Casio Edifice EF-558D-2A Manual

Casio Ur Edifice EF-558D-2A

Læs gratis den danske manual til Casio Edifice EF-558D-2A (1 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Casio Edifice EF-558D-2A, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Operation Guide 5177

MA1005-EA

Your watch may differ somewhat from the one shown in the illustration. •



7+8

DayStopwatch second hand

Crown

(Normal position)

First click

(Day, day of week setting)

Second click

(Time setting)

Day of week

Second hand

Minute hand

Stopwatch minute handHour hand

Stopwatch hour hand

To set the time

When the second hand is at 12 o’clock, pull out the crown to the second click 1.

to stop it.

Set the hands by rotating the crown. Move the minute hand four or ﬁve minutes 2.

past the setting you want, and then back them up to the setting.

Push the crown back in on a time signal to resume timekeeping.3.

To set the day and day of the week

Avoid setting the day and day of the week between 9:00 p.m. and 6:00 a.m. The •

day and day of the week may not change in the following day if you do.

Pull out the crown to the ﬁrst click.1.

Set the day by rotating the crown counterclockwise.2.

Set the day of the week by rotating the crown clockwise.3.

Push the crown back in to its normal position.4.

Using the Stopwatch

The stopwatch lets you measure elapsed time up to 4 hours, 59 minutes,

59 seconds.

The illustration shows a time of 2 hours, 20 minutes, 40 seconds. •

Do not try to perform stopwatch operations while the crown is pulled out either •

to the ﬁrst or second click. If you try to press a button, you might accidentally

cause the crown to rotate and change the current time or day setting.

When an elapsed time measurement reaches ﬁve hours, the stopwatch hour •

hand will stop but the stopwatch minute and second hands will continue to

move.

To measure elapsed time

Press 1. to start the stopwatch.A

Press 2. to stop the stopwatch.A

You can resume the measurement operation by pressing •A again.

Press 3. to reset the stopwatch.B

Adjusting the Stopwatch Hands Position

Use of the stopwatch can cause the starting positions of the stopwatch hour

hand, minute hand and second hand to become misaligned. Use the following

procedures to check hand alignment and to adjust the positions of the hands so

they point to 12 o’clock when the stopwatch is reset.

To adjust the positions of the stopwatch hands

Press 1. B to reset the stopwatch, and check the alignment of the stopwatch

hour hand, minute hand and second hand.

Pull out the crown to the second click.2.

Press 3. to move the stopwatch second hand forward until it points to A

12 o’clock.

If the stopwatch minute hand is aligned correctly, proceed to step 5. If the 4.

stopwatch hour hand and stopwatch minute hand are also misaligned, press B

so the stopwatch hour hand and the stopwatch minute hand jump to ).0 (60

After making the adjustments you want, push the crown back in to its normal 5.

position.

Note that pulling the crown out also stops the timekeeping second hand. After •

performing the above procedure, you should also adjust the timekeeping setting.

For a watch with an elapsed time bezel ■

Rotate the elapsed time bezel to align the mark with the

minute hand.

After certain amount of time elapsed, read the graduation on

the elapsed time bezel which the minute hand points to.

The elapsed time is indicated.

Elapsed time bezel

Some water resistant models are equipped with a screw •

lock crown.

With such models, you must unscrew the crown in the •

direction noted in the illustration to loosen it before you can

pull it out. Do not pull too forcibly on such crowns.

Also note that such watches are not water resistant while •

their crowns are loosened. Be sure to screw the crowns

back in as far as they will go after making any setting.

Speciﬁcations

Accuracy at normal temperature: ± 20 seconds a month

Display: 3 analog hands (timekeeping hour and minutes, stopwatch seconds),

3 dials (timekeeping seconds, stopwatch hours and minutes), day, day of the

week

Stopwatch function: Measuring capacity: 4:59 59 /Measuring unit: 1 second' "

Measuring modes: Elapsed time

Battery: One silver oxide battery (Type: SR927W)

Approximately 5 years on type SR927W (assuming one stopwatch operation 60 min./day)

Produkt Specifikationer

Mærke:	Casio
Kategori:	Ur
Model:	Edifice EF-558D-2A

Har du brug for hjælp?

Hvis du har brug for hjælp til Casio Edifice EF-558D-2A stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ur Casio Manualer

Casio G-Shock GW-9400 Manual

23 Oktober 2025

Casio G-Shock GA-S110 Manual

14 September 2025

Casio AE2000W-1AV Manual

5 September 2025

Casio AEQ-110 Manual

4 September 2025

Casio G-Shock GA-700UC-3A Manual

28 Juli 2025

Casio Baby-G BSA-B100 Manual

27 Juli 2025

Casio G-Shock GM-110 Manual

27 Juli 2025

Casio G-Shock GM-S5600 Manual

27 Juli 2025

Casio Edifice EF-527D-1A Manual

27 Juli 2025

Casio Edifice EFR-571 Manual

27 Juli 2025

Ur Manualer

Nyeste Ur Manualer

Swiss Military Hanowa Immersion Chrono Manual

31 Oktober 2025

Breitling Lady Premier 32 Manual

31 Oktober 2025

Grandeux FS21 Manual

29 Oktober 2025

Breitling Lady Premier Automatic 36 Manual

29 Oktober 2025

Swiss Military Hanowa Ace Chrono Manual

26 Oktober 2025

Swiss Military Hanowa Aerograph Night Vision Manual

26 Oktober 2025

Swiss Military Hanowa Afterburner Chrono Manual

26 Oktober 2025

Swiss Military Hanowa Nautica Manual

26 Oktober 2025

Swiss Military Hanowa Triton Automatic Manual

25 Oktober 2025

Spin Master Fleuss SP-5055-01 Manual

20 Oktober 2025