Evolveo Armor 2x1 Manual

Evolveo Ikke kategoriseret Armor 2x1

Læs gratis den danske manual til Evolveo Armor 2x1 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om Evolveo Armor 2x1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Cannot Power On

Charge the speaker and make sure it has enough power.

Flashing red

• Bluetooth version: V4.2

• Bluetooth profile:

A2DPV1.2,AVRCPV1.4,HPV1.6,HSPV1.2

• Wireless distance:10 meters

• Max Output power: 2*15W

• Driver Unit: 2 x φ66mm (4Ω, 2x15W)

• Frequency response: 80Hz-16kHz

• Signal-to-noise ratio: >70dB

• 0 Battery: Lithium-ion (3.6V/2 00mAh*2pcs)

• Y-Micro USB Charging Cable DC input voltage/current:

• Playtime: 6-10 hours (varies by volume level and music

files)

• Charging time: 2.5 hours (5V/2A)

• Dimensions: 116 x 90 x 86 mm /4.6 x 3.5 x 3.4in

• Weight: 650g/ 22.9 oz

Press and hold for 2 seconds on one of the speaker until

indicator fast flashing blue.

Connect via AUX-IN

Specifications

TWS Disconnection

Reset

Overview Buttons & Indicators

Charge the Speaker

Bluetooth Pairing

Bluetooth Disconnection

TWS connection

Controls

2 x Speaker

1 x Leather Strap

1 x Cable

1 x AUX Cable (Ф3.5mm)

1 x User Manual

What’s in the Box

Safety Precautions

Red light off

Steady red

Fully charged

Charging

Low battery( 10%)<

Troubleshooting

Cannot Connect With Device

No Sound

Poor Sound Quality

Please check the following:

• The Bluetooth device supports A2DP profile

• The Speaker is within 10m from the device.

• The Speaker is in pairing mode, the LED indicator flashing

blue and red.

• Make sure the volume is at audible level on both your

device and speaker.

• Make sure your device is successfully paired with the

speaker, the indicator turn steady blue.

Move the device closer to the Speaker or remove any

obstacle between them.

1. Power ON your Speaker.

2. Search and select “ ” from your mobile ARMOR 2x1

device bluetooth setting list.

3. Indicator turns steady blue once connected.

Note:

•Make sure that the speaker is within 10 meters from your

mobile device.

•When powered on, the speaker will automatically

connect to the last connected device if available. If not

speaker will enter pairing mode. (The speaker can

memorize maximum of 8 paired devices ).

• Speaker will automatically power off if without device

paired in 10 minutes.

1.Power on the speaker.

2.Using the AUX Cable(3.5mm) to connect your

external device to AUX-in port on speaker.

3.It will automatically turn to AUX-in mode and the

indicator turns steady green.

Note:

• Under AUX-IN mode, skip songs and

speakerphone function are not available.

• o return to Bluetooth mode, remove the AUX T

cable from your . ฀$฀5฀0฀2฀5฀฀฀฀฀[฀฀

Power ON/ OFF

• Press until the tone comes up and indicator light on.

• Press until the tone comes up and indicator light off.

Mic LED

Bluetooth Pairing LED indicator

TWS

7 8

• Avoid dropping.

• Do not disassemble.

• Do not submerge in water.over 30 minutes

• Avoid extreme temperatures.

• Use original or certified cables.

• Do not use any corrosive cleaner/oil to clean.

• Do not use the device outdoors during thunderstorms.

DC5V

Note:

• Fully charge at first use

• Speaker will power off automatically when the battery

lower than 3%.

Press and hold for 1-2 seconds until Indicator flashing

fast blue.

Press Play / Pause

Volume up / down

Next / Previous track

Switch Bluetooth mode /

Aux-in mode

Answer/End call

Reject call

Put current call on hold and

answer incoming call

Redial last-called number

Press

Press and hold for 1 second

Press

Press and hold for 1 second

Press

Press and hold for 1 second

>1s

If this speaker has any problem, you can try to disconnect

the charging cable, place a small pin(Φ<3mm) into the

reset key “ ” and hold it for 2 seconds until the indicator

off to reset the speaker.

> >2s 2s

1.Place two speakers near each other, the distance

should not be over 5-7 meters.

2.Power on the two speakers, Press and hold the for 2

seconds on one speaker as MASTER speaker (playback

left channel ), the indicator fast flashing blue and green,

then two speaker will pairing each other automatically

(The other speaker will be as SLAVE speaker and

playback right channel)

3.The MASTER speaker indicator slow flashing blue once

paired.

661682

材： 版，黑印刷 80g ,

Produkt Specifikationer

Mærke:	Evolveo
Kategori:	Ikke kategoriseret
Model:	Armor 2x1
Kode for international beskyttelse (IP):	IPX7
Bredde:	116 mm
Dybde:	90 mm
Højde:	86 mm
Vægt:	650 g
Produktfarve:	Sort
Batterispænding:	3.6 V
Batterikapacitet:	2000 mAh
Produkttype:	Bærbar stereohøjttaler
Kompatible hukommelseskort:	MicroSD (TransFlash)
Wi-Fi:	Ingen
Bluetooth:	Ja
Antal højttalere:	2
Udgangseffekt (RMS):	30 W
Kabler inkluderet:	AUX, Micro-USB
Bluetooth-version:	4.2
Bluetooth-profiler:	A2DP, AVRCP, HSP
Anbefalet brug:	Universel
Forbindelsesteknologi:	Kabel & trådløs
Indbygget kortlæser:	Ja
Batterilevetid (maks.):	20 t
3,5 mm stik:	Ja
USB-tilslutning:	Ja
Batteritype:	Indbygget batteri
Opladningstid for batteri:	2.5 t
Indbygget mikrofon:	Ja
USB-stik type:	Micro-USB
Produktdesign:	Terning
Bluetooth-område:	15 m
Håndfri:	Ja