DeWalt DWE74912 Manual

DeWalt savemaskine DWE74912

Læs gratis den danske manual til DeWalt DWE74912 (2 sider) i kategorien savemaskine. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 17 anmeldelser. Har du et spørgsmål om DeWalt DWE74912, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

DWE74912 Heavy-Duty Table Saw Stand

WARNING: For your own safety, read the table saw

instruction manual before using any accessory. Failure to heed

these warnings may result in personal injury and serious damage to

the table saw and the accessory. When servicing this tool, use only

identical replacement parts.

• This table saw stand is designed only for use with the DWE7490,

DWE7491, and DWE7499 table saws. Do not use this stand with

any other tool.

• DO NOT mount the table saw to the stand in any other

orientation.

• Position all of the rubber stand feet in the same orientation or

unstable footing may occur.

• Do not climb on or sit on saw stand.

• Do not use saw stand on inclined, uneven or unstable surfaces.

• Do not use saw stand if it is damaged or bent.

• The back legs of the saw stand are slightly longer than the

front legs to provide additional support. Use the saw stand and

operate the table saw from the front side only.

• Maximum load: 150 lbs. (68.1 kg.)

SAVE THESE INSTRUCTIONS

ASSEMBLY

• Assemble as shown in Figure 1; all leg pieces are equal lengths.

TO OPEN TABLE SAW STAND

1. Unfold the saw stand until it is fully opened. Place it upright, as

shown in Figure 2.

2. Place the table saw on the stand by sliding the front tube (A) of

the saw into the lip (B) on the front of the stand (Fig. 3).

3. Lower the rear feet of the saw onto the rear rail (C) at the back of

the stand as shown in Figure 3.

4. Secure the front and rear of the saw with the bolts provided

(Fig. 4). Install bolts FROM THE BOTTOM. Install washers and

nuts on the top. Tighten securely. Be sure the saw does not rock

or wobble in place.

TO CLOSE THE STAND

1. Remove the bolts that secure saw to the stand.

2. Tilt the rear of the saw up allowing the rear feet to clear the lip on

the back of the stand.

3. Pull the saw forward and up allowing the front tube to slide out of

the lip on the stand.

4. After stowing the saw, pick the stand up by both rails and close

it by squeezing the top rails toward each other.

FIG. 1

The following are trademarks for one or more DeWALT power tools: the yellow and black color scheme; the “D” shaped air intake grill; the array of pyramids on