Indesit THP 641 IX/I Manual

Indesit Komfur THP 641 IX/I

Læs gratis den danske manual til Indesit THP 641 IX/I (32 sider) i kategorien Komfur. Denne vejledning er vurderet som hjælpsom af 53 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 27 anmeldelser. Har du et spørgsmål om Indesit THP 641 IX/I, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/32

SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED

These instructions are valid if the country symbol

appears on the appliance. If the symbol doesn’t appear on

the appliance, it is necessary to refer to the technical

instructions which will provide the necessary instructions

concerning modification of the appliance to the conditions

of use of the country.

CAUTION: The use of the gas cooking appliance results

in the production of heat, moisture and products of

combustion in the room in which it is installed. Ensure that

the kitchen is well ventilated especially when the appliance

is in use: keep natural ventilation holes open or install a

mechanical ventilation device (mechanical extractor

hood). Prolonged intensive use of the appliance may call

for additional ventilation, such as opening a window, or

more effective ventilation, for example increasing the level

of mechanical ventilation (if possible).

Failure to follow the information in this manual exactly

may cause a fire or explosion, resulting in property damage

or personal injury.

Before using the appliance, read these safety instructions.

Keep them nearby for future reference.

These instructions and the appliance itself provide

important safety warnings, to be observed at all times. The

manufacturer declines any liability for failure to observe

these safety instructions, for inappropriate use of the

appliance or incorrect setting of controls.

WARNING: If the hob surface is cracked, don’t use the

appliance – risk of electrical shock.

WARNING: Danger of fire: Do not store items on the

cooking surfaces.

CAUTION: The cooking process has to be supervised. A

short cooking process has to be supervised continuously.

WARNING: Unattended cooking on a hob with fat or oil

can be dangerous – risk of fire. NEVER try to extinguish a

fire with water, but switch off the appliance and then cover

flame e.g. with a lid or a fire blanket.

Do not use the hob as a work surface or support. Keep

clothes or other flammable materials away from the

appliance, until all the components have cooled down

completely – risk of fire.

Very young children (0-3 years) should be kept away

from the appliance. Young children (3-8 years) should be

kept away from the appliance unless continuously

supervised. Children from 8 years old and above and

persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge can use

this appliance only if they are supervised or have been

given instructions on safe use and understand the hazards

involved. Children must not play with the appliance.

Cleaning and user maintenance must not be carried out

by children without supervision.

CAUTION: In case of hotplate glass breakage: shut

immediately off all burners and any electrical heating

element and isolate the appliance from the power supply;

do not touch the appliance surface; do not use the

appliance.

The glass lid can break in if it is heated up. Turn off all the

burners and the electric plates before closing the lid. Do

not shout down lid when burner alight.

WARNING: The appliance and its accessible parts

become hot during use. Care should be taken to avoid

touching heating elements. Children less than 8 years of

age must be kept away unless continuously supervised.

The food must not be left in or on the product for more

than one hour before or after cooking.

PERMITTED USE

CAUTION: the appliance is not intended to be operated

by means of an external switching device, such as a timer,

or separate remote controlled system.

This appliance is intended to be used in household and

similar applications such as: staff kitchen areas in shops,

offices and other working environments; farm houses; by

clients in hotels, motels, bed & breakfast and other

residential environments.

No other use is permitted (e.g. heating rooms).

This appliance is not for professional use. Do not use

the appliance outdoors.

Use pots and pans with bottoms the same width as

that of the burners or slightly larger (see specific table).

Make sure pots on the grates do not protrude beyond the

edge of the hob.

Improper use of the grids can result in damage to the

hob: do not position the grids upside down or slide them

across the hob.

Do not let the burner flame extend beyond the edge of the pan.

If the hob surface is in glass material, do not use the cast iron griddles, ollar stones,

terracotta pots and pans.

Do not use: heat diffusers such as metal mesh, or any other types; two burners

simultaneously for one receptacle (e.g. Fish kettle).

Should particular local conditions of the delivered gas make the ignition of burner

difficult, it is advisable to repeat the operation with the knob turned to small flame

setting.

In case of installation of a hood above the cooktop, please refer to the hood

instructions for the correct distance.

The protective rubber feet on the grids represent a choking hazard for young

children. After removing the grids, please ensure that all the feet are correctly fitted.

INSTALLATION

The appliance must be handled and installed by two or

more persons - risk of injury. Use protective gloves to

unpack and install - risk of cuts.

The electrical and gas connections must comply with

local regulation.

Installation, including water supply (if any) and electrical

connections, and repairs must be carried out by a qualified

technician. Do not repair or replace any part of the

appliance unless specifically stated in the user manual.

Keep children away from the installation site. After

unpacking the appliance, make sure that it has not been

damaged during transport. In the event of problems,

contact the dealer or your nearest After-sales Service.

Once installed, packaging waste (plastic, styrofoam parts

etc.) must be stored out of reach of children - risk of

suffocation. The appliance must be disconnected from

the power supply before any installation operation - risk of

electrical shock. During installation, make sure the

appliance does not damage the power cable - risk of fire or

electrical shock. Only activate the appliance when the

installation has been completed.

WARNING: Modification of the appliance and its

method of installation are essential in order to use the

appliance safely and correctly in all the additional countries.

Use pressure regulators suitable for the gas pressure

indicated in the instruction.

The room must be equipped with an air extraction

system that expels any combustion fumes.

The room must also allow proper air circulation, as air is

needed for combustion to occur normally. The flow of air

must not be less than 2 m

3/h per kW of installed power.

The air circulation system may take air directly from the

outside by means of a pipe with an inner cross section of

at least 100cm2; the opening must not be vulnerable to

any type of blockages.

The system can also provide the air needed for

combustion indirectly, i.e. from adjacent rooms fitted with

air circulation tubes as described above. However, these

rooms must not be communal rooms, bedrooms or

rooms that may present a fire hazard.

Liquid petroleum gas sinks to the floor as it is heavier

than air. Therefore, rooms containing LPG cylinders must

also be equipped with vents to allow gas to escape in the

event of a leak. As a result LPG cylinders, whether partially

or completely full, must not be installed or stored in rooms

or storage areas that are below ground level (cellars, etc.).

It is advisable to keep only the cylinder being used in the

room, positioned so that it is not subject to heat produced

by external sources (ovens, fireplaces, stoves, etc. ) which

could raise the temperature of the cylinder above 50°C.

Should you experience difficulty in turning the burners knobs, please contact After

Sales Service for replacement of the burner tap if found to be faulty.

The openings used for the ventilation and dispersion of heat must never be covered.

Carry out all cabinet cutting works before fitting the

appliance in the furniture and remove all wood chips and

sawdust.

If the appliance is not installed above an oven, a

separator panel (not included) must be installed in the

compartment under the appliance.

GAS CONNECTION

WARNING: Prior to installation, ensure that the local

distribution conditions (type of gas and gas pressure) and

the adjustment of the appliance are compatible.

Check that the pressure of the gas supply is consistent

with the values indicated in “Burner and nozzle

specifications” table.

WARNING: The configuration conditions for this

appliance are stated on the label (or data plate).

WARNING: This appliance is not connected to a

combustion products evacuation device. It must be

installed and connected in accordance with current

installation regulations. Particular attention must be paid

to the relevant requirements regarding ventilation.

If the appliances is connected to liquid gas, the

regulation screw must be fasted as tightly as possible.

IMPORTANT: When the gas cylinder or gas container is

installed, it must be properly settled (vertical orientation).

WARNING: This operation must be performed by a

qualified technician.

Use only flexible or rigid metal hose for gas connection.

Connection with a rigid pipe (copper or steel)

Connection to the gas system must be carried out in such

a way as not to place any strain of any kind on the appliance.

There is an adjustable L-shaped pipe fitting on the

appliance supply ramp and this is fitted with a seal in order

to prevent leaks. The seal must always be replaced after

rotating the pipe fitting (the seal is provided with the

appliance). The gas supply pipe fitting is a threaded 1/2

gas cylindrical male attachment.

Connecting a flexible jointless stainless steel pipe to a

threaded attachment. The gas supply pipe fitting is a

threaded 1/2 gas cylindrical male attachment. These pipes

must be installed so that they are never longer than 2000

mm when fully extended. Once connection has been

carried out, make sure that the flexible metal pipe does

not touch any moving parts and is not compressed. Only

use pipes and seals that comply with current National

regulations.

IMPORTANT: If a stainless steel hose is used, it must be

installed so as not touch any mobile part of the furniture

(e.g. drawer). It must pass through an area where there are

no obstructions and where it is possible to inspect it on all

its length.

The appliance should be connected to the main gas

supply or to gas cylinder in compliance with the current

national regulations. Before making the connection, make

sure that the appliance is compatible with the gas supply

you wish to use. If this is not the case, follow the instructions

indicated in the paragraph “Adapting to different types of

gas”.

After connection to the gas supply, check for leaks with

soapy water. Light up the burners and turn the knobs

from maximum position 1* to minimum position 2* to

check flame stability.

ADAPTING TO DIFFERENT TYPES OF GAS

(This operation needs to be carried out by a qualified

technician).

In order to adapt the appliance to a type of gas other

than the type for which it was manufactured (indicated on

the rating label), follow the dedicated steps provided after

installation drawings.

ELECTRICAL WARNINGS

IMPORTANT: Information about current and voltage

consumption is provided on the rating plate.

It must be possible to disconnect the appliance from

the power supply by unplugging it if plug is accessible, or

by a multi-pole switch installed upstream of the socket in

accordance with the wiring rules and the appliance must

be earthed in conformity with national electrical safety

standards.

Produkt Specifikationer

Mærke:	Indesit
Kategori:	Komfur
Model:	THP 641 IX/I
Vekselstrømsindgangsspænding:	220 - 240 V
Vekselstrømsindgangsfrekvens:	50-60 Hz
Bredde:	580 mm
Dybde:	510 mm
Højde:	56 mm
Vægt:	10300 g
Produktfarve:	Rustfrit stål
Kontroltype:	Dreje
Indbygget skærm:	Ingen
Ledningslængde:	1 m
Timer:	Ingen
Placering af apparat:	Indbygget
Installationsrum bredde:	555 mm
Installationsrum dybde:	575 mm
Farve på kontrolpanel:	Rustfrit stål
Komfurtype:	Gaskomfur
Overfladetype:	Rustfrit stål
Antal kogeplader / madlavningsområde:	4
Kogezone 1 form:	Rund
Blus/kogeplade zone 1 strømkilde:	Gas
Kogezone 2 form:	Rund
Blus/kogeplade zone 2 strømkilde:	Gas
Kontrolposition:	Top forside
Tilsluttet belastning (elektrisk):	- W
Ovnbredde størrelse:	58 cm
Blus/kogeplade zone 4 strømkilde:	Gas
Kogezone 4 form:	Rund
Blus/kogeplade zone 3 strømkilde:	Gas
Kogezone 3 form:	Rund
Indbygget hætte:	Ingen
Tilsluttet belastning (gas):	- W
Antal gasbrændere:	4
Elektronisk tænding:	Ja
Sensorkog:	4
Understøttet grydemateriale:	Støbejern
Elektronisk antændelsestype:	Enhåndstænding