JANDY Stain Remover Manual

JANDY Ikke kategoriseret Stain Remover

Læs gratis den danske manual til JANDY Stain Remover (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om JANDY Stain Remover, eller vil du spørge andre brugere om produktet?

Side 1/2
1. Attach Stain Remover
applicator head to pool pole.
2. Place rubber band around
lower of bottle (see picture).
Screw vent cap on gallon
container of diluted muriatic
acid (5:1 recommended). Use
chlorine for organic stains.
4. Submerge vinyl hose tubing
and applicator in pool, stretching
tube out all the way to remove
coils.
3. Place acid container on edge
of pool at deep end. Carry
applicator and pole to opposite
side of pool.
INSTRUCTIONS FOR USING JANDY STAIN REMOVER
Muriatic acid, or similar strong chemicals, can cause
bleaching or damage to pool surfaces. Do not hold Stain
Remover over stains for longer than 10 seconds at a time.
Keep Stain Remover moving. Do not allow more than
one (1) pint of chemical to enter pool in any one Stain
Remover session (usually not more than 1-3 minutes of
use). If multiple sessions are required, wait 3 days and
repeat. NOTE: Check pool chemistry before using Stain
Remover and after, then adjust chemistry accordingly.
STAIN REMOVER USER
CAUTION
Special Applications:
For rust and other stains use muriatic acid. For algae use liquid algaecides or
chlorine. Contact your pool dealer for additional information.
CAUTION: Muriatic acid is not recommended for vinyl lined swimming
pools. Substitute with liquid algaecides or chlorine.
KEEP OUT OF REACH OF CHILDREN. READ LABEL ON ACID
CONTAINER AND WARNING ON STAIN REMOVER. CAN CAUSE
SERIOUS INJURY OR DEATH.
WARNING:


Produkt Specifikationer

Mærke: JANDY
Kategori: Ikke kategoriseret
Model: Stain Remover

Har du brug for hjælp?

Hvis du har brug for hjælp til JANDY Stain Remover stil et spørgsmål nedenfor, og andre brugere vil svare dig