Bauknecht WAB 1210 SW Manual

Bauknecht Vaskemaskine WAB 1210 SW

Læs gratis den danske manual til Bauknecht WAB 1210 SW (16 sider) i kategorien Vaskemaskine. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Bauknecht WAB 1210 SW, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

INSTRUCTIONS FOR USE

DEFINITION OF USE

BEFORE USING THE WASHING MACHINE

FIRST WASH CYCLE

PRECAUTIONS AND GENERAL RECOMMENDATIONS

DESCRIPTION OF THE WASHING MACHINE

CHILD SAFETY

DETERGENTS AND ADDITIVES

DRAINING RESIDUAL WATER

REMOVING THE FILTER

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

TRANSPORT AND HANDLING

ACCESSORIES

INSTALLATION

ELECTRICAL CONNECTION

DEFINITION OF USE

This appliance is exclusively destined to wash and

spin machine washable laundry in private

households.

•Observe the instructions given in these Instructions

for Use and in the separate Programme Chart when

using the washing machine.

•Keep these Instructions for Use and the Programme

Chart; if you pass on the washing machine to

another person, also give him/her the Instructions

for Use and the Programme Chart.

BEFORE USING THE WASHING MACHINE

1.Remove the packaging and check

•After unpacking, make sure that the washing

machine is undamaged. If in doubt, do not use

the washing machine. Contact After-Sales

Service or your local dealer.

•Keep the packaging materials (plastic bags,

polystyrene parts, etc.) out of reach of children,

since it is a possible source of danger.

•If the appliance was exposed to the cold prior to

delivery, keep it at room temperature for a few

hours before operating.

2.Remove the transit bolts

•The appliance is fitted with transit bolts to

prevent internal damage during transport.

Before using the washing machine you must

remove the transit bolts (see “Installation”/

”Remove the transit bolts”).

3.Install the washing machine

•Install the appliance on a solid and level floor

surface. In the case of a yielding sub-floor, the

appliance should be installed in the corner of a

room.

•Adjust the feet to ensure that the machine is

stable and level on the floor (see “Installation”/

”Adjust the feet”).

•In case of wooden or so-called “floating floors”

(for instance certain parquet or laminate floors),

place the appliance on a 70 x 70 cm sheet of

plywood at least 3 cm in thickness. The plywood

sheet must be screwed to the floor.

•Make sure that the ventilation openings in the

base of your washing machine (if available on

your washer) are not obstructed by a carpet or

other material.

4.Water inlet

•Connect the water supply inlet hose in accordance

with the regulations of your local water company

(see “Installation”/”Connect the water supply

hose(s)” and instructions on the hose bag).

• Water supply: Cold water only (if no other

information on programme

chart)

• Tap: 3/4” threaded hose connection

• Pressure: 100-1000 kPa (1-10 bar).

•Use only new hoses to connect the washing

machine to the water supply. Used hoses must

not be used and should be discarded.

5.Drain hose

•Connect the drain hose to the ventilated siphon or

hook it over the edge of a sink by means of the “U”

bend and secure it against falling down (see

“Installation”/“Connect the water drain hose”).

6.Electrical connections

•Electrical connections must be carried out by a

qualified electrician in compliance with the

manufacturer's instructions and local safety

regulations.

•Voltage information, power consumption and

electrical fusing data are supplied on the front

panel behind the door frame.

•The appliance must be connected to the mains

exclusively by means of a socket with an earth

connection in accordance with established

regulations. The appliance must be earthed by

law. The manufacturer declines all liability for

possible damage to property or injury to persons

or pets deriving from failure to observe the a/m

directions.

•Do not use extension leads or multi sockets.

•Before any maintenance on the washing

machine disconnect the power plug or switch oﬀ

the power supply.

•Access to the mains plug or to disconnection from

mains supply via a double-pole switch must be

ensured at all times following the installation.

•Do not operate the washing machine if it has

been damaged during transport. Inform the

After-Sales Service.

•Mains cable replacement is only to be carried out

by After-Sales Service.

•The washing machine must only be used in the

household for the prescribed uses.

Produkt Specifikationer

Mærke:	Bauknecht
Kategori:	Vaskemaskine
Model:	WAB 1210 SW

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht WAB 1210 SW stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Vaskemaskine Bauknecht Manualer

Bauknecht NM11 844 B CH Manual

4 August 2025

Bauknecht NBLCD 946E WS A EU Manual

4 August 2025

Bauknecht AW 7A3 N Manual

3 August 2025

Bauknecht W10 W6400 A Manual

3 August 2025

Bauknecht WM BK 10A CH A Manual

15 Juli 2025

Bauknecht Super Eco 845 A Manual

11 Juli 2025

Bauknecht WM Class 8AA Manual

5 Juli 2025

Bauknecht WAT 619 C EX Manual

4 Juli 2025

Bauknecht WT AO 86 43 N Manual

4 Juli 2025

Bauknecht WTL 56313 C Manual

30 Juni 2025

Vaskemaskine Manualer

Nyeste Vaskemaskine Manualer

Hisense WF3S1045BW3 Manual

14 August 2025

Hoover VT 810D11-S Manual

14 August 2025

Hoover H3WPS6106TAMB-S Manual

14 August 2025

Hoover HNFT S374TAH-S Manual

14 August 2025

Sharp ES-NFB014DWNAO-EN Manual

14 August 2025

Hoover HWQ4 47AMC/1-84 Manual

14 August 2025

Hoover DYN33 5125D2-30 Manual

14 August 2025

Hoover VHD 612/1-89S Manual

14 August 2025

Hoover WDXA 596AH/1-S Manual

14 August 2025

Hoover HWP 48AMBC7/1-S Manual

14 August 2025