Hotpoint TCFM 80C GP Aquarius Manual

Hotpoint Tørretumbler TCFM 80C GP Aquarius

Læs gratis den danske manual til Hotpoint TCFM 80C GP Aquarius (4 sider) i kategorien Tørretumbler. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Hotpoint TCFM 80C GP Aquarius, eller vil du spørge andre brugere om produktet?

Side 1/4
Instruction booklet
TUMBLE DRYER TCAM 80C
TCEM 80C
TCYM 80C
TCFM 80C
Important Information
FLUFF FILTER
You must clean the fluff filter after drying cycle. EVERY
Step 1
Open the door of your dryer.
Step 2
Pull out the filter (using the two
finger grips).
Step 3
Open the filter and clean any fluff
deposits from the filter mesh.
Step 4
Refit the filter with the curved
side towards you.
Step 5
Make sure the filter is pushed
fully home - run the dryer NEVER
without the filter in position.
Failure to clean the filter after EVERY drying cycle will affect
the drying performance of your machine.
It will take longer to dry and as a result will use more
electricity during drying.
You MUST empty the water container after EVERY drying cycle.
Failure to empty the water container will cause the machine to stop heating and the load may still be wet at the end of the
drying cycle. The ‘Empty Water’ light will tell you that the water container is full and needs emptying.
!
!
PRODUCT DATA... (EU Regulation 392/2012)
Rated capacity of Cotton laundry for the standard programme at full load Energy efficiency class 8 kg C
The weighted Annual Energy Consumption (AEc) kWh.627.2
Consumption per year, based on 160 drying cycles of the standard cotton programme at full and partial load, and the consumption of
the low-power modes. Actual energy consumption per cycle will depend on how the appliance is used
This household tumble dryer is a Non-Automatic Condenser Dryer
Energy consumption: full load Edry
kWh, partial load E5.26 dry1/2 kWh2.91
Power consumption: off-mode (Po) W0.00
Duration of the ‘left-on mode’ for power management systems - minutesN/A
The ‘standard cotton programme’ suitable for drying normal wet cotton laundry that is the most efficient programme in terms of
energy consumption for cotton used at full and partial load is High Heat
Programme time (minutes) weighted (Tt) full & partial load , full load (T115 dry) , partial load (T150 dry1/2) 88
Condensation efficiency class C
Average condensation efficiency (%): full load (Cdry) , partial load (C73 dry1/2) , weighted (C74 t) full & partial load 74
Airborne acoustical noise emissions dB(A) re 1 pW.69
This data is also available on the website http://www.hotpoint.eu/hotpoint
This symbol reminds you to read this booklet.
Dryer Description
Control panel
Installation
WATER CONTAINER
You empty the water container MUST
after drying cycle.EVERY
Removing the water container:
Step 1
Pull the water container towards you and remove it completely
from the dryer.
Step 2
Empty all the water in the water container.
Step 3
Replace the water container making sure that it is securely fixed.
Priming the Water Collection System.
When your dryer is new, the water container will not collect
water until the system is primed. This will take 1 or 2 drying
cycles. Once primed it will collect water during every drying
cycle.
!
CONDENSER UNIT
You clean the fluff from the MUST
condenser month. Failure to EVERY
clean the condenser could cause
premature failure of your dryer.
Remove the condenser unit regularly (at least monthly) and clean
off any fluff deposits.
Step 1
Open the condenser cover.
Step 2
Remove the condenser
by turning the 3 catches
and pulling the condenser towards you. It is
normal for some residual water to be left in
the condenser unit.
Step 3
Flush the condenser from the rear with water
to remove any fluff deposits.
Step 4
Replace the condenser unit and make sure
that all 3 catches are closed and that the
position arrows on the front of the condenser
are pointing upwards.
WHERE TO PUT YOUR DRYER
If you are going to install the dryer
under a work counter be sure to leave
a 10mm space between the top and
any other objects on or above the
machine and a 15mm space between
the sides and any kitchen units or
walls to ensure proper air circulation.
The dryer must never be installed
behind a lockable door, a sliding door
or a door with a hinge on the opposite
side to that of the dryer door.
WATER DRAINAGE CONNECTION
If the dryer is installed next to a drain
the water can be plumbed into this
drain. This does away with the need to
empty the water container. The height of
the drain must be less than 1m from the
bottom of the dryer. Remove the existing
hose from the dryer and connect it to
the drain (if required add an additional
length of hose).
ELECTRICAL CONNECTIONS
The socket must be grounded. The power supply cord should be
checked periodically and, if required, replaced by a cord specially
prepared for this dryer.
BEFORE YOU START USING YOUR DRYER
Once you have installed your dryer and before you use it clean
the inside of the drum to remove any dust that could have
accumulated during transport.
10
m
m
15 mm
5
15 mm
15 mm
20
30
40
50
60
70
80
100
110
120
130
0
TIMER
Knob Indicator
HEAT
Button
START
Button
Empty water
Light
The HEAT button selects drying temperature.
OUT: LOW IN: HIGH heat heat
The knob sets the drying time: rotate it clockwise, TIMER NEVER
COUNTER-CLOCKWISE, until the indictor is pointing to the drying
time you want to select.
The Empty Water indicator light signals that the water container is
full and must be emptied. The light will take a few seconds to go
out after replacing the empty water container, the dryer must be
running for this to happen.
Note: If the water container fills up the indicator lights, the heat is
turned off and your laundry will not dry.
2
2
1
Less than 1m


Produkt Specifikationer

Mærke: Hotpoint
Kategori: Tørretumbler
Model: TCFM 80C GP Aquarius

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint TCFM 80C GP Aquarius stil et spørgsmål nedenfor, og andre brugere vil svare dig