With each wash cycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user instructions !)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water softener system only.)
Electric indicator on c ontrol panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate whe n to f ill the salt int o
the softener by t he number of cycles the dishwasher has run.
Check the regeneration
salt le vel
Load the baskets
Select a p rogramme
Close the door, t urn on the water tap and press the St art/reset button. The machine will start working
after about 10 seconds.
Running the dishwasher
Swi tch off the applia nce
Turn off the wate r tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 min utes) before unloading the dishwa sher to avoid handling
the dishes and utensils while they are still hot and more sus c eptible to break.
The y will a lso dry better.Unload the appliance, starting from the lower b asket.
Changing the pro gramme
Add forgot ten di shes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pa ns,
then l oad the baskets. Refer to the dish washe r loading instruct ions.
Press the Programme butto n until the selected progra m me li ghts up .
( See th e section entitled Ope rationg instructio n )“ ”
When the working cy cle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he do o r carefu ll y.
Hot st eam may escape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on agai n, plea se re-select th e washing cycle and operate the dishwasher
ac cording to the original Power-on state ).
Switch on the appliance Pre ss the On/Off button to switch on the applian c e, Open the door.
1.Open the door a little to sto p the dishwasher.
2.After the spra y arms stop working, you can ope n the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwa sher will star t running again after 10 sec onds.
For detailed operating method read the corresponding content on the instructio n manual.
1. A running cycle can only be modified if it has been running for a short time. O therwise the deterg ent
m ay have alre ady be en released and the water already drained. If this is the case, the de tergent
dispenser must be refilled.
2. Press the Start/Reset button for more than 3 second s to cancel the running programme.
3. Select a new programme.
4. R estart the di shwa sh er.
