La Crosse Technology WS 6826 Manual

La Crosse Technology Vejrstation WS 6826

Læs gratis den danske manual til La Crosse Technology WS 6826 (4 sider) i kategorien Vejrstation. Denne vejledning er vurderet som hjælpsom af 78 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 39.5 anmeldelser. Har du et spørgsmål om La Crosse Technology WS 6826, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

The Wireless Color Forecast Station features manual set time, date,

weather forecast, indoor and outdoor temperature/humidity, with

temperature alerts, and heat index and dew point, on a stylish, colorful,

and easy to read display. Use the integrated USB charging port to

charge your smartphone, camera or other device when the forecast

station operates on A/C power. Wireless transmission range of over 300

feet (90 meters) in open air, from transmitter to forecast station.

WIRELESS COLOR FORECAST STATION

THIS STATION LEARNS

Please allow 3-4 days for barometer calibration to generate an

accurate forecast.

SETUP INSTRUCTIONS STEP BY STEP

STEP 1:

• Insert the 5-volt A/C power adapter into the designated area on the

back of the forecast station.

• Plug the A/C power adapter into a wall outlet for continuous backlight

(ON/OFF), and dimmer feature.

STEP 2: (optional battery operation)

• Remove battery cover from the forecast

station: Slide tab down and pull out to remove the cover.

• Insert 3 NEW AAA batteries (not included) into the back of the

forecast station. Observe the correct polarity (see marking inside the

battery compartment).

• The forecast station will light up and show, indoor temperature,

humidity and time.

• (Press and release the HI/LOW/OFF button to illuminate the backlight

for 8 seconds when using only battery power.)

• Do Not Mix Old and New Batteries

• Do Not Mix Alkaline, Standard, Lithium or Rechargeable

Batteries

STEP 3:

• Ensure that the transmitter is within 10 feet of the forecast station.

• Remove battery cover from transmitter: Slide the battery cover down

and lift off the front.

• Insert 2 NEW AA batteries (not included) into the

transmitter. Observe the correct polarity.

• Within 3 minutes, the forecast station will show

readings in the Outdoor temperature area on the LCD.

Note: Use Alkaline batteries (or Lithium for temperatures

below - 20°F /-28.8°C).

TRANSMITTER SIGNAL STRENGTH

z After the batteries are inserted, the forecast station will search for the

outdoor temperature/humidity transmitter for 3 minutes.

z The antenna symbol will flash during reception, and temperature

display will be dashes “---“.

z The antenna symbol will scroll during transmitter synchronization.

z If synchronization fails once, the antenna will lose one bar.

z If synchronization fails twice, the antenna will lose two bars.

z If reception continuously fails to receive 5 times, the antenna symbol

will be shown as .

z The antenna will show full display with successful RF

(radio frequency) reception.

TROUBLESHOOTING

z If the outdoor temperature is not displayed after three

minutes, hold the SENSOR SEARCH button on the

forecast station for three seconds to search for

outdoor transmitter.

z Next, remove the battery cover from the transmitter then press the TX

button to send a signal.

z If it still does not receive the outdoor temperature, remove the A/C

cord and batteries from both the forecast station and the transmitter

for 15 minutes repeat setup instructions from step 1.

TIME/DATE

The SETTINGS button moves through the program menu

and confirm settings.

Use the UP ARROW button to increase a value.

Use the DOWN ARROW button to decrease a value.

SET TIME/DATE

Hold the SETTINGS button for three seconds to enter time set mode.

z LANGUAGE : The language will flash. Use the ARROW buttons to

select the language for weekday display (French, Italian, Dutch,

Spanish, Danish, English or German) and press the SETTINGS

button to confirm and move to 12/24 hour.

z 12/24-HOUR: The time format will flash. Use the ARROW buttons to

choose 12-hour or 24-hour time format and press the SETTINGS

button to confirm and move to hour.

z HOUR: The Hour will flash. Use the ARROW buttons to choose the

hour, and press the SETTINGS button to confirm and move to

minutes.

z MINUTES: The Minutes will flash. Use the ARROW buttons to

choose the minutes, and press the SETTINGS button to confirm and

move to the year.

z YEAR: The Year will flash. Use the ARROW buttons to choose the

year, and press the SETTINGS button to confirm and move to the

month.

z MONTH: The Month will flash. Use the ARROW buttons to choose

the month, and press the SETTINGS button to confirm and move to

the date.

z DATE: The Date will flash. Use the ARROW buttons to choose the

date, and press the SETTINGS button to confirm and move to

Fahrenheit/Celsius.

z FAHRENHEIT/CELSIUS: °F or °C will flash. Use the ARROW buttons

to select Fahrenheit or Celsius. Press and release the SETTINGS

button to confirm and exit the program menu.

Note: When no buttons are pressed for ten seconds, the forecast station

will save the last change and default back to normal time and

temperature display mode.

ALARM TIME

The TIME ALARM button moves through the alarm

set mode and confirms settings.

Use the UP ARROW button to increase a value.

Wireless Color Forecast Station

WS6826 | Quick Setup Guide

Use the DOWN ARROW button to decrease a value.

SET ALARM TIME

From normal time and temperature display mode, press and release the

TIME ALARM button once to show alarm time. Hold the TIME ALARM

button for three seconds to enter alarm set mode.

z HOUR: The Hour will flash. Use the ARROW buttons to set the hour,

and press TIME ALARM button to confirm and switch to minutes.

z MINUTES: The Minutes will flash. Use the ARROW buttons to set the

minutes, and press TIME ALARM button to confirm.

z Press the SETTINGS button to return to normal mode

Note: When no buttons are pressed for ten seconds, the forecast station

will save the last change and default back to normal mode.

ACTIVATE/DEACTIVATE TIME ALARM

z In normal mode, press and release the TIME ALARM button once to

show alarm time.

z Press and release the TIME ALARM button repeatedly to turn

ON/OFF alarm. The alarm icon appears when alarm is activated.

Note: The alarm will ring for 2 minutes then turn off if no buttons are

pressed.

SNOOZE ALARM

When the alarm sounds, press the HI/LOW/OFF button to snooze the

alarm for 10 minutes. The snooze option can be repeated three times.

The alarm icon will flash while the snooze feature is

active.

Note: while the alarm sounds press any button except

the TIME ALARM button to turn the alarm off.

BACKLIGHT

Operating on A/C adapter, the backlight is on continuously when

operating the forecast station with the 5-volt A/C adapter.

Note: When the adapter is NOT in use, the Hi/Low/Off light feature is

not available.

• HIGH: The backlight is defaulted to HI at setup when the Adapter is in

use.

• LOW: Press and release the HI/LOW/OFF button to dim the backlight.

• OFF: Press and release the HI/LOW/OFF button again to turn the

backlight off. Press and release the HI/LOW/OFF button again to return

to full strength.

Note: When the backlight is off, press any button to activate the

backlight for 10 seconds.

Operating on battery power only, press and release the any button

and the backlight will show for 10 seconds.

TEMPERATURE TREND ICONS

The indoor and outdoor temperature trend indicators will update every

30 minutes or less. These trends represent temperature changes over

the past three hours.

Temperature rising more than 2°F /1°C in the past three

hours

Temperature has not changed more than 2°F/1°C

in the past three hours.

Temperature falling more than 2°F /1°C in the past three

hours

USB CHARGE PORT

The integrated USB charging port (on back) will charge your smart

phone, camera or other devices when the forecast station is plugged

into a power outlet with the included 5V A/C adapter.

Note: This is a power-output charging port. The charging port does not

supply power to the forecast station.

Begin charging your external device by connecting the device’s USB

charging cable (not included) to the USB

charging port on the back of the forecast station. Charging times will

vary.

Note: Some USB cables are for data transfer only and cannot be used

for charging. Make sure that the USB cable you use will charge your

device. Most USB cables included with mobile devices will work for

charging.

-USB Power Output: 1A maximum current

-Do NOT overload USB port. Charge 1A devices or less only

HEAT INDEX & DEW POINT TEMPERATURE

HEAT INDEX

Heat Index combines the effects of heat and humidity. It is the apparent

temperature of how hot it feels to a human being. As humidity increases,

the body is unable to cool effectively. The temperature will feel warmer.

View Heat Index: From normal time and temperature display mode,

press the HEAT/DEW button once and Heat Index will show instead of

the outdoor ambient temperature.

Note: Heat index will be the same number as the

temperature until the outdoor temperature is above 80

degrees °F (26.7°C).

DEW POINT TEMPERATURE

Dew Point Temperature is the saturation point of the air, or the

temperature to which the air has to cool in order to create condensation.

The higher the dew points, the higher the moisture content of the air at a

given temperature.

View Dew Point Temperature: From normal time and

temperature display mode, press the HEAT/DEW button

twice and Dew Point temperature will show instead of the

outdoor ambient temperature. The words Dew Point will

show near outdoor temperatures.

Note: Dew Point temperature is lower than the actual temperature.

TEMPERATURE ALERTS

Press and release the TEMP ALERT button to toggle between the

temperature alerts. Hold the TEMP ALERT button to set individual high

and low alerts.

The bell icon indicates each alert that is active.

The MAX TEMP button will turn a temperature alert ON.

This button will increase an alert value in Temp Alert set

mode.

The MIN TEMP button will turn a temperature alert OFF.

This button will decrease an alert value in Temp Alert set

mode.

One or all of the HI and LO temperature alerts may be set.

z Range for indoor temperature alert:

+32°F to +122°F (0°C to 50°C)

z Range for outdoor temperature alert:

-40°F to 140°F (-40°C to 60°C)

SELECT TEMPERATURE ALERT VALUE

Hold the TEMP ALERT button for five seconds, until the forecast station

beeps, to select and set temperature alert values.

z OUTDOOR HI alert will flash. Press the ARROW buttons to set the

alert value, and press the TEMP ALERT button to confirm. Then

press the TEMP ALERT button again switch to OUTDOOR LOW

setting.

z OUTDOOR LO alert will flash. Press the ARROW buttons to set the

alert value, and press the TEMP ALERT button to confirm. Then

press the TEMP ALERT button again switch to INDOOR HI setting.

z INDOOR HI alert will flash. Press the ARROW buttons to set the alert

value, and press the TEMP ALERT button to confirm. Then press the

TEMP ALERT button again switch to INDOOR LOW setting.

Produkt Specifikationer

Mærke:	La Crosse Technology
Kategori:	Vejrstation
Model:	WS 6826

Har du brug for hjælp?

Hvis du har brug for hjælp til La Crosse Technology WS 6826 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Vejrstation La Crosse Technology Manualer

La Crosse Technology TX145WSDR Manual

31 Juli 2025

La Crosse Technology 328-1415 Manual

31 Juli 2025

La Crosse Technology 308-1711BLV3 Manual

31 Juli 2025

La Crosse Technology 308-10847 Manual

21 Juli 2025

La Crosse Technology CA73071 Manual

4 Marts 2025

La Crosse Technology M71633 Manual

8 Januar 2025

La Crosse Technology V41CA Manual

8 Januar 2025

La Crosse Technology CA74177 Manual

26 December 2024

La Crosse Technology S73071 Manual

26 December 2024

La Crosse Technology 308-1415FCT-NH Manual

26 December 2024

Vejrstation Manualer

Nyeste Vejrstation Manualer

Hyundai WS 2303 Manual

10 August 2025

TFA 30.3039 Manual

8 August 2025

TFA Linea Plus 35.1144.01 Manual

7 August 2025

TFA 98.1111.02 Manual

7 August 2025

TFA 30.3900.02 Manual

7 August 2025

TFA View 35.1142 Manual

7 August 2025

Brandson 307346 Manual

5 August 2025

Techno Line WS 9130 Manual

3 August 2025

Theben LUXORliving M140 Manual

3 August 2025

Techno Line WS 9215 Manual

3 August 2025