Digital Watchdog Omni-Focus DWC-B2373D Manual

Digital Watchdog Overvågningskamera Omni-Focus DWC-B2373D

Læs gratis den danske manual til Digital Watchdog Omni-Focus DWC-B2373D (3 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Digital Watchdog Omni-Focus DWC-B2373D, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

B2373D

About manual

INSTRUCTION MANUAL

■Do not open or modify

Do not open the case except during maintenance and

installation, as it may be dangerous and cause damages.

■Do not put objects inside the unit

Make sure that no metal objects or flammable substances

get inside the camera. It could cause fire, short-circuits or

damages.

■Be careful when handling the unit

To prevent damage, do not drop the camera or subject it to

strong shock or vibration.

■Install away from electric or magnetic fields

■Protect from humidity and dust

■Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen

or boiler room, as the temperature may rise to high levels.

■Cleaning

Dirt can be removed from the case only by wiping it with

a soft cloth moistened with a soft detergent solution.

■Mounting Surface

The mounting surface material must be strong enough to

support the camera.

Before installing and using the camera, please read this

manual carefully.

Be sure to keep it handy for future reference.

DIMENSION (mm)

5436 W Crenshaw Street

Tampa, FL 33634

www.digital-watchdog.com

Technical Support: 1-866-446-3595 / 813-888-9555

WARRANTY INFORMATION

PRECAUTIONS

Digital Watchdog (referred to as “the Warrantor”) warrants

the Camera Series against defects in materials or

workmanship as follows:

LABOR: For the initial five (5) years from the date of original

purchase, if the camera is determined to be defective, the

Warrantor will repair or replace the unit, with

new or refurbished product at its option, at no charge.

PARTS: In addition, the Warrantor will supply replacement

parts for the initial five (5) years. To obtain warranty or out

of warranty service, please contact a Technical Support

Representative at 1-866-446-3595 Monday through Friday

from 9:00 AM to 5:00 PM Eastern.

A purchase receipt or other proof of the date of the original

purchase is required before warranty service is rendered.

This warranty only covers failures due to defects in

materials and workmanship which arise during normal use.

This warranty does not cover damage which occurs in

shipment or failures which are caused by products not

supplied by the Warrantor or failures which result from

accident, misuse, abuse, neglect, mishandling,

misapplication, alteration, modification, faulty installation,

set-up adjustments, improper antenna, inadequate signal

pickup, maladjustment of consumer controls, improper

operation, power line surge, improper voltage supply,

lightning damage, rental use of the product or service by

anyone other than an authorized repair facility or damage

that is attributable to acts of God.

LIMITS AND EXCLUSIONS

There are no express warranties except as listed above.

The Warrantor will not be liable for incidental or

consequential damages (including, without limitation,

damage to recording media) resulting from the use of

these products, or arising out of any breach of the

warranty. All express and implied warranties, including

the warranties of merchantability and fitness for

particular purpose, are limited to the applicable warranty

period set forth above.

Some states do not allow the exclusion or limitation of

incidental or consequential damages, or limitations on

how long an implied warranty lasts, so the above

exclusions or limitations may not apply to you.

This warranty gives you specific legal rights and you

may also have other rights that vary from state to state.

If the problem is not handled to your satisfaction, then

write to the Address above.

Service calls which do not involve defective materials or

workmanship as determined by the Warrantor, in its

sole discretion, are not covered. Costs of such service

calls are the responsibility of the purchaser.

Before sending the camera out for repair, check the

items below. If the problem persists after checking

these items, contact your service center.

■

■■ If no image appears.

Is the coaxial cable attached securely?

Are the power and voltage normal?

Has the iris of the lens inside the camera been

adjusted correctly (with the level volume) ?

Is there adequate illumination?

■

■■ If the image is unclear

Is the lens in focus?

Is the lens dirty?

Dirt of fingerprints on the lens can adversely

affect the images.

Gently wipe any dirt or fingerprints off the lens

with a soft cloth or lens cleaning paper and cleaning

fluid (commercially available).

Is the monitor adjusted correctly?

WARNING:

TO PREVENT THE RISK OF FIRE OR ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

TROUBLESHOOTING

WHITE BAL. ATW, MANUAL, AWC ATW: 1,800 ~10,500 ˚K

BACKLIGHT OFF, LOW, MIDDLE, HIGH Backlight compensation

AGC NORMAL, HIGH,OFF

SPECIAL Refer to the bottom

MIRROR OFF, ON

PRIVACY OFF, ON

SHARPNESS OFF, ON(=8)

RESET

OFF, ON

CAMER ID

DAY NIGHT AUTO, B/W, EXTERN, COLOR

SYNC INT, LL

SENS-UP AUTO(=X6), OFF

EXIT

SHUTTER ESC, MANUAL, FLK, OFF

DNR MIDDLE, HIGH, OFF, LOW

LENS



CAMERA SETTINGS

CONTROL BOARD

CONNECTION

※

※※ ATTENTION

1. Do not rotate ①more than 360˚.

2. Do not twist ②many times unnecessarily.

SW2

SW3

SW1

CON2

SETUP FUNTION SUMMARY

when using BUILT-IN lens,

the type of the lens is able to fix

MANUAL: 1/60(50) ~

1/120,000sec, x2~ x128

WHITE BAL. ATW, MANUAL, AWC ATW: 1,800 ~10,500 ˚K

BACKLIGHT OFF, LOW, MIDDLE, HIGH Backlight compensation

AGC NORMAL, HIGH,OFF the Brightness can be adjusted(1 ~ 70)

when AGC is t urned off,

DNR does not operate.

when AGC is t urned off,

SENS-UP does not operate.

SPECIAL Refer to the bottom

Saved all the setting menu,

then exits.

uppercase or lowercase, OFF maximum length for the name

/numeral 0~9/-, null display is limited 15letters.

AUTO :

dayatime → color mode ,

night-time

→ B/W mode

B/W : Always B/W mode

COLOR: Always color mode

EXTERN

CDS

EXTERNAL

SIGNAL

INPUT

LL mode: you can adjust

desired phase from 0˚

~ 359˚,

auto detection

MATION ON mode: AREA(4 programmable

DETECTION zone /SIZE), the word

MOTION DETECTED" appear on the

screen when movement is detected

ON mode:AREA(4 programmable

zone) /SIZE/TONE

MIRROR OFF, ON set a horizontal image inversion.

the available range

of level is 0 ~ 31.

returns to the level which was set

by the manufacturer for shipment.

save the SPECIAL MENU and then

returns to the SETUP MENU

PRIVACY OFF, ON

SHARPNESS OFF, ON(=8)

RESET

OFF, ON

RERURN

CAMER ID

DAY NIGHT AUTO, B/W, EXTERN, COLOR

SYNC INT, LL

SENS-UP AUTO(=X6), OFF

EXIT

SHUTTER ESC, MANUAL, FLK, OFF

DNR MIDDLE, HIGH, OFF, LOW

LENS



KEYBUTTON

OSDBUTTON

ZoomFocusControl Buttons

BUTTON

IDButtons

BUTTON

CAUTION :

Check for polarity when using a DC 12V / AC 24V.

CAMERA SETING ANGLE

FUNCTIONAL OF CONTROL BOARD

1. SW1 Joystick

The function of SW1 joystick are camera zoom in/out and OSD control.

a) Press SW3 button for 2 seconds until red LED light around the camera

lens flickers 3 times. And the function of SW1 is switched to control Omni

Focus Zoom ON/OFF.

b) Press SW3 button for 2 seconds until red LED light around the camera

lens flickers 3 times. And the function of SW1 is switched to control OSD

menu.

2. SW2

The camera ID number is set by pushing SW2 switches.

(※1,2,4,8(BCD code) means ID number, and ID contains 10 numbers from

0 to 9.) for the IR remote only

3. CON2

Video Test output connector

Omni‐FocusRemoteControlInstructions

1. ChecktheDipswitch(SW4)forcameraID(Default is 0)

2. Pointthe theremotecontroltowards camera,thenpress and 

hold[0]untiltheRedLEDlightstartflashing.

3. PressandholdtheKEYbutton,untilLEDturns a solidRED.

4. PressthePlus sign (+)to toZOOMIN,Minussign ‐ ( ) ZOOMOUT

5. Pressthe to the[ENT]button enter setupMenuand press [KEY]

buttonto exit.

Produkt Specifikationer

Mærke:	Digital Watchdog
Kategori:	Overvågningskamera
Model:	Omni-Focus DWC-B2373D

Har du brug for hjælp?

Hvis du har brug for hjælp til Digital Watchdog Omni-Focus DWC-B2373D stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Overvågningskamera Digital Watchdog Manualer

Digital Watchdog MegaPix DWC-MB95WI Manual

1 December 2024

Digital Watchdog MEGApix DWC-MV72DI Manual

1 December 2024

Digital Watchdog MEGApix DWC-MPF2WI Manual

1 December 2024

Digital Watchdog MEGApix DWC-MF2WI Manual

1 December 2024

Digital Watchdog Star-Light DWC-D3263TIR Manual

1 December 2024

Digital Watchdog DWC-B6263WTIR 2.1MP Outdoor Universal HD Analog Bullet Camera wit Manual

1 December 2024

Digital Watchdog MEGApix CaaS DWC-MB44WIAWC Manual

30 November 2024

Digital Watchdog MegaPix DWC-MVA2WiAT Manual

30 November 2024

Digital Watchdog MegaPix CaaS DWC-MB44WI650C6 Manual

30 November 2024

Digital Watchdog MegaPix DWC-MV72WI4A Manual

30 November 2024

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

1 August 2025

31 Juli 2025

31 Juli 2025

31 Juli 2025

FLIR ioi HD CB-5222 Manual

30 Juli 2025

Eufy Cam S3 Pro Manual

30 Juli 2025

Telycam Vision+ 4KN 30X Manual

30 Juli 2025

Marshall Electronics CV630-BI Manual

30 Juli 2025

Telycam Vision+ SE Manual

30 Juli 2025

FLIR Ariel CC-3405 Manual

29 Juli 2025