Kenwood KRK-15B Manual


Læs gratis den danske manual til Kenwood KRK-15B (25 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Kenwood KRK-15B, eller vil du spørge andre brugere om produktet?

Side 1/25
CABLE
SIMPLE GUIDE
PRECAUTIONS
The following product is exclusively for use with transceivers.KENWOOD
To prevent possible accidents and damages, do not attempt to use this product with
other types of transceivers.
ABOUT PRODUCT
USB PROGRAMMING INTERFACE CABLE
This product is the cable to connect transceivers and the PC.KENWOOD
Install the UART driver or USB driver from the supplied CD to the PC.
PROGRAMMING INTERFACE CABLE
This product is the cable to connect transceivers and the PC.KENWOOD
FILTERED CIGARETTE LIGHTER CORD
The cigarette lighter cable allows you to supply power to your transceiver
from the cigarette lighter of your automobile.
The cigarette lighter cable is equipped with a 2 A fuse. When the fuse
blows, replace it with a fuse of the same rating.
To cigarette
lighter socket To transceiver
3.4 mm
Fuse (2A)
CAUTION:
12 V DC ONLY
Serious damage may result to your transceiver if this cable is connected to a voltage
source greater than 16 V. Some vehicles have battery voltages of 24 V or greater.
REMOTE CONTROL KIT
These products are the connection cable kits for installing the operation
panel of KENWOOD mobile transceivers separately.
B5A-1082-00
© 2015
CÂBLE
GUIDE SIMPLE
PRÉCAUTIONS
Le produit suivant doit uniquement être utilisé avec les émetteurs-récepteurs
KENWOOD.
Pour éviter tout dommages et accidents potentiels, n'essayez pas d'utiliser ce produit
avec d'autres types d'émetteurs-récepteurs.
À PROPOS DU PRODUIT
CÂBLE D'INTERFACE DE PROGRAMMATION USB
Ce produit est un câble permettant de connecter les émetteurs-récepteurs
KENWOOD aux ordinateurs.
Installez le pilote UART ou le pilote USB sur l'ordinateur à partir du CD fourni.
CÂBLE D'INTERFACE DE PROGRAMMATION
Ce produit est un câble permettant de connecter les émetteurs-récepteurs
KENWOOD aux ordinateurs.
CORDON ALLUME-CIGARES
Le cordon allume-cigares vous permet d'alimenter votre émetteur-récepteur
à partir de l'allume-cigare de votre voiture.
Le cordon allume-cigare est muni d'un fusible 2 A. Quand le fusible grille,
remplacez-le avec un fusible de même valeur.
À la douille
allume-cigare À l'émetteur-récepteur
3,4 mm
Fusible (2A)
ATTENTION :
12 V CC UNIQUEMENT
L'émetteur-récepteur peut être endommagé si ce cordon est connecté à une source de
tension de plus 16 V. Certains véhicules ont une batterie d'une tension de 24 V ou plus.
KIT TÉLÉCOMMANDE
Ce produit est un kit de connexion permettant d'installer un panneau de
commande pour émetteur-récepteur séparé.KENWOOD
B5A-1082-00
© 2015


Produkt Specifikationer

Mærke: Kenwood
Kategori: Ikke kategoriseret
Model: KRK-15B

Har du brug for hjælp?

Hvis du har brug for hjælp til Kenwood KRK-15B stil et spørgsmål nedenfor, og andre brugere vil svare dig