I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8821-002023 Rev00
©2010 Milestone AV Technologies,
a Duchossois Group Company
09/10
NAS1S23/28 SHELVES
The NAS1S23/28 shelves are designed for use with Chief® Raxxess S1 Series racks. See the specific installation instructions provided with
the rack for additional installation information.
TOOLS REQUIRED / PARTS INCLUDED
WARNING: FAILURE TO READ, THOROUGHLY UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS CAN RESULT IN SERIOUS
PERSONAL INJURY, DAMAGE TO EQUIPMENT, OR VOIDING OF FACTORY WARRANTY! It is the installer’s responsibility to make
sure all components are properly assembled and installed using the instructions provided.
WARNING: EXCEEDING THE WEIGHT CAPACITY CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! It is the installer’s responsibility to make sure the combined weight of all components located on each shelf does not exceed
250 lbs (113.4 kg).
A (1)
[Shelf]
B (2)
[Bracket]
C (4)
#4-1/4"
D (4)
1/4-20 x 1/2"
E (4)
#4-40 F (4)
1/4-20
NOTE: The optional brackets (B) may be attached to the shelf to
keep components from being pushed toward back of shelf.
1. Align two brackets (B), as required, onto shelf (A). (See Figure 1)
2. Fasten brackets to shelf using four #4-40 x 1/4" studs (C) and
four #4-40 locknuts (E). (See Figure 1)
Figure 1
3. Attach shelf to rack using four 1/4-20 x 1/2" studs (D) and four
1/4-20 locknuts (F). (See Figure 2)
4. Attach additional shelves as required.
Figure 2
®Chief is a registered trademark of Milestone AV Technologies.
All rights reserved.
(A)
(B)
(E) x 4
2
(C) x 4
(B)
3
(A)
(D) x 4
(F) x 4
