Indesit IN2FE14CNP80 Manual

Indesit Opvaskemaskine IN2FE14CNP80

Læs gratis den danske manual til Indesit IN2FE14CNP80 (16 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 42 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 21.5 anmeldelser. Har du et spørgsmål om Indesit IN2FE14CNP80, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
EN
1
DAILY REFERENCE
GUIDE
1. On-O/Reset button with indicator light
2. Push & Go button with indicator light
3. Salt rell indicator light
4. Program selection knob
5. Delay indicator lights
6. Delay button with indicator light
7. Start/Pause button with indicator light / Drain out
1 2 3 46 7
5
CONTROL PANEL
APPLIANCE
1. Upper rack
2. Foldable aps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
0000 000 00000
Service:
1
2
3
4
5
6
10
12
7
11
9
8
PRODUCT DESCRIPTION
THANK YOU FOR BUYING AN INDESIT PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.indesit.com/register
PLEASE SCAN THE
QR CODE ON YOUR
APPLIANCE IN
ORDER TO HAVE
MORE DETAILED
INFORMATION
Before using the appliance carefully read Safety and Installation Instructions.
After installation, please remember to remove all transport protection parts from
the dishwasher.
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes
and on the machine’s functional components.
• It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be lled when the SALT REFILL
indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the rst time you do this: ll the salt
reservoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can
get into the container during the wash program (this could damage
the water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the
procedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in your
house. This information can be obtained from your local water supplier.
The factory sets the default value for the water hardness
• Switch on the appliance by pressing the button.ON/OFF
• Switch o the appliance by pressing the button.ON/OFF
• Hold down button START/Pause for 5 seconds.
• Switch on the appliance by pressing the button.ON/OFF
• The ON/OFF LED light will ash as many times as the level that was set.
• Set the desired water hardness level using the PROGRAM SELECTION
knob (see WATER HARDNESS TABLE).
• Switch o the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL
indicator light switches o.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
Water Hardness Table
Level
°dH
German
degrees
°fH
French
degrees
°Clark
English
degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser should be A
lled when when the dark optical indicator on the dispenser door C
becomes transparent.
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can
adjust the quantity of rinse aid used.
• Switch the dishwasher on using the button.ON/OFF
• Switch it o using the button.ON/OFF
• Press button START/Pause three times.
• Switch it on using the button.ON/OFF
• The START/Pause LED light will ash as many times as the level that
was set.
• Set the level of rinse aid quantity to be supplied using the PROGRAM
SELECTION knob (see PROGRAMS TABLE).
• Switch it o using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (2-3).
• If there are drops of water or limescale marks on the dishes,
set a mid-range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device D.
Introduce the detergent into the dry dispenser E only. Place
the amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier
information to add the proper
quantity. Inside the dispenser
E there are indications to help
the detergent dosing.
2. Remove detergent residues
from the edges of the dispenser
and close the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until
the closing device is secured
in place.
The detergent dispenser automatically opens up at the right time
according to the program.
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
A
B
C
D
E

Produkt Specifikationer

Mærke: Indesit
Kategori: Opvaskemaskine
Model: IN2FE14CNP80

Har du brug for hjælp?

Hvis du har brug for hjælp til Indesit IN2FE14CNP80 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Opvaskemaskine Indesit Manualer

Indesit

Indesit IN2IKE107 Manual

18 Juni 2025
Indesit

Indesit IN2IE14CNP80 Manual

10 Juni 2025
Indesit

Indesit IN2FE14CNP80 Manual

20 Februar 2025
Indesit

Indesit IN2IE14DNP80 Manual

24 Januar 2025
Indesit

Indesit idl 600 Manual

15 Januar 2025
Indesit

Indesit idl 410 fr c Manual

15 Januar 2025
Indesit

Indesit ID3I D741O Manual

14 Januar 2025
Indesit

Indesit D2F HK26 S Manual

30 December 2025
Indesit

Indesit UNODUE Manual

11 Oktober 2024
Indesit

Indesit DG 6445 W Manual

22 September 2024

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

AEG

AEG GG882VIPC Manual

31 Juli 2025
AEG

AEG FUS6491CZM Manual

31 Juli 2025
AEG

AEG FES6491XZM Manual

31 Juli 2025
AEG

AEG FSK64627P Manual

31 Juli 2025
AEG

AEG FSB6491CZ Manual

31 Juli 2025
AEG

AEG FSE73427P Manual

31 Juli 2025
AEG

AEG FES7671XPM Manual

31 Juli 2025
AEG

AEG FSK53607Z Manual

31 Juli 2025
AEG

AEG GS649EXTI Manual

31 Juli 2025
Asko

Asko DWC67423BIW Manual

30 Juli 2025