Casio GD-120CM-4 Manual

Casio Ur GD-120CM-4

Læs gratis den danske manual til Casio GD-120CM-4 (6 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Casio GD-120CM-4, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

Operation Guide 3427

E-9

Switching Between Time Screens

Each press of cycles the time screens in the sequence shown below.D

Displayed for one second

D D D

E-8

Timekeeping

The Timekeeping Mode’s Multi Time feature gives you

quick and easy access to the current time and date in

four different cities, numbered from T-1 (Time 1) through

T-4 (Time 4). T-1 is your Home City Time, and T-2,

T-3, and T-4 are Local Times. Local Times are kept in

synchronization with your Home City Time (T-1).

PM indicator

Day of week

Hour : Minutes Seconds

Month – Day

E-7

Alarm Mode Stopwatch Mode

C C

Countdown Timer

Mode

E-6

General Guide

x Press to change from mode to mode. C

In any mode (except when a setting screen is on the display), press to illuminate B

the display.

Timekeeping Mode World Time Mode

C C

E-5

To measure times with the stopwatch ................................................................. E-31

To turn on illumination .......................................................................................... E-33

To specify the illumination duration .................................................................... E-33

To turn the auto light switch on and off .............................................................. E-35

To turn the button operation tone on and off ..................................................... E-38

To turn Flash Alert on and off .............................................................................. E-41

E-4

Procedure Lookup

The following is a handy reference list of all the operational procedures contained in

this manual.

To toggle the Timekeeping Mode time between DST and

Standard Time .................................................................................................... E-15

To view the time for another city code ................................................................ E-18

To toggle a city code time between Standard Time and

Daylight Saving Time ........................................................................................ E-19

To change your Home Time city to the current World Time city ...................... E-20

To set an alarm time .............................................................................................. E-22

To test the alarm .................................................................................................... E-24

To turn an alarm on and off .................................................................................. E-25

To turn the Hourly Time Signal on and off .......................................................... E-26

To conﬁ gure the countdown timer ...................................................................... E-28

To use the countdown timer ................................................................................. E-29

E-3

Contents

Indicators ................................................................................................................. E-2

General Guide ..........................................................................................................E-6

Timekeeping ............................................................................................................. E-8

World Time .............................................................................................................E-18

Alarms .................................................................................................................... E-21

Countdown Timer ..................................................................................................E-27

Stopwatch .............................................................................................................. E-30

Illumination ............................................................................................................ E-32

Reference ............................................................................................................... E-36

Speciﬁ cations ........................................................................................................E-44

E-2

Indicators

Graphic area A

page E-36

Graphic area B

page E-36

Auto light switch on indicator

page E-32, E-35

DST indicator

page E-15, E-19

PM indicator

page E-8, E-16

Hourly time signal on indicator

page E-26

Alarm on indicator

page E-21

Mute indicator

page E-37

Flash Alert on indicator

page E-41

E-1

About This Manual

x Depending on the model of your watch, display text appears

either as dark ﬁ gures on a light background or light ﬁ gures

on a dark background. All sample displays in this manual are

shown using dark ﬁ gures on a light background.

x Button operations are indicated using the letters shown in

the illustration.

x Each section of this manual provides you with the

information you need to perform operations in each mode.

Further details and technical information can be found in

the “Reference” section.

MA1310-EA

#!3)/#/-054%2#/,4$

Operation Guide 3427

E-19

To toggle a city code time between Standard Time and Daylight Saving Time

1. In the World Time Mode, use (east) to display the city D

code (time zone) whose Standard Time/Daylight Saving

Time setting you want to change.

2. Hold down for about one second to toggle Daylight A

Saving Time ( displayed) and Standard Time ( DST DST

not displayed).

x The indicator is on the display whenever you display DST

a city code for which Daylight Saving Time is turned on.

x Note that the DST/Standard Time setting affects only

the currently displayed city code. Other city codes are

not affected.

x Note that you cannot switch between Standard Time

and Daylight Saving Time while UTC is selected as the

city code.

DST indicator

E-18

World Time

World Time shows the current time in 48 cities (31 time

zones) around the world.

x All of the operations in this section are performed in

the World Time Mode, which you enter by pressing C

(page E-6).

To view the time for another city code

In the World Time Mode, press to scroll eastwardly D

through city codes.

x For full information about city codes, see the “City Code

Table” at the back of this manual.

x If the current time for a city is wrong, check your

Timekeeping Mode time and time zone settings and

make the necessary changes.

City code

Current time and date in

the zone of the selected

city code

E-17

Swapping the Home City Time with a Local Time

You can use the procedure below to swap the current Home City Time (T-1) with one

of the Local Times (T-2, T-3, T-4).

1. In the Timekeeping Mode, use to display the Local Time that you want to swap D

with the Home City Time.

2. Press and at the same time.A B

E-16

12/24-Hour Format

x With the 12-hour format, the (PM) indicator appears to the left of the hour digits for P

times in the range of noon to 11:59 p.m. and no indicator appears to the left of the

hour digits for times in the range of midnight to 11:59 a.m.

x With the 24-hour format, times are displayed in the range of 0:00 to 23:59, without

any indicator.

x The 12-hour/24-hour timekeeping format you select in the Timekeeping Mode is

applied in all other modes.

Changing the City Setting of a Local Time

You can select any one of the city codes in the table at the back of this manual as a

Local Time city.

1. Display the Local Time whose city setting you want to change, and then hold down

A for about one second until the current city code starts to ﬂ ash.

2. Use (east) and (west) to select the city code you want.D B

3. Press to display the DST setting screen.C

4. Press to toggle between Daylight Saving Time (D displayed) and Standard

Time ( displayed).

5. After the settings are the way you want, press .A

E-15

To toggle the Timekeeping Mode time between DST and Standard Time

1. Use to display the current Home City Time (T-1) D

screen.

2. Hold down until the seconds start to ﬂ ash, which A

indicates the setting screen.

3. Press to display the DST setting screen.C

4. Press to toggle between Daylight Saving Time D

( displayed) and Standard Time ( displayed).

5. Press to exit the setting screen.A

x The indicator appears on the Timekeeping screen to DST

indicate that Daylight Saving Time is turned on.

DST indicator

E-14

x See “Daylight Saving Time (DST)” on page E-14 for details about DST setting.

x For information about Flash Alert, see “Flash Alert” (page E-41).

5. Press to exit the setting screen.A

x The day of the week is displayed automatically in accordance with the date (year,

month, and day) settings.

Daylight Saving Time (DST)

Daylight Saving Time (summer time) advances the time setting by one hour from

Standard Time. Remember that not all countries or even local areas use Daylight

Saving Time.

E-13

Screen To do this: Do this:

Reset the seconds to .

Press .D

Toggle between Daylight Saving Time ( )

and Standard Time ( ).

Change the city code. Use (east) and (west).D B

Change the hour or minutes. Use (+) and (–).D B

Toggle between 12-hour ( ) and 24-hour

( ) timekeeping. Press .D

Change the year. Use (+) and (–).D B

Change the month or day.

Toggle the setting between 1.5 seconds

( ) and 3 seconds ( ).

Press .D

Toggle between Flash Alert on and ( )

off ( ).

E-12

Seconds DST

Illumination Duration Setting

MinutesHour

Year

12/24-Hour FormatFlash Alert

City Code

Day Month

C C C C CC

CC CCC

4. When the setting you want to change is ﬂ ashing, use and to change it as D B

described below.

E-11

Changing the Current Home City Time and Date Settings

1. Use to display the current Home City Time (T-1) D

screen.

2. Hold down until the seconds start to ﬂ ash, which A

indicates the setting screen.

3. Press to move the ﬂ ashing in the sequence shown C

below to select other settings.

E-10

x While the Home City Time (T-1) screen is displayed, pressing will switch the day A

of the week / month-day indication to the currently selected Home City code and the

T-1 indicator for about one second.

x You can change the current time setting for your Home City Time (T-1) only.

x For Local Times (T-2, T-3, T-4), you only can change the city code and DST setting.

Scrolling through the Time Screens

x In the Timekeeping Mode (page E-6), holding down for about three seconds will D

cycle the time screens in sequence, from T-1 through T-4.

x Pressing any button will display the Home City Time (T-1) screen.

Produkt Specifikationer

Mærke:	Casio
Kategori:	Ur
Model:	GD-120CM-4
Bredde:	51.2 mm
Dybde:	17.4 mm
Højde:	55 mm
Vægt:	72 g
Armbånd, materiale:	Resin
Vandfast:	Ja
Urkassens materiale:	Resin
Kalender:	Ja
Ur-indstilling:	12t/24t
Stopur:	Ja
Timer:	24 h
Urtype:	Armbåndsur
Batterilevetid:	7 År
LED-baggrundsbelysning:	Ja
Batteritype:	CR2025
Antal understøttede batterier:	1
Slagfast:	Ja
Urets glastype:	Mineral
Alarmfunktion:	Ja
Mekanismetype:	Elektronisk
Se opkaldstype:	LCD-skive
Vandbestandigt tryk:	20 ATM
Vandbestandig dybde:	200 m
Husets farve:	Black, Red
Båndets hovedfarve:	Black, Red
Etui form:	Rund
Nøjagtighed:	±15 sek/md
Kalendertype:	Dag
Nedtællingsur:	Ja
Verdenstid funktkon:	Ja