Indesit DFP 27B+96 Z Manual

Indesit Opvaskemaskine DFP 27B+96 Z

Læs gratis den danske manual til Indesit DFP 27B+96 Z (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Indesit DFP 27B+96 Z, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

DAILY REFERENCE

GUIDE

Before using the appliance carefully read Health and Safety guide.

APPLIANCE

PRODUCT DESCRIPTION

CONTROL PANEL

0000 000 00000

Service:

1. Upper rack

2. Foldable aps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Cutlery basket

7. Lower spray arm

8. Filter Assembly

9. Salt reservoir

10. Detergent and Rinse Aid dispensers

11. Rating plate

12. Control panel

THANK YOU FOR BUYING A INDESIT PRODUCT.

In order to receive a more complete assistance, please

www.indesit.com

You can download the Safety Instructions and the

Use and Care Guide, by visiting our website

docs.indesit.eu and following the Instructions on

the back of this booklet.

1. On-O/Reset button

2. Program selection knob

3. Half load/Extra Light button with indicator light

4. Delay button with indicator light

5. Start/Pause button with indicator light

6. Washing and Delayed Start 3h. indicator light

7. Drying and Delayed Start 6h. indicator light

8. Wash Cycle End and Delayed Start 9h. Indicator light

9. Rinse Aid rell indicator light

10. Salt rell indicator light

1 2

3 4 5

6 7 8 9 10

FIRST TIME USE

SALT, RINSE AID AND DETERGENT

ADVICE REGARDING THE FIRST TIME USE

After installation, remove the stoppers from the racks and the reta-

ining elastic elements from the upper rack.

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and

on the machine’s functional components.

• It is important that the salt reservoir be never empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher (see Pro-

duct Description) and should be lled when the SALT REFILL indicator

light in the control panel is lit .

1. Remove the lower rack and unscrew the

reservoir cap (anticlockwise).

2. -Only the rst time you do this: ll the salt re

servoir with water.

3. Position the funnel (see gure) and ll the salt

reservoir right up to its edge (approximately

1 kg); it is not unusual for a little water to leak

out.

4. Remove the funnel and wipe any salt residue

away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get

into the container during the wash program (this could damage the

water softener beyond repair).

Whenever you need to add salt, it is mandatory to complete the

procedure before the beginning of the washing cycle.

SETTING THE WATER HARDNESS

To allow the water softener to work in a perfect way, it is essential that

the water hardness setting is based on the actual water hardness in

your house. This information can be obtained from your local water

supplier.

The factory setting is for avarage (3) water hardness.

•SwitchontheappliancebypressingtheON/OFF button.

•SwitchotheappliancebypressingtheON/OFF button.

•HolddownbuttonSTART/PAUSE for 5 seconds, until you hear a beep.

•SwitchontheappliancebypressingtheON/OFF button.

•Thesaltindicatorlightashes(asmanytimesasthecurrentselection).

•SetthePROGRAM SELECTION knob to the desired hardness level

number (see WATER HARDNESS TABLE).

•SwitchotheappliancebypressingtheON/OFFbutton.

Setting is complete!

As soon as this procedure is complete, run a program without loading.

Only use salt that has been specically designed for dishwashers.

After the salt has been poured into the machine, the SALT REFILL indi-

cator light switches o.

If the salt container is not lled, the water softener and the

heating element may be damaged as a result.

Water Hardness Table

Level °dH

German degrees

°fH

French degrees

1 Soft 0 - 6 0 - 10

2 Medium 7 - 11 11 - 20

3 Average 12 - 17 21 - 30

4 Hard 18 - 34 31 - 60

5 Very hard 35 - 50 61 - 90

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid dispenser shouldA

be lled when the in the controlRINSE AID REFILL indicator light

panel is lit.

1. Open the dispenser by pressing and pulling up the tab on the lidB .

2. Pour in the rinse aid (max.110 ml), making sure it does not overow

from the dispenser. If this happens, clean the spill immediately with a

dry cloth.

3. Press the lid down until you hear a click to close it.

NEVER pour the rinse aid directly into the appliance tub.

ADJUSTING THE DOSAGE OF RINSE AID

If you are not completely satised with the drying results, you can ad-

just the quantity of rinse aid used.

•SwitchthedishwasheronusingtheON/OFF button.

•SwitchitousingtheON/OFF button.

•PressbuttonSTART/PAUSE three times - a beep will be heard.

•SwitchitonusingtheON/OFF button.

•Therinse-aidindicatorlightwillash(as many times as the current se-

lection).

•SetthePROGRAM SELECTION knob to the level number of rinse aid

quantity to be supplied.

• Switch it o using the buttonON/OFF

Setting is complete!

If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied. The

LOW RINSE AID indicator light will not be lit if you run out of rinse aid.

A maximum of 5 levels can be set according to the dishwasher model. The

factory setting is specic to the model, please follow instruction above

to check this for your machine.

• If you see bluish streaks on the dishes, set a low number (1-2).

• If there are drops of water or limescale marks on the dishes, set a

mid-range number (3-4).

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser

use the opening device A. Introduce

the detergent into the dry dispenser

B only. Place the amount of

detergent for pre-washing directly

inside the tub.

1. When measuring out the detergent re-

fer to the mentioned earlier information

to add the proper quantity. Inside the

dispenser B there are indications to help

the detergent dosing.

2. Remove detergent residues from the edges of the dispenser and

close the cover until it clicks.

3. Close the lid of the detergent dispenser by pulling it up until the

closing device is secured in place.

The detergent dispenser automatically opens up at the right time

according to the program.

Produkt Specifikationer

Mærke:	Indesit
Kategori:	Opvaskemaskine
Model:	DFP 27B+96 Z
Vekselstrømsindgangsspænding:	220 - 240 V
Vekselstrømsindgangsfrekvens:	50 Hz
Bredde:	600 mm
Dybde:	600 mm
Højde:	850 mm
Vægt:	47000 g
Kontroltype:	Buttons, Rotary
Indbygget skærm:	Ingen
Ledningslængde:	1.28 m
Pakkevægt:	49000 g
Pakkedybde:	675 mm
Pakkebredde:	625 mm
Pakkehøjde:	910 mm
Energieffektivitetsklasse (gammel):	A++
Årligt energiforbrug:	265 kWh
Placering af apparat:	Fritstående
Støjniveau:	46 dB
Tilløbsslange, længde:	150 m
Antal vaskeprogrammer:	7
Forsinket start-timer:	Ja
Dør farve:	Hvid
Balje materiale:	Rustfrit stål
Vaskeklasse:	A
Vandforbrug pr. cyklus:	9 L
Farve på kontrolpanel:	Hvid
Antal kuverter:	14 kuverter
Cyklustid:	- min.
Forsinket start (maks.):	9 t
Opvaskeprogrammer:	Eco, Intensive, Normal, Pre-wash, Quick
Halv belastning:	Ja
Tørringsklasse:	A
Årligt vandforbrug:	2520 L
Indikator for afspændingsmiddel:	Ja
Energiforbrug pr. cyklus:	0.9 kWh
Udøsslange længde:	155 m
Produktstørrelse:	Fuld størrelse (60 cm)
Vandpåfyldning:	Cold, Hot
Saltindikator:	Ja
Øverste kurv indstillelig højde:	Ja