La Crosse Technology WT-3144P Manual

La Crosse Technology Ur WT-3144P

Læs gratis den danske manual til La Crosse Technology WT-3144P (4 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 18 anmeldelser. Har du et spørgsmål om La Crosse Technology WT-3144P, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Model: WT 3144S www.lacrossetechnology.com/support - Page | 1

Model: WT- 3144S

Instruction Manual

DC: 031115

14” Atomic Wall Clock

Get Started

Step 1: Slide the switch to select a time zone.

Step 2: Insert 1 fresh AA, LR6 1.5 volt ALKALINE battery according to the

polarity marked on the case.

Step 3: For the best reception, please place clock on a wall that faces Ft. Collins,

Colorado. During the night, your clock will automatically set itself.

Note: The hands will move to the 12:00 position and search for the radio signal.

If the radio signal is not received in the first 10 minutes, the clock will start

running from the 12:00 position and will continue to run. Do not attempt to

reset the hands manually even though the time on the clock is incorrect. The

clock is synchronizing to the WWVB signal and once the radio signal is decoded,

the hands will automatically adjust to the correct time. This may take up to 5

nights if there is atmospheric interference.

Position Clock

 For the best reception, please place clock on a wall that faces Ft. Collins,

Colorado.

 Signal reception is at its peak when there is only one wall or window

between the clock and the outside.

 The antenna is best positioned for signal reception when the front or back of

the clock faces Colorado.

 Choose a location 6 feet or more from electronics such as cordless phones,

wireless gaming systems, televisions, microwaves, routers, baby monitors,

etc., which can prevent signal reception.

 Large oce buildings, schools, or hospitals may not receive the WWVB time

signal in every room.

 Building with a metal roof may interfere with reception.

R :eset the clock does not respond to the various function modes, press the If

RESET button on the movement case.

Model: WT 3144S www.lacrossetechnology.com/support - Page | 2

Note: We recommend that you change the battery every 24 months to maintain

accuracy. Remove the battery when the clock will not be in use for an extended

period.

Manual Set Time

On rare occasions in certain areas, the clock

may not be able to utilize the radio controlled

function because of the strength of the signal

or the geographic location. In this case, the

clock can be set manually and used as a

regular quartz wall clock.

Note: Allow up to five nights for the clock to receive the WWVB signal before

manually setting the time.

Set the clock manually:

1. Press and hold the SET button for 3+ seconds to activate the manual mode.

Once the clock is in manual mode, there are two ways to move the minute

hand forward.

 Hold the SET button down to move the minute hand forward

consistently.

 Alternatively, press the SET button rapidly (more than once per second)

to move the minute hand forward step by step (in minute increments).

 Use these features to move the minute hand forward until the correct

time is set. The clock will automatically leave manual mode after the

SET button is not pressed for 6+ seconds.

Troubleshooting

The wonderful advantage of owning a radio controlled clock is that it is virtually -

trouble free. If the clock receives a clear time signal, it will set itself perfectly. If it

does not receive a time signal, consider the following:

 Battery – The clock must have a fresh battery to receive and process the

time signal.

 Location – Try a different location, ideally near a window. Your clock should

be at least six feet from computers, TVs, air conditioners, other radio-

controlled clocks and other electrical appliances that cause interference.

 Weather – Electrical storms between you and Colorado during the night will

interfere with the WWVB signal.

Daylight Saving Time:

The National Institute of Standards and Technology and WWVB encode a special

DST “bit” in the WWVB transmission for DST. Your clock will read this information

and automatically advance the hands one hour in the spring and eleven hours in

the fall.

Arizona

If you live in an area that does not recognize DST, you must slide the DST switch

OFF. To reactivate the DST program simply slide the switch to the ON position.

Produkt Specifikationer

Mærke:	La Crosse Technology
Kategori:	Ur
Model:	WT-3144P

Har du brug for hjælp?

Hvis du har brug for hjælp til La Crosse Technology WT-3144P stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ur La Crosse Technology Manualer

La Crosse Technology 404-2658-INT Manual

4 Marts 2025

La Crosse Technology WT-8112U Manual

12 Januar 2025

La Crosse Technology WT-3145U Manual

10 Januar 2025

La Crosse Technology 404-3025W Manual

8 Januar 2025

La Crosse Technology 25201 Manual

30 December 2025

La Crosse Technology 25509 Manual

30 December 2025

La Crosse Technology 404-3025B Manual

26 December 2024

La Crosse Technology 20802 Manual

26 December 2024

La Crosse Technology 513-23137 Manual

26 December 2024

La Crosse Technology WT-8005U Manual

5 December 2024

Ur Manualer

Nyeste Ur Manualer

Grand Seiko 9F85 Manual

12 September 2025

Grand Seiko 9R01 Manual

11 September 2025

Grand Seiko 9R65 Manual

11 September 2025

Grand Seiko 9R02 Manual

11 September 2025

Grand Seiko 9R15 Manual

11 September 2025

Casio AE2000W-1AV Manual

5 September 2025

Casio AEQ-110 Manual

4 September 2025

Citizen Attesa Satellite Wave GPS Layers of Time CC4057-60E Manual

3 September 2025

Citizen L Mae EM1060-52N Manual

3 September 2025

Citizen Corso Diamond EW2712-55E Manual

3 September 2025