GE Profile JP930SCSS Manual

GE Komfur Profile JP930SCSS

Læs gratis den danske manual til GE Profile JP930SCSS (8 sider) i kategorien Komfur. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om GE Profile JP930SCSS, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

TOOLS YOU WILL NEED

MATERIALS YOU WILL NEED

229C4053P529-1

31-10545-1 05-03 JR

Installation

30″Electric Cooktop

Instructions

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

• IMPORTANT —Save these

instructions for local inspector’s use.

• IMPORTANT —Observe all

governing codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these

instructions for future reference.

• Product failure due to improper installation

is not covered under the Warranty.

WARNING — This appliance must

be properly grounded.

•ATTENTION INSTALLER —

ALL COOKTOPS MUST BE HARD WIRED

(DIRECT WIRED) INTO AN APPROVED

JUNCTION BOX. A “PLUG AND

RECEPTACLE” IS NOT PERMITTED ON

THESE PRODUCTS.

• Proper installation is the responsibility

of the installer and product failure due to

improper installation is NOT covered under

warranty.

PARTS INCLUDED

Wire Nuts

Junction Box

Saber Saw

Pencil

Safety Glasses

1/8″Drill Bit & Electric

or Hand Drill

Ruler or Straightedge

Phillips Head

Screwdriver

JP340, JP350, JP930, JP931, JP938, JP939

“If you have questions, call 800.GE.CARES or visit our website at:

www.GEAppliances.com”

2 Hold Down

Brackets

4 Screws Foam Tape

Installation Instructions

FOR YOUR SAFETY

• For Personal Safety, remove house fuse

or open circuit breaker before beginning

installation. Failure to do so could result

in serious injury or death.

• Be sure your cooktop is installed properly

by a qualified installer or service technician.

• To eliminate the risk of burns or fire due

to reaching over heated surface elements,

cabinet storage located above the surface

units should be avoided. If cabinet storage

space is to be provided, the risk can be

reduced by installing a range hood that

projects horizontally a minimum of 5″

beyond the bottom of the cabinets. Cabinet

installation above the cooktop may be no

deeper than 13″.

• Make sure the cabinets and wall coverings

around the cooktop can withstand the

temperatures (up to 200°F) generated

by the cooktop.

• The cooktop should be easy to reach and

lighted with natural light during the day.

• Always disconnect the electrical service to

the cooktop before repairing or servicing

the cooktop. This can be done by

disconnecting the fuse or circuit breaker.

Failure to do this could result in a

dangerous or fatal shock. Know where your

main disconnect switch is located. If you do

not know, have your electrician show you.

IMPORTANT SAFETY INSTRUCTIONS

ELECTRICAL REQUIREMENTS

This appliance must be supplied with the

proper voltage and frequency, and connected

to an individual, properly grounded branch

circuit, protected by a circuit breaker or a

time delay fuse as noted on rating plate.

We recommend you have the electrical wiring

and hookup of your cooktop connected by a

qualified electrician. After installation, have

the electrician show you where your main

cooktop disconnect is located.

Wiring must conform to National Electrical

Code. You can get a copy of the National

Electrical Code, ANSI/NFPA No. 70-Latest

Edition, by writing:

National Fire Protection Association

Batterymarch Park

Quincy, MA 02269

The cooktop conduit wiring is approved for

copper wire connection only, and if you have

aluminum house wiring, you must use

special UL approved connectors for joining

copper to aluminum.

You must use a two-wire, three conductor

208/240 VAC, 60 Hertz electrical system. A

white (neutral) wire is not needed for this

unit. The cooktop must be installed in a

circuit that does not exceed 125 VAC nominal

to ground.

Refer to the rating plate on your cooktop for

the KW rating for your cooktop.

Produkt Specifikationer

Mærke:	GE
Kategori:	Komfur
Model:	Profile JP930SCSS

Har du brug for hjælp?

Hvis du har brug for hjælp til GE Profile JP930SCSS stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Komfur GE Manualer

GE PXOVNPRB1VDM Manual

17 Juni 2025

GE JB480SYSS Manual

17 Juni 2025

GE GRF500SVSS Manual

17 Juni 2025

GE JCB840 Manual

17 Januar 2025

GE JGS650SEFSS Manual

24 December 2024

GE PC2S930YPFS Manual

16 August 2024

GE JDP36BWWH Manual

6 August 2024

GE JGBS60DEKCC Manual

26 Juli 2024

GE JB640DFWW Manual

27 Maj 2024

GE JBS61BCAD Manual

26 Maj 2024

Komfur Manualer

Nyeste Komfur Manualer

De Dietrich DPV4605HB Manual

18 Juni 2025

Smeg SIMU315D Manual

18 Juni 2025

Maytag MCIT8036SB Manual

18 Juni 2025

De Dietrich DPE4400X Manual

18 Juni 2025

De Dietrich DPE4729XF Manual

18 Juni 2025

Smeg PGFU30X2 Manual

17 Juni 2025

AEG NII64G00FZ Manual

17 Juni 2025

InAlto ICI30T Manual

17 Juni 2025

AEG NIK95I00FZ Manual

17 Juni 2025

Premium Levella PGS2406 Manual

17 Juni 2025