Kenwood Excelon CA-POD14AC Manual
Kenwood
Ikke kategoriseret
Excelon CA-POD14AC
Læs gratis den danske manual til Kenwood Excelon CA-POD14AC (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Kenwood Excelon CA-POD14AC, eller vil du spørge andre brugere om produktet?
Side 1/4
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best performance from your new product.
© 2023 JVCKENWOOD Corporation
CA-POD14AC
6.5” AIR COOLED LOWER FAIRING SPEAKER ADAPTORS DESIGNED
AND ENGINEERED FOR 2014+ HARLEY-DAVIDSON® TOURING
MODEL MOTORCYCLES WITH OE OR AFTERMARKET AIR COOLED
LOWERS
INSTRUCTION MANUAL
JVCKENWOOD Corporation
2
6.5” Air Cooled Lower Fairing Speaker Adaptors Installation
Figure 1.1
Installation procedure
1. Remove the outer fairing/headlamp assembly (a towel on the front fender can help
prevent scratches or “dings” from dropped tools or fasteners etc.). Refer to a service manual
if you need help with this.
NOTE: The CA-POD14AC lower adaptors are MUCH easier to install with the lower fairings
OFF the bike. The next steps assume the lower fairings are OFF the bike, so please remove
them before proceeding.
2. When the lower fairings came o the bike, there was a painted “cap” that came o that
exposed the fasteners that hold the top of the lower to the upper crash bar. Looking into
the lower fairing from the area that was covered by the cap, you will see 3 screws that
hold the front panel to the lower fairing. Remove these 3 screws and undo the “slider arm”
from the vent so the front panel with the slider arm can come o the lower fairing. The 3
screws just removed will be re-used.
3. Depending on the lower fairings you have, if you have a “pocket” attached to the back
side of the front panel, it will need to be removed to gain access to the fastener that holds
the vent adjuster “handle” in place. With this pocket removed, undo the fastener that
secures the “handle” and put the handle aside for now.
5. Locate the wire harness that came with the CA-POD14AC kit. You will see this harness
has one longer 4-wire section that splits into two 2-wire sections. Each 2-wire section is
labeled “clutch side” or “brake side”. Take the appropriate short section and put it in the
correct side’s lower fairing so the speaker connectors are inside. Leave these loose for now.
6. Install the “vent adjuster handles” with arms into each lower speaker adaptor. Bring
the speaker adaptors to the lower fairing and put the speaker wires through the square
opening so they go into the speaker’s enclosure. With the wires in place, attach the arm
back into the vent. The speaker adaptor will now sit in place on the lower fairing. Using
the 3 screws removed earlier, secure the speaker adaptor to the lower fairing.
4. Using Fig 1.1 for reference, drill a 3/8"
(10mm) hole in the area highlighted by the
white circle into each lower to allow the
speaker wires to go in.
NOTE: Starting with a smaller drill bit and
working your way up to the full size is a good
idea. “Step bits” also work great for this. Make
sure to clean up any plastic “burrs” so they
don’t cut the speaker wires over time.
Produkt Specifikationer
| Mærke: | Kenwood |
| Kategori: | Ikke kategoriseret |
| Model: | Excelon CA-POD14AC |
Har du brug for hjælp?
Hvis du har brug for hjælp til Kenwood Excelon CA-POD14AC stil et spørgsmål nedenfor, og andre brugere vil svare dig
Ikke kategoriseret Kenwood Manualer
25 Marts 2025
24 Marts 2025
24 Marts 2025
24 Marts 2025
24 Marts 2025
24 Marts 2025
18 Marts 2025
22 Februar 2025
22 Februar 2025
22 Februar 2025
Ikke kategoriseret Manualer
- Cotech
- Bals
- SatKing
- Liteline
- B-Speech
- Gazelle
- Eligent
- Expobar
- Samsung
- OBH Nordica
- DiO
- AudioQuest
- Rotel
- Lanzar
- Berner
Nyeste Ikke kategoriseret Manualer
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025
20 Juni 2025