User Guide for NUC7i3DNHNC
2
Before You Begin
CAUTIONS
The steps in this guide sume familiar with computer terminology with tas you’re and he
safety practices a regulatory compliance required for using and modifying computer nd
equipment.
Disconnect the computer from its power so ce and from any netwo before performi any of ur rk ng
the steps described in this guide.
Failure to disconnect power or orks before you open the computer or perform procedures netw any
can result in personal injury or equipment damage. Some circuitry on the board can continue and/
to ttoperate even though the front panel power bu on is f.of
Follow these guidelines before you begin:
Always follow the steps in each procedure in the correct order.
Create a log to record information about your computer, such as mo l, serial de
numbers installe tions, an, d op d conf at n informat igur io ion.
Electrostati ischarge (ESD) can damage components. rform the procedures c d Pe
describe in id th s ch te onl at an ESD workstat n ing an a tatic wr t strap and a ap r y io us ntis is
conductive foam pad. If such a stat n available, you io isn’t can provide some ESD
protection by wearing an antistatic wrist strap and attaching to a metal part of the it
computer chassis.
Installation Precautions
When you inst an test the I el NUC, observe l warning an caut ns in the installat n all d nt al s d io io
instruct ns. io
To avoid injury, be careful of:
Sharp pins on connecto rs
Sharp pins circuit boards on
Rough edges and sharp corners on the chassis
Hot components (such as SSDs, processors, voltage regulators, a heat sinks) nd
Damage wires that could cause a short circuit to
Observe Safety and Regulatory Requirements
If you f w don’t ollo these instruct ns, you increase your safety risk and the possibility of io
noncom iance wipl th regional laws and regul ions. at