La Crosse Technology LTV-WR1 Manual
Læs nedenfor 📖 manual på dansk for La Crosse Technology LTV-WR1 (4 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 38 personer og blev bedømt med 4.1 stjerner i gennemsnit af 19.5 brugere
Side 1/4
Model: LTV-WR1
DC: 083117
Multi-sensor
Wind Direction | Wind Speed | Rain
RESET
Drain vents for rain
sensor
Reset
button
Red LED
Light
Drain holes for
multi sensor
Rain funnel
(collector)
Wind
cups
Batteries
3-AA
Directional
Vane
Features
• Wind direction
• Wind speed
• Rainfall
• Solar Panel for extended
battery life
• Replaceable directional vane
• Replaceable wind cups
• Self-emptying rain sensor
Power
1- Insert 3-AA batteries
according to polarity.
2- The red LED light will flash
while transmitting.
Note: The solar panel will
extend the life of the batteries
but the sensor cannot operate
on solar power alone.
Mounting
• Mount in an open area clear for 50 feet in all directions.
• Mount with the solar panel facing south, so the wind direction is
correct. See the letters N, S, E W, embossed on the top of the sensor.
• Use the bubble level on the top of the sensor to ensure it is level, for
accurate rainfall readings.
• The maximum wireless transmission range to the station is over 400
feet (121 meters) in open air, not including walls or trees.
• Cups should be on the top of the sensor.
• Attach to mounting surface with screws through the mounting bracket.
• The sensor can be mounted from the bottom or from the side.
Alternatively:
• Insert your own mounting pole into the sensor base.
• Tighten screws
• Mounting bracket would not be used.
Bubble
Level
Replace Wind Cups
1. Loosen the screw on side of cups
2. Remove cups
3. Install new cups
4. Tighten screw on flat side of stem
Replace Directional Vane
1. Loosen the screw on side of vane
2. Remove direction vane
3. Install new vane
4. Tighten screw on flat side of stem
Clean Rain Sensor
1. Remove rain funnel (pull flat side firmly upward).
2. Gently remove debris or insects inside the rain sensor.
3. Clear debris from drain vents.
4. Clear debris from the rain funnel.
5. Reinstall the rain funnel.
Note: Do not oil the rain sensor.
Produkt Specifikationer
| Mærke: | La Crosse Technology |
| Kategori: | Ikke kategoriseret |
| Model: | LTV-WR1 |
Har du brug for hjælp?
Hvis du har brug for hjælp til La Crosse Technology LTV-WR1 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Ikke kategoriseret La Crosse Technology Manualer
23 September 2024
13 September 2024
10 September 2024
9 September 2024
7 September 2024
31 August 2024
31 August 2024
29 August 2024
28 August 2024
27 August 2024
Ikke kategoriseret Manualer
- Ikke kategoriseret WEICON
- Ikke kategoriseret ARRI
- Ikke kategoriseret Fuji
- Ikke kategoriseret Expressive E
- Ikke kategoriseret Reltech
- Ikke kategoriseret Prowork
- Ikke kategoriseret Ultimate Support
- Ikke kategoriseret Fein
- Ikke kategoriseret J5create
- Ikke kategoriseret Texas
- Ikke kategoriseret MQ
- Ikke kategoriseret Chuango
- Ikke kategoriseret Omega Altise
- Ikke kategoriseret ARC
- Ikke kategoriseret Speed-Link
Nyeste Ikke kategoriseret Manualer
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025