Hotpoint NRFAA50S Manual

Hotpoint Køleskab NRFAA50S

Læs gratis den danske manual til Hotpoint NRFAA50S (12 sider) i kategorien Køleskab. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Hotpoint NRFAA50S, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

REFRIGERATOR/FREEZER COMBINATION

RFA52 xx

NRFAA50 x

Contents

Installation, 2-4

Positioning and connection

Door reversal

Description of the appliance, 5

Overall view

Start-up and use, 6-7

Starting the appliance

Using the refrigerator to its full potential

Using the freezer to its full potential

Maintenance and care, 8

Switching the appliance off

Cleaning the appliance

Avoiding mould and unpleasant odours

Replacing the light bulb

Precautions and tips, 9

General safety

Disposal

Respecting and conserving the environment

Troubleshooting, 10

Guarantee, 11

After Sales Service,12

Operating Instructions

English

Installation

Your appliance is supplied with a 13amp fused plug that

can be plugged into a 13amp socket for immediate use.

Before using the appliance please read the instructions

below.

WARNING:

THIS APPLIANCE MUST BE EARTHED.

Replacing fuse covers:

When replacing a faulty fuse, a 13amp ASTA approved

fuse to BS 1362 should always be used and the fuse

cover re-fitted.

If the fuse cover is lost, the plug must not be used until a

replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the

correct colour as indicated by the coloured marking or the

colour that is embossed in words on the base of the plug.

Changing the plug:

Removing the plug

If your appliance has a non-rewireable moulded plug and

you should wish to remove it to add a longer cable or

to re-route the mains cable through partitions, units etc.

please ensure that either:

- The plug is replaced by a fused 13amp re-

wireable plug bearing the BSI mark of

approval.

- The mains cable is wired directly into a

13amp cable outlet, controlled by a

switch (in compliance with BS 5733)

which is accessible without moving the

appliance.

Disposing of the plug

Cut off and dispose of the supplied plug if it does not

fit your socket. The cable should be cut as close as

possible to the moulded plug.

Remove the fuse.

WARNING:

To avoid a shock hazard do not insert the discarded

plug into a socket anywhere else.

! Before placing your new appliance into operation please

read these operating instructions carefully. They contain

important information for safe use, for installation and for

care of the appliance.

! Please keep these operating instructions for future

reference. Pass them on to possible new owners of the

appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated humidity-free

room.

2. Do not obstruct the rear fan grills. The compressor and

condenser give off heat and require good ventilation to

operate correctly and save energy.

3. Leave a space of at least 10 cm between the top part of

the appliance and any furniture above it, and at least 5 cm

between the sides and any furniture/side walls.

4. Ensure the appliance is away from any sources of heat

(direct sunlight, electric stove, etc.).

5. In order to maintain the correct distance between the

appliance and the wall behind it, fit the spacers supplied

in the installation kit, following the instructions provided.

Levelling

1. Install the appliance on a level and rigid floor.

2. If the floor is not perfectly horizontal, make the necessary

adjustments by tightening or loosening the single foot at

the front of the appliance.

Electrical connections

After the appliance has been transported, carefully place it

vertically and wait at least 3 hours before connecting it to the

electricity mains. Before inserting the plug into the electrical

socket ensure the following:

• The appliance is earthed and the plug is compliant with

the law.

• The socket can withstand the maximum power of the

appliance, which is indicated on the data plate located on

the bottom left side of the fridge (e.g. 150 W).

• The voltage must be in the range between the values

indicated on the data plate located on the bottom left side

(e.g. 220-240V).

• The socket is compatible with the plug of the appliance.

If the socket is incompatible with the plug, ask an

authorised technician to replace it (see Assistance). Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power supply

cable and the electrical socket must be easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).

! The manufacturer declines any liability should these

safety measures not be observed.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24

Produkt Specifikationer

Mærke:	Hotpoint
Kategori:	Køleskab
Model:	NRFAA50S
Bredde:	550 mm
Dybde:	540 mm
Højde:	1570 mm
Produktfarve:	Sølv
Pakkedybde:	660 mm
Pakkebredde:	600 mm
Pakkehøjde:	1610 mm
Energieffektivitetsklasse (gammel):	A+
Årligt energiforbrug:	242 kWh
Placering af apparat:	Fritstående
Tilsluttet belastning:	- W
Støjniveau:	43 dB
Vendbare døre:	Ja
Fryser, netto rumindhold:	67 L
Fryser, brutto rumindhold:	73 L
Frysekapacitet:	2 kg/24t
Opbevaringstid under strømafbrydelse:	15 t
Klimaklasse:	SN-T
Køleskab antal hylder/kurve:	3
Antal grøntsagsskuffer:	2
Køleskabsdøre:	3
Køleskab, netto rumindhold:	150 L
Total netto kapacitet:	217 L
Understøtter VPN:	228 L
Køleskab indvendigt lys:	Ja
Stjernebedømmelse:	4*
Fryser position:	Bottom-placeret
Hylder, materiale:	Hærdet glas
Køleskab, brutto rumindhold:	155 L
Hurtig frys funktion:	Ja
Fryser antal hylder/kurve:	2
Super Cool funktion:	Ja
Isterning bakke:	Ja
Anti-bakterial lag:	Ja