Kenwood Excelon CA-POD14LC Manual

Kenwood Ikke kategoriseret Excelon CA-POD14LC

Læs gratis den danske manual til Kenwood Excelon CA-POD14LC (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Kenwood Excelon CA-POD14LC, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Take the time to read through this instruction manual.

Familiarity with installation and operation procedures will help you obtain the best performance from your new product.

CA-POD14LC

6.5” LIQUID COOLED LOWER FAIRING SPEAKER ADAPTORS

DESIGNED AND ENGINEERED FOR 2014+ HARLEY-DAVIDSON®

TOURING MODEL MOTORCYCLES WITH LIQUID COOLED HEADS

INSTRUCTION MANUAL

JVCKENWOOD Corporation

6.5” Liquid Cooled Lower Fairing Speaker Adaptors Installation

Figure 1.1

Installation procedure

1. Remove the seat and both wires (+ and -) from the battery.

2. Remove the outer fairing/headlamp assembly (a towel on the front fender can help

prevent scratches or “dings” from dropped tools or fasteners etc.). Refer to a service manual

if you need help with this.

3. Starting on the brake side lower fairing, use a coin or something similar to carefully pry

o the front access cover. With the cover removed, look inside the opening and at the

very back, you will see a 7/16” nut needs to be removed. This nut allows the painted fairing

lower “cap” on the front to come off. With the painted cap off, you will see a “bar” that

secures the top half of the lower to the crash bar. Remove the 2 nuts and the bar and put

them aside for now. At the bottom of the lower is a clamp that holds the bottom half of

the lower to the crash bar. Remove the bolt that secures the clamp.

4. Gently push the top of the lower towards the back of the bike just enough so you can

remove the 3 Torx screws (normally hidden by the painted cap) that hold the lowers front

panel in place. Gently pull on the front panel to release 2 clips which will allow the front

panel to come away, but not completely free from the bike yet. There is a small arm for the

vent mechanism still attached that is removed by squeezing the top of the pivot pin and

lifting up on the arm. You can now bring the factory lower front panel to a workbench

and remove the Torx screw that holds the vent adjuster and arm to the factory panel.

Using the same screw, install the vent adjuster and arm into your new speaker adaptor.

6. Moving to the front side of the lower fairing, in the area normally hidden by the painted

cap you will see a hole where the bolt passes through that secures the painted cap. Just

above that hole and approximately 2” back from the bolt hole, you will need to drill a 3/8”

hole for the wires to pass. When this installation is nished, the painted cap will hide the

wire nicely.

NOTE: It’s a good idea to start with a pilot hole and then drill the nal size. Use care to

make sure your drill bit does not pierce the radiator’s coolant tank inside the lower on the

brake side!

5. The kit comes with die-cut foam panels.

Find the one for the side of the bike you are

working on and apply it as shown, noting you

should clean the area with isopropyl alcohol

rst. On your factory front panel, you will see

2 white clips. One of these clips will come

off and be installed onto the new speaker

adaptor. See Fig. 1.1

Produkt Specifikationer

Mærke:	Kenwood
Kategori:	Ikke kategoriseret
Model:	Excelon CA-POD14LC

Har du brug for hjælp?

Hvis du har brug for hjælp til Kenwood Excelon CA-POD14LC stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Kenwood Manualer

Kenwood Abbey Lux ZJP05 Manual

5 Oktober 2025

Kenwood Mesmerine TFM810 Manual

4 Oktober 2025

Kenwood Elegancy ZJP11 Manual

4 Oktober 2025

Kenwood Abbey Lux TCP05 Manual

3 Oktober 2025

Kenwood NXR-1700-E Manual

27 August 2025

Kenwood AT550 Manual

7 August 2025

Kenwood Chef Sense KVC5001Y Manual

14 Juli 2025

Kenwood KNB-L1 Manual

9 Juli 2025

Kenwood KNB-63L Manual

9 Juli 2025

Kenwood KNB-70LEX Manual

9 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

GBC W12 Manual

14 Oktober 2025

Fuxtec FX-CT100 Manual

13 Oktober 2025

Scotsman Prodigy Plus NH0422 Manual

13 Oktober 2025

Chief FCA800HS Manual

13 Oktober 2025

Chief OLCM1U Manual

13 Oktober 2025

IPEGA PG-P5V002 Manual

13 Oktober 2025

IPEGA PG-P5013 Manual

13 Oktober 2025

IPEGA PG-SW2210 Manual

13 Oktober 2025

IPEGA PG-P5042 Manual

13 Oktober 2025

Scotsman Prodigy Plus NH0922 Manual

13 Oktober 2025