Casio MTF-E003G-1AVEF Manual

Casio Ur MTF-E003G-1AVEF

Læs gratis den danske manual til Casio MTF-E003G-1AVEF (1 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 58 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 29.5 anmeldelser. Har du et spørgsmål om Casio MTF-E003G-1AVEF, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Operation Guide 2711/4327

MA0504-EA

■ For watch with the elapsed time bezel

Rotate the elapsed time bezel to align the mark with the

minute hand.

After certain amount of time elapsed, read the graduation on the

elapsed time bezel which the minute hand points to.

The elapsed time is indicated.

• Some water resistant models are equipped with a screw lock

crown.

• With such models, you must unscrew the crown in the direction

noted in the illustration to loosen it before you can pull it out.

Do not pull too forcibly on such crowns.

• Also note that such watches are not water resistant while their

crowns are loosened. Be sure to screw the crowns back in as

far as they will go after making any setting.

To set the time

1. Pull out the crown to the second

click.

• This causes the second hand to

stop.

2. Set the hands by rotating the crown.

Move the minute hand four or five

minutes past the time you want to

set, and then back it up to the proper

setting.

Push the crown back in to the normal

position to restart timekeeping.

To set the day

1. Pull out the crown to the first click.

2. Set the day by rotating the crown.

3. Push the crown back in to the

normal position.

• Avoid setting the day between 9:00

p.m. and 1:00 a.m. (the day display

may not change in the following day).

Using the Stopwatch

The stopwatch lets you measure elapsed time up to 59 minutes, 59 seconds. You

can also correct the position of the stopwatch second hand when necessary.

• The illustration shows a time of 20 minutes, 40 seconds.

• Do not try to perform stopwatch operations while the crown is pulled out either to

the first or second click. If you try to press a button, you might accidentally cause

the crown to rotate and change the current time or day setting.

To measure elapsed time

1. Press A to start the stopwatch.

2. Press A to stop the stopwatch.

• You can resume the measurement operation by pressing again.A

3. Press B to reset the stopwatch.

Adjusting the Stopwatch Second and Minute Hand Positions

Use of the stopwatch can cause the starting positions of the stopwatch minute hand

and second hand to become misaligned. Use the following procedures to check hand

alignment and to adjust the positions of the hands so they point to 12 o’clock when

the stopwatch is reset.

To adjust the positions of the stopwatch hands

1. Press B to reset the stopwatch, and check the alignment of the stopwatch minute

hand and second hand.

2. Pull out the crown to the second click.

3. Press A to move the stopwatch second hand forward until it points to 12 o’clock.

4. If the stopwatch minute hand is aligned correctly, proceed to step 5. If the stopwatch

minute hand is also misaligned, press so the stopwatch minute hand jumps to B0.

5. After making the adjustments you want, push the crown back in to its normal position.

• Note that pulling the crown out also stops the timekeeping second hand. After

performing the above procedure, you should also adjust the timekeeping setting.

The configuration of your watch may differ

somewhat from that shown in the

illustration.

Second click

(Time setting)

Crown

(Normal position)

Hour hand

Minute hand

Day

Second hand

Stopwatch second

hand

Stopwatch

minute

hand

First click

(Day setting)

24-hour hand

Elapsed time bezel

Produkt Specifikationer

Mærke:	Casio
Kategori:	Ur
Model:	MTF-E003G-1AVEF
Vægt:	114 g
Dimensioner (BxDxH):	45 x 12.8 x 55 mm
Armbånd, materiale:	Resin
Urkassens materiale:	Rustfrit stål
Stopur:	Ja
Batterilevetid:	2 År
Batteritype:	SR927W
Antal understøttede batterier:	1
Urets glastype:	Mineral
Vandbestandig dybde:	100 m
Nøjagtighed:	±20 sek/md