Lenco SP-500 Manual

Lenco Højttaler SP-500

Læs gratis den danske manual til Lenco SP-500 (16 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Lenco SP-500, eller vil du spørge andre brugere om produktet?

Side 1/16
English - 1
SP-300 / SP-400 / SP-500
INSTRUCTION MANUAL 2-Way Speaker System
For information and support, www.lenco.eu
WARNINGS
Don’ts
Do not place naked flames, such as lighted candles on or near the product.
Do not place objects filled with liquids, such as vases on or near the product.
Do not install this product on top of other electrical equipment or on uneven surfaces.
Do not use or store this product in a place where it is subject to direct sunlight, heat, excessive
dust or vibration.
Do not use this product with wet hands.
Do not clean this product with water or other liquids.
Do not block or cover the slots and holes in the product.
Do not push foreign objects into the slots or holes in the product.
Do not attempt to open this product yourself. There are no user serviceable parts inside.
Do not allow children access to plastic bags.
SAFETY WARNINGS
Before using this product, read and follow all warnings and instructions.
This product is not intended for use by young children. Young children should be properly
supervised.
This product is intended for household use only and not for commercial or industrial use.
Do not expose to dripping or splashing.
No naked flame sources, such as lighted candles, should be placed on the product.
Allow suitable distances around the product for sufficient ventilation.
Ventilation should not be impeded by covering ventilation openings with items such as
newspapers, table cloths, curtains and the like.
Make sure the speaker is adjusted to a stable position. Damage caused by using this product in an
unstable position or by failure to follow any other warning or precaution contained within this user
manual will not be covered by warranty.
Lenco suggests retaining the packaging in case for future transport of the product.
SPEAKER PLACEMENT
Lenco recommends placing the speakers as follow:
Have an uninterrupted line of sight to the speakers.
Moving speakers closer to the walls and corners increases the bass but also makes it more uneven.
Try 45 to 120cm to start with and avoid making the distance to the sidewalls the same as the wall behind
the speakers.
Best stereo is usually achieved with the speakers and the listener positioned at
the points of an equilateral triangle as follow and the speakers pointing to a spot
just in front of the listening position. Left – right symmetry helps, so for example
try to avoid heavy curtains on one side only.
These products have shielded magnetic assemblies.
English - 2
CONNECTING THE SPEAKER
Use cable of equal length to both speakers and keep them as short as possible. The excess cable should
be folded concertina fashion into a bundle and tied for neatness. Do not coil it as inductance introduced
may impair high frequencies. Run leads away from mains leads and obvious sources of radio frequency
energy such as mobile cordless telephones. In general, the thicker the speaker cable, the better use
cable where the two conductors are easily distinguished.
Make sure all connections in your Hi-Fi system are clean and tight. Make certain there are no stray
strands of wire bridging the (+) and (-) terminals.
SPEAKER PHASE
If you connect one speaker incorrectly, that speaker may be working in opposition to the other resulting in
poor stereo and bass response. If you suspect this, check by sitting exactly between the speakers and
having someone reverse the connections at ONE END ONLY of ONE speaker cable, leaving all other
connections alone.
OPERATION
Operating the loudspeakers
The loudspeakers have been designed to produce high quality sound with a large dynamic range.
A few simple points should be in mind.
- Low power amplifiers operated at very high volume will produce distortion, which can damage the
high frequency driver.
- Exaggerated setting of bass and treble controls can create significant distortion even when using a
high power amplifier.
- In a noisy background such as a party your hearing becomes insensitive to loud music and
distortion.
Warning
To avoid risk of damage always reduce the volume if you can detect audible distortion.
CHOICE OF AMPLIFIER
A low powered amplifier will give satisfactory results only at low volume settings.
To obtain the best performance from your speakers, try to use an amplifier rated near to or slightly in
excess of the power rating of the loudspeakers.
SPECIFICATIONS
Model SP-300 SP-400 SP-500
Woofer 3” 4” 5”
Tweeter 1” 1” 1”
Frequency Range 100Hz~22KHz 80Hz~22KHz 70Hz~22KHz
Sensitivity (1W/m) 87 dB 87 dB 88 dB
Impedance 4 ohm 8 ohm 8 ohm
Amplifier requirement: 10 ~ 100W 20 ~ 120W 25 ~ 130W
<<< Design and specifications are subject to change without notice >>>
If at any time in the future you should need to dispose of this product please note that: Waste
electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste
Electrical and Electronic Equipment Directive)


Produkt Specifikationer

Mærke: Lenco
Kategori: Højttaler
Model: SP-500

Har du brug for hjælp?

Hvis du har brug for hjælp til Lenco SP-500 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler Lenco Manualer

Lenco

Lenco PA-101 Manual

4 Januar 2025
Lenco

Lenco PA-46 Manual

3 Oktober 2024
Lenco

Lenco PA-50 Manual

30 September 2024
Lenco

Lenco BT-180 Manual

30 September 2024
Lenco

Lenco BTS-5 Manual

17 September 2024
Lenco

Lenco PA-360 Manual

30 August 2024
Lenco

Lenco BT-210 Manual

26 August 2024
Lenco

Lenco BTP-400 v2 Manual

26 August 2024
Lenco

Lenco PA-100 Manual

23 August 2024
Lenco

Lenco SB-210 BT Manual

12 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer