Digital Watchdog DWC-D1373D Manual

Digital Watchdog Overvågningskamera DWC-D1373D

Læs gratis den danske manual til Digital Watchdog DWC-D1373D (5 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om Digital Watchdog DWC-D1373D, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

■

■■ DIMENSIONS

INSTRUCTION MANUAL

Before installing and using the camera, please read this manual carefully.

Be sure to keep it handy for future reference.

■Do not open or modify

Do not open the cabinet exit during maintenance and

installation, as it may be dangerous and cause damages.

■Do not put objects inside the unit

Make sure that no metal objects or flammable substances get inside

the camera. It could cause fire, short-circuits or damages.

■Be careful when handling the unit

To prevent damage, do not drop the camera or subject

it to strong shock or vibration.

■Install away from electric or magnetic fields

■Protect from humidity and dust

■Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen or boiler

room, as the temperature may raise to high levels.

■Cleaning

Dirt can be removed from the cabinet only by wiping it

with a soft cloth moistened with a soft detergent solution.

■Mounting Surface

The mounting surface material must be strong enough to secure the

camera.

5436 W Crenshaw Street

Tampa, FL 33634

www.digital-watchdog.com

Technical Support: 1-866-446-3595 / 813-888-9555

PRECAUTIONS

D1373D

About this manual

Before installing and using the camera, please read this manual carefully.

Be sure to keep it handy for future reference.

TROUBLESHOOTING

Before sending the camera out for repair, check the items below. If the

problem persists after checking these items, contact your service

center.

■

■■ If no image appears.

Is the coaxial cable attached securely?

Are the power and voltage normal?

Has the iris of the lens inside the camera been

adjusted correctly (with the level volume) ?

Is there adequate illumination?

■

■■ If the image is unclear

Is the lens in focus?

Is the lens dirty?

Dirt of fingerprints on the lens can adversely affect the

images. Gently wipe any dirt or fingerprints off the lens

with a soft cloth or lens cleaning paper and cleaning

fluid (commercially available).

Is the monitor adjusted correctly?

WARNING:

TO PREVENT THE RISK OF FIRE OR ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

■Do not open or modify

Do not open the cabinet exit during maintenance and

installation, as it may be dangerous and cause damages.

■Do not put objects inside the unit

Make sure that no metal objects or flammable substances get inside

the camera. It could cause fire, short-circuits or damages.

■Be careful when handling the unit

To prevent damage, do not drop the camera or subject

it to strong shock or vibration.

■Install away from electric or magnetic fields

■Protect from humidity and dust

■Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen or boiler

room, as the temperature may raise to high levels.

■Cleaning

Dirt can be removed from the cabinet only by wiping it

with a soft cloth moistened with a soft detergent solution.

■Mounting Surface

The mounting surface material must be strong enough to secure the

camera.

WARRANTY INFORMATION

Digital Watchdog (referred to as “the Warrantor”) warrants the

Camera Series against defects in materials or workmanship as follows:

LABOR: For the initial five (5) years from the date of original purchase,

if the camera is determined to be defective, the Warrantor will repair or

replace the unit, with

new or refurbished product at its option, at no charge.

PARTS: In addition, the Warrantor will supply replacement parts for

the initial five (5) years. To obtain warranty or out of warranty service,

please contact a Technical Support Representative at 1-866-446-3595

Monday through Friday from 9:00 AM to 5:00 PM Eastern.

A purchase receipt or other proof of the date of the original purchase is

required before warranty service is rendered. This warranty only

covers failures due to defects in materials and workmanship which

arise during normal use. This warranty does not cover damage which

occurs in shipment or failures which are caused by products not

supplied by the Warrantor or failures which result from accident,

misuse, abuse, neglect, mishandling, misapplication, alteration,

modification, faulty installation, set-up adjustments, improper antenna,

inadequate signal pickup, maladjustment of consumer controls,

improper operation, power line surge, improper voltage supply,

lightning damage, rental use of the product or service by anyone other

than an authorized repair facility or damage that is attributable to acts

of God.

5436 W Crenshaw Street

Tampa, FL 33634

www.digital-watchdog.com

Technical Support: 1-866-446-3595 / 813-888-9555

This warranty gives you specific legal rights and you may also have

other rights that vary from state to state.

If the problem is not handled to your satisfaction, then write to the

Address above.

Service calls which do not involve defective materials or workmanship

as determined by the Warrantor, in its sole discretion, are not covered.

Costs of such service calls are the responsibility of the purchaser.

LIMITS AND EXCLUSIONS

There are no express warranties except as listed above. The Warrantor

will not be liable for incidental or consequential damages (including,

without limitation, damage to recording media) resulting from the use of

these products, or arising out of any breach of the warranty. All express

and implied warranties, including the warranties of merchantability and

fitness for particular purpose, are limited to the applicable warranty

period set forth above.

Some states do not allow the exclusion or limitation of incidental or

consequential damages, or limitations on how long an implied warranty

lasts, so the above exclusions or limitations may not apply to you.

PRECAUTIONS

D1373D

About this manual

■

■■ LENS ADJUSTMENTS

■

■■ CAMERA SETTING FOR CONTROL BOARD

CONNECTIONS AND CAMERA SETTINGS

1. Adjust the panning(360˚) and tilt(60˚) position.

2. Adjust the Joy stick to control TELE & WIDE.

Focus is automatically matched without any adjustment

SW2

SW1 SW3

CON1

CONNECTIONS AND CAMERA SETTINGS

1. Adjust the panning(360˚) and tilt(60˚) position.

2. Adjust the Joy stick to control TELE & WIDE.

Focus is automatically matched without any adjustment

FUNCTIONAL OF CONTROL BOARD

[1]DC IRIS LEVEL control (VR1)[NOT using]

[2]Functional control of O.S.D(On Screen Display)(SW1)

The function of SW1 joystick are camera zoom in/out and OSD control.

a) Press the SW3 button for 2 seconds until red LED around the camera lens flickers 3 times.

And the function of SW1 is switched to control Omni Focus Zoom IN/OUT.

b) Press the SW3 button for 2 seconds until red LED around the camera lens flickers 3 times.

And the function of SW1 is switched to control OSD menu.

[3]. SW2

The camera ID number is set by pushing SW2 switches.

(※1,2,4,8(BCD code) means ID number, and ID contains 10 numbers from 0 to 9.) for the IR remote only

[4]. CON2

Video Test output connector

SW2

SW1 SW3

CON1

VR1

N-VR

CONNECTIONS AND CAMERA SETTINGS

1. Adjust the panning(360˚) and tilt(60˚) position.

2. Adjust the Joy stick to control TELE & WIDE.

Focus is automatically matched without any adjustment

FUNCTIONAL OF CONTROL BOARD

[1]DC IRIS LEVEL control (VR1)[NOT using]

[2]Functional control of O.S.D(On Screen Display)(SW1)

The function of SW1 joystick are camera zoom in/out and OSD control.

a) Press the SW3 button for 2 seconds until red LED around the camera lens flickers 3 times.

And the function of SW1 is switched to control Omni Focus Zoom IN/OUT.

b) Press the SW3 button for 2 seconds until red LED around the camera lens flickers 3 times.

And the function of SW1 is switched to control OSD menu.

[3]. SW2

The camera ID number is set by pushing SW2 switches.

(※1,2,4,8(BCD code) means ID number, and ID contains 10 numbers from 0 to 9.) for the IR remote only

[4]. CON2

Video Test output connector

SW2

SW1 SW3

CON1

VR1

N-VR

Produkt Specifikationer

Mærke:	Digital Watchdog
Kategori:	Overvågningskamera
Model:	DWC-D1373D

Har du brug for hjælp?

Hvis du har brug for hjælp til Digital Watchdog DWC-D1373D stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Overvågningskamera Digital Watchdog Manualer

Digital Watchdog MegaPix DWC-MB95WI Manual

1 December 2024

Digital Watchdog MEGApix DWC-MV72DI Manual

1 December 2024

Digital Watchdog MEGApix DWC-MPF2WI Manual

1 December 2024

Digital Watchdog MEGApix DWC-MF2WI Manual

1 December 2024

Digital Watchdog Star-Light DWC-D3263TIR Manual

1 December 2024

Digital Watchdog DWC-B6263WTIR 2.1MP Outdoor Universal HD Analog Bullet Camera wit Manual

1 December 2024

Digital Watchdog MEGApix CaaS DWC-MB44WIAWC Manual

30 November 2024

Digital Watchdog MegaPix DWC-MVA2WiAT Manual

30 November 2024

Digital Watchdog MegaPix CaaS DWC-MB44WI650C6 Manual

30 November 2024

Digital Watchdog MegaPix DWC-MV72WI4A Manual

30 November 2024

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

1 August 2025

31 Juli 2025

31 Juli 2025

31 Juli 2025

FLIR ioi HD CB-5222 Manual

30 Juli 2025

Eufy Cam S3 Pro Manual

30 Juli 2025

Telycam Vision+ 4KN 30X Manual

30 Juli 2025

Marshall Electronics CV630-BI Manual

30 Juli 2025

Telycam Vision+ SE Manual

30 Juli 2025

FLIR Ariel CC-3405 Manual

29 Juli 2025