Boston Acoustics Bravo 20 Manual


Læs gratis den danske manual til Boston Acoustics Bravo 20 (5 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 37 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 19 anmeldelser. Har du et spørgsmål om Boston Acoustics Bravo 20, eller vil du spørge andre brugere om produktet?

Side 1/5
1
OWNER’S MANUAL
Bravo 20
HigH performance multi-purpose speaker
2
Introduction
Thank you for choosing Boston Acoustics. The Boston Bravo® 20 is a multi-purpose, high performance compact loudspeaker.
The Bravo 20, which uses Bostons patented one-inch aluminum dome VR® tweeter with AMD and a 4½-inch woofer, can be
combined with its supplied mounting bracket or rear stand to be mounted or placed virtually anywhere in any room.
How to Connect Your Speakers
Correctly wiring your speakers is important for achieving the best sound quality. Wiring should take just a few minutes, but it’s
important to do it carefully, since incorrect wiring (such as reversed connections) can result in a poor soundstage and poor bass.
We recommend 18-gauge wire or thicker for runs up to 15 feet (4.5m), and 16-gauge wire or thicker for longer runs. Separate
the first few inches of the wire conductors. Strip off ½-inch (12mm) of insulation from the ends of each speaker wire to expose
the two conductors and tightly twist the wire strands.
WARNING: To prevent electrical shock hazard, always switch off the amplifier or receiver when making connections to the speaker.
IMPORTANT: Typically, one side of the wire is smooth.
Connect this side to the – (black) connection. The other side
has a rib or stripe. Connect this to the + (red) connection.
Using the spring terminal posts: The spring terminal
posts permit easy connection to banana plugs, spade lugs,
and bare wire. Push the the top of the terminal down by
approximately ¼-inch, exposing the hole. Insert the wire in
the hole and release the terminal.
¼"
Specifications
Frequency Range : (±3dB) 80Hz to 20kHz
Recommended Amplifier Power: 15–125 watts
Nominal Impedance: 8 ohms
Sensitivity 85dB [SPL/2.8v at 1m]: 89dB
Woofer: 4½” (115mm) copolymer
Tweeter: 1” (25mm) VR® aluminum dome with AMD
Crossover Frequency 2500Hz
Dimensions: (H x W x D)
with corner fillers 14¼ x 6½ x 5¼” (362 x 166 x 134mm)
without corner fillers 14¼ x 6½ x 4¼” (362 x 166 x 108mm)
Weight: 5 lbs (2.25kg)
Finish: White or black, textured ABS
with matching metal grille


Produkt Specifikationer

Mærke: Boston Acoustics
Kategori: Højttaler
Model: Bravo 20

Har du brug for hjælp?

Hvis du har brug for hjælp til Boston Acoustics Bravo 20 stil et spørgsmål nedenfor, og andre brugere vil svare dig