EN-1
FCC STATEMENT
Preface
About this Manual
• The contents of this manual and the bundled Basic Reference are subject to change without notice.
• Note that the example screens and product illustrations shown in this User’s Guide may differ
somewhat from the screens and configuration of the actual camera.
• This manual contains proprietary information protected by copyright. All rights are reserved. No part
of this manual may be reproduced by any mechanical, electronic or other means, in any form,
without prior written permission of the manufacturer.
• HP shall not be liable for technical or editorial errors or omissions contained herein.
© Copyright 2012
following two conditions:
( ) 1 This device may not cause harmful interference, and
( ) 2 This device must accept any interference received, including interference that may
cause undesired operation.
Note:
This e uipment has been tested and found to comply with the limits for Class B digital q
devices, pursuant to Part 1 of the CC rules. These limits are designed to provide 5 F
reasonable protection against harmful interference in a residential installation.This
e uipment generates uses and can radiate radio fre uency energy and, if not installed q q
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the e uipment and receiver.q
Connect the e uipment into an outlet on a circuit different from that to which the q
receiver is connected.
Consult the dealer or an experienced radio T technician for help./ V
Use of shielded cable is re uired to comply with Class B limits in ubpart B of Part 1 q S 5
of the CC rules.F
Do not make any changes or modifications to the equipment unless otherwise
specified in the manual. If such changes or modifications should be made, you could
be required to stop operation of the e uipment.q
Notice
If static electricity or electromagnetism causes data transfer to discontinue midway
( )fail , restart the application or disconnect and connect the communication cable
( )USB, etc. again.
Copyright
