Hotpoint H3 D91GS UK Manual

Hotpoint Tørretumbler H3 D91GS UK

Læs gratis den danske manual til Hotpoint H3 D91GS UK (4 sider) i kategorien Tørretumbler. Denne vejledning er vurderet som hjælpsom af 66 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 33.5 anmeldelser. Har du et spørgsmål om Hotpoint H3 D91GS UK, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

CARE LABEL

Always check the care labels, especially when placing garments

in the tumble dryer for the  rst time. Below are the most

commonly used symbols:

May be tumble dried.

Do not tumble dry.

Tumble dry – high heat.

Tumble dry – low heat.

THANK YOU FOR BUYING A HOTPOINT PRODUCT.

In order to receive a more complete assistance, please

Quick guide

Before using the appliance carefully read the Safety

Instructions.

FIRST TIME USE

Remove all the tapes used to hold items on the machine.

Before you use it, clean the inside of the drum to remove any

dust that could have accumulated during transport. Slight odour

or vapour may be found if you open the door during its rst use,

this is normal and should only last a few minutes.

Make sure that the water tank is correctly inserted. Make sure

that the drain hose on the back of the dryer is properly

connected, either to the dryers's water tank or to your domestic

drainage system.

The dryer must be installed in a room with a temperature

ranging between 5°C and 35°C to ensure proper operation.

DAILY USE

Doing this will keep your machine working at its BEST:

- remember to empty your water tank after each drying cycle.

- remember to clean your condenser unit regularly

(monthly).

- remember to clean your lter after each drying cycle.

Refer to the Care & Maintenance section.

1. Plug the dryer into the power supply socket.

2. Open the door and load garments; always refer to instructions on

clothing labels and the max loads indicated in the programme

section. Empty pockets. Make sure garments do not get caught

between the door and/or the door lter. Do not load items that

are dripping wet. Do not tumble dry large, very bulky items.

3. Close the door.

4. Press the "On/O" button.

5. Select the most suitable programme

for the type of fabric in that

load.

6. Select the options, if necessary.

7. Press the "

Start/Pause"

button to begin drying.

8. At the end of the drying cycle, a buzzer will beep. An indicator on

the control panel signals the end of the cycle. Pull the load out

immediately to prevent the formation of creases on laundry.

9. Turn the machine o by pressing the "On/O" button, open the

door and pull the clothing out. If the machine is not switched o

manually, after about a quarter of an hour from the end of the

cycle , the appliance turns o automatically to save energy.

Note that some programme/option accords with "Crease Care"

system. This means that for some hours, after the end of the

drying cycle, the drum rotates at regular intervals to prevent the

formation of creases.

In case of power failure, it is necessary to press the "Start/Pause"

button to restart the cycle.

TRANSPORT AND HANDLING

Never lift the dryer by holding on to its top side.

1. Unplug the dryer

2. Remove the water from the water tank completely.

3. Make sure that door and water tank are properly closed.

4. If the drain hose is connected to your drainage system, re-connect

it to the back of the dryer (see "Installation" section in the Safety

Instructions).

OPENING THE DOOR DURING THE CYCLE

Laundry can be checked while the drying cycle runs and any

garments already dry can be removed, while drying continues for

the remaining items. After closing the door, press the "Start/Pause"

button to resume machine operation.

CONTROL PANEL

1 ON/OFF Button (hold to Reset)

2 Programme Selection Knob

3 Start/Pause

Options Buttons

4 Crease Care

5 Dryness Level

6 Start Delay

7 Timed Drying

8 Cycle End Signal

9 Gentle (hold for Key Lock)

10 Rapid hold to Mute)(

INDICATORS

Dryness Level: Iron Dry - Hanger Dry - Cupboard Dry - Extra Dry

Programme Status: ENDDrying - Cool Down - End of Cycle

Empty water tank Clean door lter - - Clean the condenser unit

Refer to the troubleshooting section: Failure: Call after sales service.

END

5 6 7

Produkt Specifikationer

Mærke:	Hotpoint
Kategori:	Tørretumbler
Model:	H3 D91GS UK

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint H3 D91GS UK stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Tørretumbler Hotpoint Manualer

Hotpoint HPT 94D BS IT Manual

8 Oktober 2025

Hotpoint C HD 84M WBS UK Manual

29 September 2025

Hotpoint HPT 83D BS IT Manual

5 August 2025

Hotpoint HPT 103D BS IT Manual

5 August 2025

Hotpoint H8 D94SB IT Manual

2 August 2025

Hotpoint HPTS 74D BS IT Manual

2 August 2025

Hotpoint NT M11 91WK EU Manual

2 August 2025

Hotpoint NT M11 82SK Manual

1 August 2025

Hotpoint NT M11 8X3SK EU Manual

1 August 2025

Hotpoint NT M11 8X3SK IT Manual

1 August 2025

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

Candy GD 10N1-80 Manual

17 November 2025

Bosch WQB246D41 Manual

17 November 2025

Otsein-Hoover OHDV 6 Manual

17 November 2025

Haier HD80-D357U1 Manual

17 November 2025

Otsein-Hoover OHDC 7 X Manual

17 November 2025

Siemens WQ45H2BIDN Manual

16 November 2025

Otsein-Hoover OHNC 475 S Manual

16 November 2025

Fors TP 800 A-2 Manual

15 November 2025

Whirlpool WGD4307SW Manual

15 November 2025

BEKO BM3T3824BC Manual

15 November 2025