Craig Electronics Inc. warrants this product to be free from
manufacturing defects in material and workmanship under
normal use for a period of 180 days from date of purchase.
If service is required, please return the product to the store
where it was purchased for exchange; or, pack the unit in
the original packing material with all accessories if applicable,
a copy of your sales receipt and a Cashier’s check or
Money Order for $7 (to cover shipping and handling costs)
payable to Craig Electronics Inc. For consumers in Canada,
please make sure that the cashier check or money order is
redeemable through a U.S. bank. Ship your product freight
pre-paid. Your unit will be repaired, replaced or if the unit
can not be repaired or replaced, a refund will be forwarded
to you within four weeks of receipt of your unit. Please ship
This warranty is void if the product has been: a) Used in a
commercial application or rental. b) Damaged through
misuse, negligence, or abuse. c) Modified or repaired by
anyone other than an authorized Craig Electronics Inc.
service center. d) Damaged because it is improperly
connected to any other equipment.
Note: This warranty does not cover: a) Ordinary adjustments
as outlined in the Owner’s Manual which can be performed
by the customer. b) Damage to equipment not properly
connected to the product. c) Any cost incurred in shipping
the product for repair. d) Damage to the product not used in
This warranty is not transferable and only applies to the
original purchase. Any implied warranties, including the
warranty of merchantability, are limited in duration to the
period of this expressed warranty and no warranty whether
expressed or implied shall apply to the product thereafter.
Under no circumstance shall Craig Electronics Inc. be liable
for any loss or consequential damage arising out of the use
of this product. This warranty gives specific legal rights.
However, you may have other rights which may vary from
state to state. Some states do not allow limitations on
implied warranties or exclusion of consequential damage.
Therefore, these restrictions may not apply to you.
This product has been manufactured by and is sold under
the responsibility of Craig Electronics Inc., and Craig
Electronics Inc. is the warrantor in relation to this product.
MAGNAVOX and SMART. VERY SMART are registered
trademarks of Koninklijke Philips N.V. and are used under
license from Koninklijke Philips N.V.
To Obtain Service on your Product
email:service@craigelectronics.com
Printed in China MMA3650_WC_E0FK1_B0WU
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
● Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
2. Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
To assure continued compliance, follow the attached
installation instructions and use only shielded cables
when connecting to other devices. Modifications not
authorized by the manufacturer may void user`s authority
The Bluetooth word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use of
such marks by Craig is under license. Other trademarks
and trade names are those of their respective oweners.”
● When the external BT Device searches for the unit, our
model number “MMA3650” will appear on the display of
● If while pairing you are asked for a code please try "0000"
Normal operation after paired:
1. Power on the external BT Device and enter to BT mode.
2. Press and hold the Button on the unit to power on the
. The Blue Indicator on the unit will illuminate and blink.
3. Wait a few seconds until the unit auto pairs to the
BT Device. (The Blue Indicator will stop blinking).
4. If pairing is complete you may now play music and/or
singing with your external BT Device.
To listen and sing with the music from the external Audio
Player such like MP3 Player, Discman…etc.
1. In power on mode, connect the 3.5mm stereo plug from
the supplied Audio (In) Connection Cable to the AUX
Out/Line Out /Phone Jack on the external Audio Player.
2. Connect the Micro USB Plug from the Connection Cable
to the Micro USB Jack on the unit as illustrated below.
The BT Function will be automatically cut off and the Blue
Indicator will start blinking.
3. Play the music on the connected Player as usual. (Adjust
the music level by the Volume Controls on the connected
4. Sing or speak to the Microphone. Then:
A. Slide the VOL (Microphone Volume) Control Knob on
the unit to adjust the volume level of the Microphone as
B. Slide the ECH (Microphone Echo Effect) Control Knob
to adjust the echo effect of the Microphone as desired.
To listen to music and sing through the external Audio Power
1. Power on the unit and enter to BT playback mode as
2. Connect one end of the supplied Audio (Out) Connection
Cable to the AUX In/Line In Jack on the external Audio
Power Amplifier as illustrated below:
3. Connect the other end of the Connection Cable to the
(Out) Jack on the unit as illustrated
will automatically switch to AUX (Out) mode. (Note:
Sound from the speaker will automatically cut off).
4. To resume to normal playback mode, unplug the cable
The unit has a built-in USB Charger. Use it to charge the
external USB Device as follows:
1. Make sure the unit is in power on mode.
2. Connect the full size USB Plug from the charging cable
(Not included) from external USB Device to the USB
3. Charging will auto start. Monitoring the charging status
by the charging indicators on the external USB Device
4. When finished charging, disconnect the external USB
Device from the USB Port.
A. The capacity of the built-in battery is 1200 mAH
(4.44WH). Never use it to recharge the external USB
Device their battery is bigger than it.
B. Before charging the external USB Device, check the
power of the built-in battery. If the power of the battery
is too low, it cannot use to charge the external USB
Charger has a built-in overload/overheats protector.
the output of the Charger is overload, the unit will shut
off automatically. To reset the unit:
● Unplug the external USB Device from the USB Port.
● Connect the unit to the Computer or USB Charger to
recharge the unit as usual then the unit will be reset.
USB Port (For charging the
external USB Device only)
4. ECH (Microphone Echo Effect)
5. VOL (Microphone Volume)
6. Micro USB Port (For recharging
The unit has a built-in Li-ion rechargeable battery, charge it
before first time use or when it is drained as follows:
1. Connect the small plug from the supplied USB Connection
Cable to the Micro USB Port on the unit.
2. Connect the full sized USB plug from the supplied USB
Connection Cable to the USB Port on the Personal
Computer or USB Charger (Computer and USB Charger
not included) as illustrated below:
To Computer or any USB Charger
3. When charging, the Red Charging Indicator on the unit
will illuminate. When finished charging, it will turn off.
1. When charging, you can play music or sing as usual.
2. Your battery will last longer if you following these simple
guidelines for caring and storing.
A. Before first time use, charge the unit approximately 4
hours until the unit is fully charged.
Charge and store the unit within the temperature range
of 5°C - 35°C (40°F - 95°F).
Do not overcharge (longer than 24 hours). Excessive
charging or running the unit until battery fully drains will
battery. Battery life will be extended if you keep
the battery fully charged.
D. Battery life naturally shortens slowly over time.
E. The rechargeable battery incorporated in this product
BATTERY DISPOSAL WARNING!
To reduce the risk of fire or burns:
Do not disassemble, crush, puncture, or short external
Use only with specified charger and player.
Do not dispose of in fire or water.
Do not dispose to high temperatuer above 60°C ( °F).140
Store between 0°C °F) and 60°C ( °F).(32 140
See operating instructions of this battery or product.
Batteries should be recycled or disposed of as per State and
For first time use or re-pairing the unit to a new BT Device,
follow instructions below:
1. Press and hold the Button to power on the unit. The
Blue Indicator on the unit will illuminate and blink.
2. Power on the external BT Device and enter to BT
searching mode. Start pairing following the on screen
instructions from the external BT Device. When paired,
the Blue Indicator will stop blinking.
3. If pairing is complete you may now play music with your
● Use the Volume Controls on the paired BT Device to
adjust volume level as desired.
● Using the Pause; Skip Controls on the paired BT
Device to pause, skip tracks as desired.
● Sing or speak to the Microphone. Then:
A. Slide the VOL (Microphone Volume) Control Knob
on the unit to adjust the volume level of the
B. Slide the ECH (Microphone Echo Effect) Control
Knob to adjust the echo effect of the Microphone as
Note: If feedback noise (high audio frequency noise)
is sounding from the speaker. Reduce the music
volume level or reduce the microphone volume level
by sliding the VOL (Microphone Volume) Control
5. To shut off the unit, press and hold the Button on the
unit until the Blue Indicator is turned off.
Recharge the battery as page 2
Increase the volume by the
volume controls on the paired
Unplug the Audio Connection
Cable from the AUX (Out) Jack
Reduce the volume level by the
volume controls on the paired
Pair the external BT Device to
Place the external BT device
Built-in battery consumed
Volume of the unit was set
was inserted into the AUX
had NOT paired to the unit
Check the following before requesting service:
1 x Audio (In) Connection Cable with 3.5mm Plugs
1 x Audio (Out) Connection Cable with 3.5mm and Micro
USB Connection Cable with Full size and Micro USB
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT
Out put from the Built-in
Built-in DC 3.7V, 1200 mAH (4.44WH) rechargeable
Li-ion Battery; Recharge by DC 5V through Micro
PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
