GE Profile JGP933WEJWW Manual

GE Komfur Profile JGP933WEJWW

Læs gratis den danske manual til GE Profile JGP933WEJWW (32 sider) i kategorien Komfur. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om GE Profile JGP933WEJWW, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/32
TOOLS YOU WILL NEED
1
MATERIALS YOU MAY NEED
229C4053P520-2
31-10537-2 05-03 JR
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•IMPORTANT — Save these
instructions for local inspector’s use.
• IMPORTANT —Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING —This appliance must
be properly grounded.
•IMPORTANT — Leak testing of the
appliance shall be conducted according to
the manufacturer’s instructions.
• Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by a
licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
• A flexible gas connector, when used, must
not exceed 3 feet.
PARTS INCLUDED
2 Hold
Down Brackets
Shut Off ValvePipe Fittings
CSA-Approved Flexible Gas Line
3/8″Min. ID, 1/2″NPT Connection,
3-foot Maximum Length (Massachusetts Only)
Joint Sealant
Saber Saw
Pencil
Safety Glasses
1/8″Drill Bit & Electric
or Hand Drill
Ruler or Straightedge
Foam Tape
2 Screws
Phillips Head
Screwdriver
Pipe Wrench
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca
Installation
30″Sealed Gas Cooktop
Instructions JGP328, JGP932, JGP933
2
Installation Instructions
FOR YOUR SAFETY:
WARNING — If the information
in this manual is not followed exactly, a fire,
explosion or gas leak may result causing
property damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance!
WHAT TO DO IF YOU
SMELL GAS:
• Do not try to light any appliance. Do not
touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
IMPORTANT SAFETY INSTRUCTIONS
This cooktop has been design certified by
UNDERWRITERS LABORATORIES and CSA
International. You’ll find safety precautions in
your Owner’s Manual. Read them carefully.
• Installation of this cooktop must conform
with local codes or in the absence of local
codes with the National Fuel Gas Code,
ANSI Z223.1–Latest edition.
• Be sure your cooktop is installed properly
by a qualified installer or service technician.
• To eliminate reaching over surface burners,
cabinet storage above burner should be
avoided.
• Do not install the unit near an outside door
or where a draft may affect its use.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the
proper voltage and frequency and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or fuse
having amperage as noted on the rating plate.
We recommend you have the electrical wiring
and hookup of your cooktop connected by a
qualified electrician. After installation, have
the electrician show you where your main
cooktop disconnect is located.
Check with your local utilities for electrical
codes which apply in your area. Failure to
wire your cooktop according to governing
codes could result in a hazardous condition.
If there are no codes, your cooktop must be
wired and fused to meet the requirements
of the National Electrical Code, ANSI/NFPA
No. 70—Latest edition. You can get a copy
by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
In Canada your cooktop must be wired
and fused to meet the requirements of the
Canadian Electrical Code.
Be sure the installation of this product
in a mobile home conforms with the
Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280.
If this standard does not apply, you must
follow the standard for Manufactured Home
Installations, ANSI A225.1 and Manufactured
Home Installations, Sites and Communities
and ANSI/NFPA 501A or with local codes.
You can get a copy of the Federal Standard
by Writing:
Office of Mobile Home Standards
HUD Building
451 7th Street, S.W.
Washington, D.C. 24010

Produkt Specifikationer

Mærke: GE
Kategori: Komfur
Model: Profile JGP933WEJWW

Har du brug for hjælp?

Hvis du har brug for hjælp til GE Profile JGP933WEJWW stil et spørgsmål nedenfor, og andre brugere vil svare dig


Komfur GE Manualer

GE

GE PXOVNPRB1VDM Manual

17 Juni 2025
GE

GE JB480SYSS Manual

17 Juni 2025
GE

GE GRF500SVSS Manual

17 Juni 2025
GE

GE JCB840 Manual

17 Januar 2025
GE

GE JGS650SEFSS Manual

24 December 2024
GE

GE PC2S930YPFS Manual

16 August 2024
GE

GE JDP36BWWH Manual

6 August 2024
GE

GE JGBS60DEKCC Manual

26 Juli 2024
GE

GE JB640DFWW Manual

27 Maj 2024
GE

GE JBS61BCAD Manual

26 Maj 2024

Komfur Manualer

Nyeste Komfur Manualer

Essentiel B

Essentiel B EPI 1 Manual

18 Juni 2025
Maytag

Maytag MCIT8030SB Manual

18 Juni 2025
Edilkamin

Edilkamin SENSE 8 Manual

18 Juni 2025
Smeg

Smeg CO60GMAN2 Manual

18 Juni 2025
PKM

PKM GKM 4.2 Manual

18 Juni 2025
Smeg

Smeg PGFU24X2 Manual

18 Juni 2025
Smeg

Smeg PGFU36X2 Manual

18 Juni 2025
De Dietrich

De Dietrich DPV4605HB Manual

18 Juni 2025
Smeg

Smeg SIMU315D Manual

18 Juni 2025
Maytag

Maytag MCIT8036SB Manual

18 Juni 2025