Fluke FTP17XXPQ Manual

Fluke Ikke kategoriseret FTP17XXPQ

Læs gratis den danske manual til Fluke FTP17XXPQ (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 70 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 35.5 anmeldelser. Har du et spørgsmål om Fluke FTP17XXPQ, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

FTP17XXPQ

Fused Test Probe Set

3-Phase PQ, AC285, R/B

Instructions

Introduction

The FTP17XXPQ (the Product) is a set of four FTP-1 SureGrip Fused

Test Probes with adapters and AC285 alligator clips. These test probes

are for use with standard test leads that have 4 mm safety plugs. The

Product has a replaceable 1000 V, 11 A, 20 kA IR fuse for additional

measurement protection.

How to Contact Fluke

Fluke Corporation operates worldwide. For local contact information, go

to our website: www.uke.com

To register your product, view, print, or download the latest manual or

manual supplement, go to our website.

Fluke Corporation

P.O. Box 9090

Everett, WA 98206-9090

+1-425-446-5500

uke-info@uke.com

PN 4957684

January 2018 Rev. 1, 4/21

Product specications are subject to change without notice.

Symbols

The table below is a list of symbols used on the Product and in this

document.

Symbol Description

WARNING - RISK OF DANGER. Consult user documentation.

WARNING. HAZARDOUS VOLTAGE. Risk of electric shock.

Consult user documentation.

Double Insulated

Fuse



Measurement Category II is applicable to test and measuring circuits

connected directly to utilization points (socket outlets and similar

points) of the low-voltage MAINS installation.

Measurement Category III is applicable to test and measuring circuits

connected to the distribution part of the building’s low-voltage MAINS

installation.

Measurement Category IV is applicable to test and measuring

circuits connected at the source of the building’s low-voltage MAINS

installation.

Conforms to European Union directives.



This product complies with the WEEE Directive marking

requirements. The a󰀩xed label indicates that you must not discard

this electrical/electronic product in domestic household waste.

Product Category: With reference to the equipment types in the

WEEE Directive Annex I, this product is classed as category 9

“Monitoring and Control Instrumentation” product. Do not dispose of

this product as unsorted municipal waste.

LIMITED WARRANTY AND LIMITATION OF LIABILITY

This Fluke product will be free from defects in material and workmanship for one

year from the date of purchase. This warranty does not cover fuses, disposable

batteries, or damage from accident, neglect, misuse, alteration, contamination,

or abnormal conditions of operation or handling. Resellers are not authorized to

extend any other warranty on Fluke’s behalf. To obtain service during the warranty

period, contact your nearest Fluke authorized service center to obtain return

authorization information, then send the product to that Service Center with a

description of the problem.

THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER WARRANTIES, SUCH

AS FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSED OR IMPLIED.

FLUKE IS NOT LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR

CONSEQUENTIAL DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR

THEORY. Since some states or countries do not allow the exclusion or limitation

of an implied warranty or of incidental or consequential damages, this limitation of

liability may not apply to you.

Fluke Corporation

P.O. Box 9090

Everett, WA 98206-9090

U.S.A.

Fluke Europe B.V

P.O. Box 1186

5602 BD Eindhoven

The Netherlands

11/99

Safety Information

A Warning identies conditions and procedures that are dangerous to

the user. A Caution identies conditions and procedures that can cause

dameage to the Product or the equipment under test.

 Warning

To prevent electrical shock, re, or personal injury:

• Read all safety information before you use the Product.

• Do not alter the Product and use only as specied, or the

protection supplied by the Product can be compromised.

• Comply with local and national safety codes. Use personal

protective equipment (approved rubber gloves, face protection,

and ame-resistant clothes) to prevent shock and arc blast injury

where hazardous live conductors are exposed.

• Do not exceed the Measurement Category (CAT) rating of the

lowest rated individual component of a Product, probe, or

accessory.

• Measure a known voltage rst to make sure that the Product

operates correctly.

• Hold the Product behind the tactile barrier when the 4 mm adapter

A is not attached.

• Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc.

• Do not use the Product around explosive gas, vapor, or in damp or

wet environments.

• Do not use the Product if it is altered or damaged.

• Do not use in CAT III or CAT IV environments without the adapters

installed. The adapters decreases the exposed probe metal to

<4 mm. This decreases the possibility of arc ash from short

circuits.

• Do not make connections on hazardous live conductors in damp

or wet environments.

• Limit operation to the specied measurement category, voltage, or

amperage ratings.

• Do not use a shrouded banana jack

accessory such as an alligator clip

with an unshrouded 4 mm banana

probe tip terminal in a hazardous

electrical installation. Due to the lack

of a shroud, the probe tip connector

does not provide suitable insulation

to accessible parts with this type of

assembly.

Unpack

The Product includes these items:

• FTP-1 SureGrip Fused Test Probes (1 black for connecting to neutral

voltage, 3 red for connecting to phase voltages)

• AC285 Alligator Clips (1 black, 3 red)

• Adapters that securely attach the Fluke AC285 alligator clips to the

Fused Test Probes (4)

• FTP17XXPQ Instructions

At delivery, make sure that the shipment is complete and all items are

undamaged. Contact your supplier if you see any damage.

Operation

To use:

1. Thread the adapter onto the probe . A B

2. Push on the alligator clip AC285 C securely for a rm connection for

CAT III/CAT IV measurements.

Maintenance

Clean the Product with a damp cloth and mild detergent. Do not immerse

in liquid.

Fuse Information

To replace fuse:

1. .Unscrew the handle at the nger guard D

2. Replace the fuse.

 Caution

For safety, replace with Fluke part number 803293 only.

3. Screw handle into place.

When the fuse is blown, a 1 M parallel resistor allows the meter to take Ω

a measurement and indicate if live voltage is present. This measurement

helps to prevent a possible misreading of no voltage present. The input

impedance of the meter has signicant e󰀨ect on the reading error. See

table below.

Voltage Reading with Blown Fuse

Actual

MainsVoltage

Meter Input

Impedance[1]

Meter Reading (V)

with Blown Fuse Error (%)

480 V 417.9 12.910 MΩ

480 V 384.4 19.94 MΩ

480 V 226.3 52.81 MΩ

480 V 1.3 99.73 kΩ

[1] Fluke Power Quality Analyzers typically have input impedances >1 M Ω.

Specications

Input ............................................... 10 A maximum

Measurement protection .............. 1000 V, 11 A, 20 kA IR

Environmental

Operating temperature -20 C to +50 C (-5 F to +120 F) ............... ° ° ° °

Maximum altitude 3000 m .......................

Safety ............................................. IEC 61010-031, Pollultion Degree 2

CAT II 1000 V without adapters installed

CAT III 1000 V, CAT IV 600 V with adapters

installed

3 4

Produkt Specifikationer

Mærke:	Fluke
Kategori:	Ikke kategoriseret
Model:	FTP17XXPQ

Har du brug for hjælp?

Hvis du har brug for hjælp til Fluke FTP17XXPQ stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Fluke Manualer

18 Juni 2025

14 Juni 2025

11 Marts 2025

8 Oktober 2024

8 Oktober 2024

8 Oktober 2024

8 Oktober 2024

7 Oktober 2024

4 Oktober 2024

Fluke CableAnalyzer DSX-8000 Manual

1 Oktober 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Zoom A3 Manual

16 Juli 2025

DS18 SLG-FKP6 Manual

16 Juli 2025

CYP PU-1201-KIT Manual

16 Juli 2025

JUNG 4008 TSM Manual

16 Juli 2025

Emko SMR1P1-00-00-01-00 Manual

16 Juli 2025

DS18 Hydro NXL-X6TP Manual

16 Juli 2025

CYP PUV-1350PL-TXWP Manual

16 Juli 2025

Audio Pro VOL-1 Manual

16 Juli 2025

CYP PUV-2010TXWP Manual

16 Juli 2025

Hillvert HT-VC-400 Manual

16 Juli 2025