GE Profile JGP963SEJSS Manual

GE Komfur Profile JGP963SEJSS

Læs gratis den danske manual til GE Profile JGP963SEJSS (32 sider) i kategorien Komfur. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om GE Profile JGP963SEJSS, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/32
1
TOOLS YOU WILL NEED
MATERIALS YOU MAY NEED
229C4053P522-2
31-10539-2 05-03 JR
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca
Installation
36″Sealed Gas Cooktop
Instructions JGP628, JGP962, JGP963, ZGU36
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•IMPORTANT — Save these
instructions for local inspector’s use.
•IMPORTANT — Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING —This appliance must
be properly grounded.
• IMPORTANT —Leak testing of the
appliance shall be conducted according to
the manufacturer’s instructions.
• Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by a
licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
• A flexible gas connector, when used, must
not exceed 3 feet.
PARTS INCLUDED
2 Hold
Down Brackets
Shut Off ValvePipe Fittings
CSA-Approved Flexible Gas Line
3/8″Min. ID, 1/2″NPT Connection,
3-foot Maximum Length (Massachusetts Only)
Joint Sealant
Saber Saw
Pencil
Safety Glasses
1/8″Drill Bit & Electric
or Hand Drill
Ruler or Straightedge
Foam Tape
(Glass Top
Models Only)
2 Screws
Phillips Head
Screwdriver
Pipe Wrench
2
Installation Instructions
FOR YOUR SAFETY:
WARNING — If the information
in this manual is not followed exactly, a fire,
explosion or gas leak may result causing
property damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance!
WHAT TO DO IF YOU
SMELL GAS:
• Do not try to light any appliance. Do not
touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
IMPORTANT SAFETY INSTRUCTIONS
This cooktop has been design certified by
UNDERWRITERS LABORATORIES and CSA
International. You’ll find safety precautions in
your Owner’s Manual. Read them carefully.
• Installation of this cooktop must conform
with local codes or, in the absence of local
codes with the National Fuel Gas Code,
ANSI Z223.1–Latest edition.
• Be sure your cooktop is installed properly
by a qualified installer or service technician.
• To eliminate reaching over surface burners,
cabinet storage above burner should be
avoided.
• Do not install the unit near an outside door
or where a draft may affect its use.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the
proper voltage and frequency and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or fuse
having amperage as noted on the rating plate.
We recommend you have the electrical wiring
and hookup of your cooktop connected by a
qualified electrician. After installation, have
the electrician show you where your main
cooktop disconnect is located.
Check with your local utilities for electrical
codes which apply in your area. Failure to
wire your cooktop according to governing
codes could result in a hazardous condition.
If there are no codes, your cooktop must be
wired and fused to meet the requirements of
the National Electrical Code, ANSI/NFPA No.
70—Latest edition. You can get a copy by
writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
In Canada your cooktop must be wired
and fused to meet the requirements of
the Canadian Electrical Code.
Be sure the installation of this product
in a mobile home conforms with the
Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280.
If this standard does not apply, you must
follow the standard for Manufactured Home
Installations, ANSI A225.1 and Manufactured
Home Installations, Sites and Communities
and ANSI/NFPA 501A or with local codes.
You can get a copy of the Federal Standard
by Writing:
Office of Mobile Home Standards
HUD Building
451 7th Street, S.W.
Washington, D.C. 24010

Produkt Specifikationer

Mærke: GE
Kategori: Komfur
Model: Profile JGP963SEJSS

Har du brug for hjælp?

Hvis du har brug for hjælp til GE Profile JGP963SEJSS stil et spørgsmål nedenfor, og andre brugere vil svare dig


Komfur GE Manualer

GE

GE CHP90302TSS Manual

10 September 2025
GE

GE PHS93E Manual

25 August 2025
GE

GE UX12B30PSS Manual

13 August 2025
GE

GE Profile PLS624ETSB Manual

7 August 2025
GE

GE Profile PLU621ETSB Manual

7 August 2025
GE

GE Profile PLU612DTBB Manual

7 August 2025
GE

GE JP3030SWSS Manual

7 August 2025
GE

GE JGB720DEJWW Manual

7 August 2025
GE

GE JP3030TWWW Manual

7 August 2025
GE

GE GGS60LAVFS Manual

7 August 2025

Komfur Manualer

Nyeste Komfur Manualer

Electrolux

Electrolux FEH5LV114 Manual

2 Oktober 2025
Consul

Consul CFO4VBE Manual

2 Oktober 2025
Consul

Consul CFS50A Manual

2 Oktober 2025
Mirage

Mirage 59510P Manual

2 Oktober 2025
Consul

Consul CFC50D Manual

2 Oktober 2025
Respekta

Respekta KM6600IB-28 Manual

2 Oktober 2025
Respekta

Respekta SH1000-33 Manual

2 Oktober 2025
Airlux

Airlux ATIF64BKM Manual

2 Oktober 2025
Sharp

Sharp KH-6V13NS0I-EU Manual

2 Oktober 2025
ElectriQ

ElectriQ IQGH603S Manual

2 Oktober 2025