Hotpoint HA6IA14BN7A0 Manual

Hotpoint Opvaskemaskine HA6IA14BN7A0

Læs gratis den danske manual til Hotpoint HA6IA14BN7A0 (16 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om Hotpoint HA6IA14BN7A0, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
EN
1
DAILY REFERENCE
GUIDE
PRODUCT DESCRIPTION
THANK YOU FOR BUYING A HOTPOINT ARISTON
PRODUCT. In order to receive a more complete
assistance, please register your appliance on:
www.hotpoint.eu/register
APPLIANCE
CONTROL PANEL
1. On-O/Reset button with indicator light
2. Program selection button
3. Salt rell indicator light
4. Rinse Aid rell indicator light
5. Program number and delay time indicator
6. Tablet (Tab) indicator light
7. Display
8. 3D Zone Wash indicator lights
9. 3D Zone Wash button
10. Delay button
11. START/Pause button with indicator light / Tablet (Tab)
1 2 3 4 5 6 7 8 9 10
11
1. Upper rack
2. Cutlery rack
3. Foldable aps
4. Upper rack height adjuster
5. Upper spray arm
6. Lower rack
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
0000 000 00000
Service:
1
4
5
6
11
7
12
8
9
2
3
10
PLEASE SCAN THE QR CODE
ON YOUR APPLIANCE IN ORDER
TO HAVE MORE DETAILED
INFORMATION
Before using the appliance carefully read Safety Instructions guide.
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
• It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be lled when the SALT REFILL
indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the rst time you do this: ll the salt
reservoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory sets the default value for the water hardness:
• Switch on the appliance by pressing the ON/OFF button.
• Switch o the appliance by pressing the ON/OFF button.
• Hold down button P for 5 seconds, until you hear a beep.
• Switch on the appliance by pressing the ON/OFF button.
• The current selection level number and the salt indicator light both ash.
• Press button P to select the desired hardness level (see WATER
HARDNESS TABLE).
• Switch o the appliance by pressing the ON/OFF button.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
Water Hardness Table
Level
°dH
German degrees
°fH
French degrees
°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should be l-
led when the RINSE AID REFILL indicator light in the control panel is lit.
1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can ad-
just the quantity of rinse aid used.
• Switch the dishwasher on using the ON/OFF button.
• Switch it o using the ON/OFF button.
• Press button P three times - a beep will be heard.
• Switch it on using the ON/OFF button.
• The current selection level number and rinse aid indicator light ash.
• Press button P to select the level of rinse aid quantity to be supplied.
• Switch it o using the ON/OFF button
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied.
The LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (1-2).
• If there are drops of water or limescale marks on the dishes, set a
mid-range number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser D there are indi-
cations to help the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Usage of detergent not designed for dishwashers may cause mal-
function or damage to the appliance.
A
B
C
D

Produkt Specifikationer

Mærke: Hotpoint
Kategori: Opvaskemaskine
Model: HA6IA14BN7A0

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint HA6IA14BN7A0 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Opvaskemaskine Hotpoint Manualer

Hotpoint

Hotpoint HI 3010 Manual

2 August 2025
Hotpoint

Hotpoint HSIO 3O23 WFE dishwasher Manual

2 August 2025
Hotpoint

Hotpoint HIC 3O33 WLEG Manual

1 August 2025
Hotpoint

Hotpoint HFC 2B19 X Manual

1 August 2025
Hotpoint

Hotpoint HIC 3C41 CW Manual

1 August 2025
Hotpoint

Hotpoint HFC 3C32 WX Manual

1 August 2025
Hotpoint

Hotpoint HIC 3C34 Manual

1 August 2025
Hotpoint

Hotpoint HSIC 3T127 C Manual

1 August 2025
Hotpoint

Hotpoint HBC 3C41 W Manual

1 August 2025
Hotpoint

Hotpoint ELTB 4B019 EU Manual

1 August 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Neff

Neff S145HTS01G Manual

12 September 2025
Whirlpool

Whirlpool ADP 4736 IX Manual

12 September 2025
Barazza

Barazza 1LVE6I Manual

12 September 2025
Robinhood

Robinhood DWM12P6FSS Manual

12 September 2025
Siemens

Siemens SK25210EU Manual

12 September 2025
Fagor

Fagor 4LVF-435AD Manual

12 September 2025
Siemens

Siemens SN46M293SK Manual

11 September 2025
Gorenje

Gorenje GV693A60UVAD Manual

11 September 2025
Bosch

Bosch SMS40E38EU Manual

11 September 2025
Hoonved

Hoonved C 60 D E Manual

10 September 2025