Fluke i2000 Flex Manual

Fluke Ikke kategoriseret i2000 Flex

Læs gratis den danske manual til Fluke i2000 Flex (10 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Fluke i2000 Flex, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/10

i3000s/i2000 Flex

AC Current Probe

Instructions

Introduction

The i3000s 24 Flex, i3000s 36 Flex, and i2000 Flex AC Current Probes

(the Probe) are used with oscilloscopes, digital multimeters, recorders

or data loggers. The i3000s probes can be used to measure AC current

up to 3000 A. The i2000 can be used to measure AC current up to

2000 A. The flexible measuring head allows current measurements on

conductors that are hard to reach or inaccessible using typical clamp-

on current probes.

The Probes provide a low-voltage (3 V ac for i3000s models, and 2 V ac

for i2000) output that is proportional to the current being measured.

The Probes provide full-scale direct readings for 30 A, 300 A, and

3000 A when using the i3000s models, and 20 A, 200 A, and 2000 A

when using the i2000.

Safety Information

A Warning identifies hazardous conditions and procedures that are

dangerous to the user. A Caution identifies conditions and procedures

that can cause damage to the Product or the equipment under test.

XW Warning

To prevent possible electrical shock, fire, or personal injury:

Read all safety information before you use the Product.

Carefully read all instructions.

Do not alter the Product and use only as specified, or the

protection supplied by the Product can be compromised.

Do not use the Product if it operates incorrectly.

Do not use the Product if it is altered or damaged.

PN 2560447 (English)

March 2006 Rev. 3, 02/22

subject to change without notice. All Product names are trademarks of their

respective companies.

Have an approved technician repair the Product.

If the Probes are used in a manner not specified in these

operating instructions, protection provided by the Probes

may be impaired.

Use the Probes only if qualified.

Use caution during installation and use of the Probe; high

voltages and currents may be present in circuit under test.

Protect the probe against water and humidity.

Wear protective clothing and gloves as required.

Do not install this product on live conductors. Always de-

energize the circuit under test before installing the flexible

measuring head.

Always inspect the electronics unit, connecting cable, and

flexible measuring head for damage before using the

Probe.

Do not use the Probe if damaged.

Always connect Probe to display device before installing

the flexible measuring head.

Never change batteries while measurement head is

installed on conductor.

Use only the provided original or specified accessories.

Comply with local and national safety codes. Use personal

protective equipment (approved rubber gloves, face

protection, and flame-resistant clothes) to prevent shock

and arc blast injury where hazardous live conductors are

exposed.

CAT III equipment is designed to protect against the

transients in the equipment in fixed equipment

installations, such as distribution panels, feeders and short

branch circuits, and the lighting systems in large buildings.

Produkt Specifikationer

Mærke:	Fluke
Kategori:	Ikke kategoriseret
Model:	i2000 Flex

Har du brug for hjælp?

Hvis du har brug for hjælp til Fluke i2000 Flex stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Fluke Manualer

Fluke 1630-2 FC Manual

25 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

Fluke FibertLert-125 Manual

1 August 2025

Fluke SmartTrace BK120 Manual

20 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Salton MP1206 Manual

31 August 2025

TensCare Sports TENS 2 Manual

31 August 2025

Pardini K58 Manual

31 August 2025

Salton SCG-4 Manual

31 August 2025

Salton JK-1103 Manual

31 August 2025

Salton WC-2040 Manual

31 August 2025

Salton WC-2070 Manual

31 August 2025

Salton SP1963 Manual

31 August 2025

Gram EFI 8060-91 B Manual

31 August 2025

Analog Way Orchestra² Manual

31 August 2025