Fluke 2AC Manual

Fluke Ikke kategoriseret 2AC

Læs gratis den danske manual til Fluke 2AC (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Fluke 2AC, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

2AC

VoltAlert

Instruction Sheet

Read First: Safety Information

WX Warning

To avoid possible electric shock or personal injury:

● If the Tester is used in a manner not specied by the manufacturer,

protection provided by the Tester may be affected.

●

Test on a known live source within the rated ac voltage range of the

product, both before and after use to ensure unit is in good working

condition.

● When using the Tester, if tip does not glow, voltage could still be

present. The Tester indicates active voltage in the presence of

electrostatic elds of sufcient strength generated from the source

(MAINS) voltage. If the eld strength is low, the Tester may not provide

indication of live voltages. Lack of an indication occurs if the Tester is

unable to sense the presence of voltage which may be inuenced by

several factors including, but not limited to:

●Shielded wire/cables

●Thickness and type of insulation

●Distance from the voltage source

●Fully-isolated users that prevent an effective ground

●Receptacles in recessed sockets/ differences in socket design

●

Condition of the Tester and Batteries

●

Do not use if the Tester appears damaged or if the Tester is not

operating properly. Specically examine the probe tip for cracks or

breakage before use. If in doubt, have the Tester serviced.

●

Do not apply more than the rated voltage as marked on the Tester.

● Use caution with voltages above 30 V ac as a shock hazard may exist.

●Comply with local and national safety requirements.

●Use proper protective equipment as required by local or national

authorities.

Table 1. Symbols

TDouble Insulated.

XHazardous Voltage. Risk of electric shock.

WRisk of danger. Important information. See Instruction Sheet.

Conforms to relevant Canadian and US Standards.

Conforms to relevant European Union directives.

Conforms to relevant Australian standards.

Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website

for recycling information.

CAT IV Equipment is designed to protect against transients from the primary supply level.

(i.e. - electricity meter or overhead /underground utility service).

August 2010 Rev. 1, 7/11

reserved. Printed in China.

FOR USE BY COMPETENT

PERSONS

Anyone using this instrument should be

knowledgeable and trained about the risks

involved with measuring voltage, especially

in an industrial setting, and the importance of

taking safety precautions and of testing the

instrument before and after using it to ensure

that it is in good working condition.

Safety Compliance: Meets IEC 61010-1:2001, UL 61010-1 (2nd ed.), CAN/

CSA-C22.2 No. 61010-1-04, and ISA-82.02.01

EMC Compliance: Meets IEC 61326-1:2006

Operating: North America: 90 V ac to 1000 V ac

Europe: 200 V ac to 1000 V ac

Temperature: Operating: -10 to 50 °C Storage: -10 to 50 °C

Humidity: 0 % to 95 % (0 to 30 °C), 0 % to 75 % (30 to 40 °C), 0 % to 45 % (40

to 55 °C)

Altitude: 2000 m (CAT IV 1000 V)

Pollution Degree: 2

Cleaning

Clean with damp cloth.

Operating Instructions

The product is always on and ready to use, subject to battery and Tester

condition.

Checking Battery and Tester

Push the Battery Check Button. If the tip glows, the batteries are good and the

Tester is operational. If the tip does not glow, replace batteries with two AAA

(LR3) batteries. If the Tester still does not function, have it serviced.

Checking for AC Voltage

Placing the tip of the Tester near an ac voltage (within the specied range of the

Tester) produces a steady glow at the tip.

Contacting Fluke

●

Technical Support USA: 1-800-44-FLUKE (1-800-443-5853)

●Calibration/Repair USA: 1-888-99-FLUKE (1-888-993-5853)

●Canada: 1-800-36-FLUKE (1-800-363-5853)

●Anywhere in the world: +1-425-446-5500

Or, visit Fluke’s website at www.uke.com.

To register your product, visit http://register.uke.com.

To view, print, or download the latest manual supplement, visit

http://us.uke.com/usen/support/manuals.

LIMITED WARRANTY AND LIMITATION OF LIABILITY

This Fluke product will be free from defects in material and workmanship for two

years from the date of purchase. This warranty does not cover fuses, disposable

batteries, or damage from accident, neglect, misuse, alteration, contamination,

or abnormal conditions of operation or handling. Resellers are not authorized

to extend any other warranty on Fluke’s behalf. To obtain service during the

warranty period, contact your nearest Fluke authorized service center to obtain

return authorization information, then send the product to that Service Center

with a description of the problem.

THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER WARRANTIES,

SUCH AS FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSED OR

IMPLIED. FLUKE IS NOT LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL

OR CONSEQUENTIAL DAMAGES OR LOSSES, ARISING FROM ANY CAUSE

OR THEORY. Since some states or countries do not allow the exclusion or

limitation of an implied warranty or of incidental or consequential damages, this

limitation of liability may not apply to you.

Fluke Corporation

P.O. Box 9090

Everett, WA 98206-9090 U.S.A.

Fluke Europe B.V.

P.O. Box 1186

5602 BD Eindhoven

The Netherlands

11/99

Produkt Specifikationer

Mærke:	Fluke
Kategori:	Ikke kategoriseret
Model:	2AC
Produktfarve:	Black,White,Yellow
Opbevaringstemperatur (T-T):	-10 - 50 °C
Driftstemperatur (T-T):	-10 - 50 °C
Certificering:	IEC 61010-1:2001, UL 61010-1 (2nd ed.), CAN/CSA-C22.2 No. 61010-1-04, and ISA-82.02.01
Nominel spænding:	1000 V
Målekategori understøttes:	CAT IV
Maksimal driftshøjde:	2000 m