Genelec 8340AWM Manual

Genelec Højttaler 8340AWM

Læs gratis den danske manual til Genelec 8340AWM (8 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 65 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 33 anmeldelser. Har du et spørgsmål om Genelec 8340AWM, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

8350A

8340A

Operating Manual

750-8340A/8350A

Introduction

Congratulations and a thank you for the purchase of this Genelec

Smart Active Monitor (SAM) system. This manual addresses

the stand-alone setup and use of the 8340A and 8350A SAM

monitors. These monitors can also be set up and used with

the Genelec Loudspeaker Manager GLM™ and the proprietary

Genelec monitor control network and software, offering much

more versatile acoustic settings and features. Use with the

GLM™ is described in the GLM™ System Operating Manual.

All Genelec SAM systems are designed to integrate easily

into all professional environments, supporting both standard

analog line level audio and AES/EBU formatted digital audio

signals.

The 8340A and 8350A are suitable for professional monitoring

tasks demanding high precision and reliability of monitoring.

The Minimum Diffraction Enclosure™ (MDE™) and advanced

Directivity Control Waveguide™ (DCW™) technologies

provide excellent frequency balance even in difficult acoustic

environments.

Each monitor is supplied with a mains cable, one 5 m GLM

network cable and an operating manual.

Energy saving Intelligent Signal Sensing (ISS™) can be turned

on to put the monitor automatically into a deep sleep state

where the product consumes less than one Watt of power.

Upon sensing an input signal the monitor automatically wakes

up to full operation. The wait until entering the ISS power save

can be configured using the GLM software. When the ISS is

active you can have your monitoring system ready for action

at all times.

System setup using GLM™ Control

Network

Although the 8340A and 8350A can be used without the

GLM™ software and control network, they only reach their

full potential when set up and calibrated using the GLM™

software. Genelec Loudspeaker Manager GLM™ and the

proprietary Genelec monitor control network and software

offer automated acoustic equalization and alignment for any

reproduction system from simple stereo to very complex

3D immersive audio setups including also one or more

subwoofers. GLM setup is fast and accurate. The settings can

be controlled with a computer or be permanently stored in the

monitors to make the setup available at all times even when

a computer is not in use. Genelec recommends setting up

SAM monitoring systems using GLM. You can find a detailed

description of the setup and the use of GLM™ in the GLM™

System Operating Manual.

The setup is fast and consists of the following steps:

• Connect a CAT5 (RJ45) cable between each monitor (and

subwoofer) and finally to the control network input of the

GLM Adapter device (see Figure 1).

• Connect the GLM Adapter device to computer USB

connector.

• Using a microphone stand, place the Genelec measurement

microphone at the listening location with the microphone

pointing upwards and the microphone top at the height of the

engineer’s ear. The microphone is a part of the GLM User Kit.

• Connect the microphone cable to the microphone input in

the GLM Adapter device.

• Download the GLM software at the Genelec web site (www.

genelec.com).

• Install the GLM software and follow the instructions in the

software to measure and set up your monitors.

• If you plan to not use a computer for controlling the

monitors, use the GLM software to write the setting into the

monitors (use menu item “Store | Store the Current Group

Settings…”).

While the GLM network is disconnected the settings stored

using the Genelec Loudspeaker Manager software can be

selected in use by setting the STORED switch ON.

Setup without using the GLM

When GLM is not available, you can use the settings on the

monitor for system setup. These settings are limited but provide

the basic acoustical calibrations and input selection. To use this

method, set the STORED switch OFF.

Connect the MAINS INPUT to the mains supply. These

products support any mains voltage globally (100-240 VAC,

50-60 Hz) so they can be plugged in anywhere. If the mains

power is provided with a generator, inverter or certain lower-

quality UPS devices, we recommend filtering of the mains

power voltage harmonics and taking care that the voltage

supply is stable.

The ANALOG IN connector is used for analog audio signals. The

maximum input level is +25 dBu. These monitors produce 100

dB SPL sound level at 1 meter in free space for an analogue

input signal of -6 dBu.

The DIGITAL IN AES/EBU female XLR connector is for AES/

EBU formatted digital audio input signals. This input is selected

automatically when a valid digital audio signal is present.

Analog input is selected when the AES/EBU signal input is

disconnected. The AES/EBU input supports two channels in a

single cable). When the digital source device controls the digital

output level, it may be advantageous to lower the level on the

monitor’s controls, which will enable the use of a higher digital

signal level with more digital resolution. With digital inputs the

audio is referenced to 0 dBFS (dB relative to the digital full scale,

the largest level that can be represented in the AES/EBU signal).

LISTENING

POSITION

MICROPHONE

GLM

NETWORK

GLM

NETWORK

GLM

NETWORK

USB

Figure 1. GLM control network cabling

Produkt Specifikationer

Mærke:	Genelec
Kategori:	Højttaler
Model:	8340AWM
Bredde:	234 mm
Dybde:	223 mm
Højde:	365 mm
Vægt:	8400 g
Brugervejledning:	Ja
Produktfarve:	Hvid
Udgangseffekt (RMS):	300 W
Anbefalet brug:	Studio
Frekvensområde:	38 - 22000 Hz
Forbindelsesteknologi:	Ledningsført
Højttaler, type:	2-vejs
Lyd-output kanaler:	1.0 kanaler
Højttaler, placering:	Floor, Tabletop/bookshelf
Antal drivere:	2
Diskanthøjttaler:	Ja
Sensitivitet:	110 dB
Diskant diameter:	19 mm
Bashøjttaler:	Ja
Woofer diameter:	165 mm
Forstærker:	Indbygget
Woofer diameter (britisk mål):	6.5 "
XLR indgang:	Ja