La Crosse Technology 308-2414FR Manual


Læs gratis den danske manual til La Crosse Technology 308-2414FR (6 sider) i kategorien Vejrstation. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om La Crosse Technology 308-2414FR, eller vil du spørge andre brugere om produktet?

Side 1/6
Model: 308-2414FR www.lacrosseclock.com/support Page | 1
Model: 308 2414FR-
Instruction Manual
DC: 103015
LED ALARM WEATHER STATION
WITH IN/OUT TEMPERATURE
LED
Reset
Stand
Battery
Compartment
2 AAA batteries
TW004
Outdoor Sensor
BUTTONS
Note: This product display
temperature in Fahrenheit only.
KU1B- - 045 0200D
Stand Lock
Stand
(please attach
stand to station)
Model: 308-2414FR www.lacrosseclock.com/support Page | 2
WWVB Atomic Time Signal Search
After your clock is powered up, it searches for the Atomic time signal for
seven minutes icon flashes. . The
Note: During Atomic time signal search the buttons will not function, . The
LED will change to low brightness and will return to high brightness after
the Atomic time search . search
Receiving Atomic signal ( icon flashing)
Successful Reception ( icon becomes static)
s Failed Reception ( icon disappear )
H es old / WAVE button until your clock giv a short beep to stop or start
the Atomic time . signal reception
During the search, press button once to show reception mode / WAVE
and signal strength Indication:-
When a strong signal is detected, display shows with 3 bars
During reception, the signal strength may move from 1 bar to 2 bars
to 3 bars. This is normal since the clock is detecting Atomic time
signal and other signals in the air at the same time.
Press SET will return to the time display with icon flashing.
For information about WWVB Atomic time visit:
www.nist.gov/pml/div688/grp40/wwvb.cfm
G et Started
Step 1: Insert the AC/DC adaptor to an outlet, then into the back
of the clock.
Step 2 (Optional): Insert 1 x CR2032 Lithium battery (not
included) to the battery compartment on the back of the
clock. The + side of the battery should face up.
Step 3: Slide open the battery cover at the back of the wireless
TW004 sensor, make sure the channel selector is set at
position 1 (top position), then insert 2 x AAA batteries (not
included) into the outdoor sensor. Observe the correct
polarity.
Step 4: Peel off the protective label on the front.
Restart: If the outdoor temperature is not displayed after 3
minutes, remove AC power and weather stationbatteries from the
& outdoor sensor. Press any button on the temperature tation s 20
times. After 5 minutes, return to Step 1 above.


Produkt Specifikationer

Mærke: La Crosse Technology
Kategori: Vejrstation
Model: 308-2414FR

Har du brug for hjælp?

Hvis du har brug for hjælp til La Crosse Technology 308-2414FR stil et spørgsmål nedenfor, og andre brugere vil svare dig