(see table 1.1.).
4b. Combined action detergents (2 in 1/3 in 1/... etc.)
Place the detergent in compartment A or in the cutlery
basket, as per the manufacturer's recommendations.
5. Check the rinse aid
level
6. Check the salt level Depending on the model:
7. Load the racks
Make sure that the spray arms can turn freely and are not impeded by crockery
or cutlery in the racks.
Detailed instructions on loading the racks are given in chapter “3. How to use
the appliance”, under “How to load the racks”.
8. Open the water tap
and close the door
9. Start the appliance Press the START button.
Wash cycle
If the appliance is switched off during a
wash cycle, when switched on again it will
resume the cycle from where it was
interrupted. Care must be taken when
opening the door, as steam will escape!
10.End of programme The START indicator lamp switches off at the end of the programme.
11.Switch off the
appliance Press the OFF button. All the indicator lamps switch off.
12.Turn off the water
tap, unload the racks
Unload the appliance, starting from the lower rack in order to avoid any
residual drips of water falling onto crockery below.
AC
B
Visual indicator in dispenser C
dark sufficient rinse aid present,
clear add rinse aid (approx. 100 ml).
The indicator lamp on the control panel lights up when rinse aid
needs to be added. Not all models are equipped with such an
indicator.
window in salt reservoir cap on bottom of appliance inside
orange when sufficient salt is present,
clear when salt needs to be added.
The indicator lamp on the control panel lights up when salt needs
to be added. Even once salt has been added, the indicator lamp
only switches off after several wash cycles!
Changing the programme
in progress:
- Keep the START button pressed
for about 2 seconds until the
START indicator goes off.
- (Water drains for up to 60
seconds).
- Select the programme again.
- Press the Start button.


Produkt Specifikationer

Mærke: Bauknecht
Kategori: Opvaskemaskine
Model: GSIK 6518 BR

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GSIK 6518 BR stil et spørgsmål nedenfor, og andre brugere vil svare dig