La Crosse Technology WS-6010U-IT Manual


Læs gratis den danske manual til La Crosse Technology WS-6010U-IT (9 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 5 anmeldelser. Har du et spørgsmål om La Crosse Technology WS-6010U-IT, eller vil du spørge andre brugere om produktet?

Side 1/9
1
Wall
mount
Solar
panel
Battery
compartment
with battery
switch inside
Model WS- -6010U IT
Solar Powered Wireless Humidity/Temperature Station
(Weather Station)
INSTRUCTION MANUAL
Model TX62UTH-IT/Solar-powered Transmitter (Sensor):
D toggles temperature and humidity readings LC
Transmits outdoor humidity/temperature to indoor receiver using 915
MHz signals
200 FT. wireless transmission range (open air)
Built-in rechargeable alkaline power cells store solar power for
continuous operation
No batteries necessary (internal power cells cannot be replaced;
contact customer service for a replacement sensor)
Able to charge in low light environments.
Solar panel
2
BATTERY
COMPARTMENT
INITIAL SETUP (USING INCLUDED SOLAR RECHARGEABLE BATTERIES FROM THE FACTORY)
1. Open battery compartment on the back of the Weather Station and make sure that the battery switch
under the battery compartment is to the left. If it is not, please slide the switch to the left before
proceeding.
2. Locate the battery insulator tab and gently pull to remove it.
3. Slide the battery switch to the SOLAR position.
4. Continue to section labeled " " ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER
ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER
Press the RESET key on the Sensor to activate the solar-powered transmitter and place it 5-10 feet
from the Weather Station for 15 minutes. The outdoor temperature will show on the weather station
within 60 seconds. Allow the sensor and the weather station to sit 5-10 feet apart for 15 minutes so the
signal can lock in repeatedly. Do not press buttons at this time.
NOTE: The solar panel needs light from a 60W light bulb or brighter during the activation process. Do not
cover solar panel with hands or other objects.
TX62UTH-IT transmitter RESET key:
NOTE: Do not use sharp objects to
press the RESET key. Use a small
dull pointed object or a straightened
paper clip and
gently press the
RESET key to commence NORMAL
MODE.
Several start up numbers will ash on
the screen of the sensor then the
temperature will display.
SWITCH RIGHT
(SOLAR OPERATION)
(SOLAR-RECHARGEABLE
BATTERIES)
Slide switch to RIGHT
position once solar-
rechargeable
batteries are inserted and
insulator tab is removed
WARNING
Do NOT recharge the
included solar-
rechargeable batteries
outside of this product
because it will damage
the batteries and other
charging devices.
SWITCH LEFT
(START-UP / RESET)
(STANDARD
ALKALINES)
Slide switch to LEFT
position before (1) start-
up / reset or (2) any type
of battery replacement


Produkt Specifikationer

Mærke: La Crosse Technology
Kategori: Ikke kategoriseret
Model: WS-6010U-IT

Har du brug for hjælp?

Hvis du har brug for hjælp til La Crosse Technology WS-6010U-IT stil et spørgsmål nedenfor, og andre brugere vil svare dig