CTA Digital PAD-AUTICC Manual

CTA Digital Ikke kategoriseret PAD-AUTICC

Læs gratis den danske manual til CTA Digital PAD-AUTICC (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om CTA Digital PAD-AUTICC, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

for iPad 8th Gen 10.2, iPad Pro 10.5 and iPad Air3

PAD-AUTICC

Vehicle Mount with Inductive Charging Case Kit

Package Contents:

Instructions:

2. Align Vehicle Seat Rail Clamp and the

Allen Key

Screw

Vechicle Mount and Screw as shown in

diagram above. Use Allen Key to screw together.

4. Installing Vehicle Seat Rail Clamp to the Vechile Rail

Because each vehicle is different, you will need to determine which included seat rail clamp is best for you.

1. Choose the base with the

angle that matches your needs.

Combine nuts and bolts throu

from the front & back as show

3. Place Tablet into Dock

Align the magnets. Please align the battery pack to the

battery pad on the right side so tablet will charge properly.

*Disclaimer - Ball Joint Warning

DO NOT attempt to adjust, tilt, or rotate

any ball socket joints while it is fully

tightened. Any such action will result in

possible damage and loss of integrity of

product functioning at full capacity.

Manufacturer will not be responsible for

any such actions by any person.

8.Adjusting Ball Joints

CAUTION! PLEASE READ

BEFORE USE!

5.Installing Vechicle Mount

to your Vechicle Seat Rail

Loose the bolt of the seat rail.

Install the assembled Vechicle Seat Rail

Clamp and Base set on the seat rail and

screw back the bolt.

6.Adjusting the Flex Arm

Joint for Preferred Positions

Twist the SCREW KNOB (Both or Either)

counter-clockwise to release the connection.

Adjust the arm to your preferred position and then

tighten the SCREW KNOB clockwise .

1. Peel the external

silicone sleeve from

the internal hard

case.

2. To open internal hard

case, apply gentle

pressure to the small

clips (as shown to the

left). The case will open

with all (4) sides are

unclipped.

3. Insert tablet into the back

portion of the hard cover.

4. Once tablet is in the back

portion of the case, look to the

bottom and plug the charging

cable into the power socket of

the tablet. After, place the

internal hard case front cover

on the top of the case and clip

all (4) sides shut around the

case.

5. Place on the external

silicone rubber sleeve over the

hard case again.

2. Attach VESA Plate to Dock

1. Located Tablet Case and Insert Device

7.Plug in Power Cord from

Dock Port into Vehicle

Produkt Specifikationer

Mærke:	CTA Digital
Kategori:	Ikke kategoriseret
Model:	PAD-AUTICC
Bredde:	50 mm
Dybde:	101 mm
Højde:	533 mm
Vægt:	1528.6 g
Produktfarve:	Sort
Materiale:	Aluminium
Normal brug:	Bil
Beslagtype til enhed:	Magnetisk montering