BlendMount BMG-2017 Manual


Læs gratis den danske manual til BlendMount BMG-2017 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 10 anmeldelser. Har du et spørgsmål om BlendMount BMG-2017, eller vil du spørge andre brugere om produktet?

Side 1/2
Blend
IDaunf-®
Innovative
Mounting
Solutions
ESCORT
LEFT HAND DRIVE VEHICLE
INSTALLATION
INSTRUCTIONS
FOR
ESCORT
IX, REDLINE EX,
AND
360C
RADAR
DETECTORS
Your rear view mirror has minimal clearance between the back side
of
the mirror and the mirror stem. It is very important
that this mount is installed correctly to ensure mirror adjustability is retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For illustration purposes, the mount and rear view mirror shown in these instructions may look slightly different then YOUR
mount and rear view mirror.
3 - Install aluminum threaded
insert into magnet, and attach
magnet onto blendmount with lip
pointed in direction as shown.
1 - The magnet must be removed from the suction
cup mount that the radar detector came with.
UNSCREW
HERE
TOP
SECTION
MID
SECTION
2 - Unscrew and remove bolt, only the
magnetic piece is used with the blendmount.
CLEARANCE
FOR MIRROR
STEM
CLAMP
SCREW
4 - The Body Assembly must
be
removed to gain access to the CLAMP SCREW.
Remove the two socket head screws as shown above.
Be
sure to remove the lock
washer with the top screw along with the lock washer and flat washer with the
bottom screw. Loosen the Clamp Screw so there is enough clearance between
the TOP and MID SECTIONS to slide over the mirror stem.
PAGE 1 OF 2


Produkt Specifikationer

Mærke: BlendMount
Kategori: Ikke kategoriseret
Model: BMG-2017

Har du brug for hjælp?

Hvis du har brug for hjælp til BlendMount BMG-2017 stil et spørgsmål nedenfor, og andre brugere vil svare dig