Greisinger EBHT-1R Manual

Greisinger Ikke kategoriseret EBHT-1R

Læs gratis den danske manual til Greisinger EBHT-1R (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Greisinger EBHT-1R, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

T20.0.2X.6C-05 page 1 of 4

Operating Manual

EASY

BUS

- Sensor Module

for Relative Air Humidity And Temperature

EBHT – 1R / 1K / 2K / Kabel

as of V2.8

Specification:

Measuring range: relative air humidity: 0.0...100.0 % rel. humidity (temperature compensated)

temperature: -40.0...120.0 °C or -40.0...248 °F

Rec. range of application: standard: 20,0...80,0 %RH

option high humidity: 5,0...95,0 %RH

Accuracy: (at nominal temperature = 25°C)

relative air humidity: ±1% linearity, 2% hysteresis

(at recommended range of application

)

temperature: 0.5% of measured value ±0.1°C

Sensors: relative air humidity: cap. polymer sensor

temperature: Pt1000

Temperature compensation: automatic

Min-/Max-Value Memory: Min and max measured values are stored

Output signal: EASY

BUS

-protocol

Connection: 2-wire EASY

BUS

, polarity free

Busload: 1.5 EASY

BUS

-devices

Adjusting: via interface or keypress (only with option VO)

by input of offset and scale (humidity and

temperature)

Display: (option) approx. 10 mm high, 4-digit LCD-display

Ambient conditions for electronics:

Nominal temperature: 25 °C

Operating temperature: -25 to 50 °C (sensor head and tube: -40 to 100°C – for short time up to 120°C)

Relative humidity: 0 to 95 %RH (non-condensing)

Storage temperature: -25 to 70 °C

Housing: ABS (IP65)

Dimensions: 82 x 80 x 55 mm (without elbow-type plug and sensor tube)

Mounting: With holes for wall mounting (in housing - accessible after cover has been removed).

Mounting distance: 50 x 70mm, max. shaft diameter of mounting screws is 4 mm.

Electrical connection: elbow-type plug conforming to DIN 43650 (IP65),

max. wire cross section: 1.5 mm², wire/cable diameter from 4.5 to 7 mm

EMC: The

device corresponds to the essential protection ratings established in the Regulations of the Council for the

Approximation of Legislation for the member countries regarding electromagnetic compatibility (89/336/EWG). In

accordance with

EN61326 +A1 +A2 (appendix A, class B), additional errors: < 1% FS.

When connecting long leads adequate measures against voltage surges have to be taken.

GREISINGER

electronic GmbH

D - 93128 Regenstauf, Hans-Sachs-Straße 26

Tel.: 0049 9402 / 9383-0, Fax: 0049 9402 / 9383-33, eMail: info@greisinger.de

Working area of humidity sensor:

T20.0.2X.6C-05 page 2 of 4

Safety instructions:

This device has been designed and tested in accordance with the safety regulations for electronic devices.

However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and special safety

advises given in this manual will be adhered to when using the device.

1. Trouble-free operation and reliability of the device can only be guaranteed if the device is not subjected to any other climatic

conditions than those stated under "Specification". If the device is transported from a cold to a warm environment condensation

may cause in a failure of the function. In such a case make sure the device temperature has adjusted to the ambient temperature

before trying a new start-up.

2. General instructions and safety regulations for electric, light and heavy current plants, including domestic safety regulations (e.g.

VDE), have to be observed.

3. If device is to be connected to other devices (e.g. via PC) the circuitry has to be designed most carefully. Internal connection in third

party devices (e.g. connection GND and earth) may result in not-permissible voltages impairing or destroying the device or another

device connected.

4. If there is a risk whatsoever involved in running it, the device has to be switched off immediately and to be marked accordingly to

avoid re-starting.

Operator safety may be a risk if:

- there is visible damage to the device

- the device is not working as specified

- the device has been stored under unsuitable conditions for a longer time.

In case of doubt, please return device to manufacturer for repair or maintenance.

5. Warning:

Do not use this product as safety or emergency stop devices, or in any other application where failure of the product could result in

personal injury or material damage.

Failure to comply with these instructions could result in death or serious injury and material damage.

Disposal instructions:

The device must not be disposed in the regular domestic waste.

Send the device directly to us (sufficiently stamped), if it should be disposed. We will dispose the device appropriate and

environmentally sound.

Assignment of elbow-type plug:

2-wire connection EASY

BUS

, no polarity, at terminals 1 and 2

General installation instructions:

To mount the connection cable (2-wire bus cable) the elbow-type plug screw has to be loosened and the coupling insert

has to be removed by means of a screw driver at the position indicated (arrow).

Pull out connection cable through PG glanding and connect to the loose coupling insert as described in the wiring

diagram. Replace loose coupling insert onto the pins at the transducer housing and turn cover cap with PG glanding in

the direction desired till it snaps on (4 different starting positions at 90° intervals). Re-tighten the screw at the angle plug.

Design types, dimensions

EBHT-1R EBHT-1K EBHT-2K EBHT-Kabel

short sensor tube aside long sensor tube aside long sensor tube bottom separated sensor tube

Produkt Specifikationer

Mærke:	Greisinger
Kategori:	Ikke kategoriseret
Model:	EBHT-1R

Har du brug for hjælp?

Hvis du har brug for hjælp til Greisinger EBHT-1R stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Greisinger Manualer

Greisinger T-Logg 120 W Manual

28 August 2024

Greisinger EASYlog 80 CL Manual

28 August 2024

Greisinger T-Logg 120 K Manual

28 August 2024

Greisinger GHTU-1R Manual

13 August 2024

Greisinger GFTB 200 Manual

11 August 2024

Greisinger GMH 3181-07 Manual

11 August 2024

Greisinger GMH 3156 Manual

11 August 2024

Greisinger T-Logg 100 Manual

8 August 2024

Greisinger GRHU-1R Manual

8 August 2024

Greisinger GIA 20 EB Manual

7 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

ENTES GEMO-10-DR-4G Manual

14 Juni 2025

Marshall VAC-12SH Manual

14 Juni 2025

Rane MX 22 Manual

14 Juni 2025

Vulcan VCH88 Manual

14 Juni 2025

Fluke SB140 Manual

14 Juni 2025

Blodgett BCT-101G Manual

14 Juni 2025

Rival 11570 Manual

14 Juni 2025

CDN MT1 Manual

14 Juni 2025

Savage Bros. FireMixer-14 Manual

14 Juni 2025

HMS Premium STR01 Manual

14 Juni 2025