GE GDP615HBMTS Manual

GE Vaskemaskine GDP615HBMTS

Læs gratis den danske manual til GE GDP615HBMTS (32 sider) i kategorien Vaskemaskine. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om GE GDP615HBMTS, eller vil du spørge andre brugere om produktet?

Side 1/32
READ CAREFULLY
KEEP THESE INSTRUCTIONS
CHECK THE FOLLOWING
Tub trim does not interfere with the door
Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door
All 4 legs of the dishwasher are firmly in contact with the
floor
Drain hose is not pinched between the dishwasher and
adjacent cabinets or walls
Tub trim is fully seated on the tub flange
FOR YOUR SAFETY
Read and observe all WARNINGS and CAUTIONS
shown throughout these instructions.
While performing installations described in this
booklet, gloves, safety glasses or goggles should
be worn.
IMPORTANT – Observe all governing codes and
ordinances.
– Be sure to leave these instructions Note to Installer
for the consumer’s and local inspector’s use.
– Keep these instructions with Note to Consumer
your Owner’s Manual for future reference.
– Installation of this dishwasher requires Skill Level
basic mechanical, electrical and plumbing skills.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliances Warranty.
See warranty information.
. New installations Completion Time – 1 to 3 Hours
require more time than replacement installations.
IMPORTANT The dishwasher MUST be installed to
allow for future removal from the enclosure if service is
required.
Care should be exercised when the appliance is installed
or removed,
to reduce the likelihood of damage to the
power supply cord.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owners Manual for
available custom panel kits.
Your dishwasher is a water heating appliance.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
31-4000103 09-18 GEA
Remove all power leading to the appliance from the
circuit breaker or fuse box before beginning installation.
Failure to do so can result in a risk of electrical shock.
To reduce the risk of electric shock, fire, or injury to persons,
the installer must ensure that the dishwasher is completely
enclosed at the time of installation.
The improper connection of the equipment grounding
conductor can result in a risk of electric shock. Check
with a qualified electrician or service representative
if you are in doubt that the appliance is properly
grounded. If house wiring is not 2-wire with ground, a
ground must be by the installer. When house wiring
is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.
To reduce the risk of electric shock, fire, or injury to persons,
the installer should check to ensure that wires are not pinched
or damaged, the house wiring is attached to the junction box
bracket through a strain relief, and all electrical connections
made at the time of install (wire nuts) are contained inside of
the junction box cover.
WARNING
Retire todos los conductores de corriente del
electrodoméstico de disyuntor o de la caja del fusible
antes de comenzar con la instalación. Si no cumple con
esto, se pod producir el riesgo de descargas eléctricas.
Para reducir el riesgo de descarga eléctrica, incendio
o lesiones a personas, el instalador debe asegurarse
de que el lavaplatos esté completamente cerrado en
el momento de la instalación.
La conexión inadecuada del conductor de conexión a
tierra del equipamiento puede provocar un riesgo de
descarga eléctrica. Consulte a un electricista calificado
o representante de servicio técnico si tiene dudas
sobre la correcta conexión a tierra del aparato. Si el
cableado doméstico no cuenta con un cable de 2 hilos
con conexión a tierra, un instalador debe realizar una
conexión a tierra. Cuando el cableado dostico es de
aluminio, aserese de usar un compuesto antioxidante
y conectores de aluminio a cobre aprobados por UL.
Para reducir el riesgo de descarga ectrica, incendio
o lesiones a personas, el instalador deberá realizar un
control para asegurar que los cables no estén pellizcados
ni dañados, que el cableado del hogar esté conectado a la
ficha de la caja de empalmes a través de un amortiguador
de refuerzo, y que todas las conexiones eléctricas
realizadas en el momento de la instalación (tuercas para
cables) estén dentro de la tapa de la caja de empalmes.
ADVERTENCIA
See your Owner’s Manual for details on how to contact us regarding installation questions
Built-In Dishwashers
Installation
Instructions
PARTS SUPPLIED IN
INSTALLATION PACKAGE:
• Junction box cover and #10 hex-head screw
• Hose clamp
• Drain hose (approximately 58” long)
• Drain hose hanger
2 #8-18 hex head screws to secure brackets to
washer tub frame
• 2 Plug buttons
• Toekick (pre-installed on some models)
• 2 Tub trim pieces (on some models)
• 2 Mounting brackets for wood countertops
or side cabinets
• 2 #8-18 x 5/8” Phillips special head screws,
to secure dishwasher to underside of
countertop or to side cabinets
• Insulation pieces (on some models)
• Literature, samples and/or coupons
TOOLS YOU WILL NEED:
Phillips-head screwdriver
1/4” and 5/16” nutdriver
6” Adjustable wrench
Level
Carpenter’s square
Measuring tape
Safety glasses
Flashlight
Bucket to catch water when flushing the line
15/16” socket (optional for skid removal)
Gloves
Pliers
For New Installations Only:
Tubing cutter
Drill and appropriate bits
Hole saw set
MATERIALS YOU WILL NEED:
3/4” GHT (Garden Hose Thread) 90˚ elbow (including
gasket) - with opposite end sized to fit Hot Water Line
• Thread seal tape
• UL-listed wire nuts (3)
Masking tape
Materials For New Installations Only:
• Air gap for drain hose, if required
• Waste tee for house plumbing, if applicable
Electrical cable or Power Cord Kit WX09X70910 (5 5” long)
or WX09X70911 (7’ 11long) depending on installation.
• Screw-type hose clamps
• Strain relief for electrical connection
• Hand shut-off valve (recommended)
Hot Water Line–3/8” minimum, copper tubing (including
ferrule, compression nut) or GE Appliances Part #
WX28X326, flexible braided hose.
• WD24X10065 drain hose (12’ long), if needed.
Installation Preparation
2
Hole Saw Set
Measuring Tape
Tubing Cutter Drill and Bits
Phillips-Head
Screwdriver
15/16” Socket
1/4” and 5/16
Nutdriver
Bucket
Flashlight
Gloves
Carpenter’s
Square
Safety Glasses
Level
Hose Clamp
#8 Hex-Head
Mounting Bracket
Screws
Junction
Box Cover
#10
Hex-Head
Junction
Box Screw
1/2" long
Mounting
Brackets
#8 Phillips
Special
Head Screws
5/8" long Literature
Insulation
(on some models)
Tub Trim Pieces
(on some models)
Pliers
Hot
Water
Line
Strain
Relief
Optional
12' Drain Hose
WD24X10065
Hose Clamps
Waste Tee Electrical Cable
(or Power Cord,
if applicable)
Wire Nuts (3)
GHT 90°Elbow
Hand
Shut-Off
Valve
Air Gap
Coupler for
optional drain hose
Plug
Buttons
Masking Tape
Toekick
Drain Hose Hanger
Thread
Seal Tape
(if applicable)
6” Adjustable
Wrench
Drain Hose


Produkt Specifikationer

Mærke: GE
Kategori: Vaskemaskine
Model: GDP615HBMTS

Har du brug for hjælp?

Hvis du har brug for hjælp til GE GDP615HBMTS stil et spørgsmål nedenfor, og andre brugere vil svare dig




Vaskemaskine GE Manualer

GE

GE HTW265 Manual

24 Februar 2025
GE

GE WCRE6270 Manual

19 Februar 2025
GE

GE GTW540ASPWS Manual

10 Februar 2025
GE

GE GKSR4110 Manual

17 Januar 2025
GE

GE GFWN1100HWW Manual

13 Januar 2025
GE

GE GJXRP080DWW Manual

9 Januar 2025
GE

GE GJXRP080 Manual

9 Januar 2025
GE

GE GJXR2080 Manual

9 Januar 2025
GE

GE GJSRP080 Manual

9 Januar 2025
GE

GE GJSR2080 Manual

9 Januar 2025

Vaskemaskine Manualer

Nyeste Vaskemaskine Manualer