2
ENGLISH (Original instructions)
SPECIFICATIONS
Model DLS713
Blade diameter 190 mm
Blade body thickness 1.3 mm - 2.0 mm
Hole (arbor) diameter 20 mm
Max. Miter angle Left 47° , Right 57°
Max. Bevel angle Left 45°, Right 5°
Max. Cutting capacities (H x W) with blade 190 mm in diameter.
Bevel angle
Miter angle 45° (left) 0° 5° (right)
25 mm x 300 mm 52 mm x 300 mm 40 mm x 300 mm
0° -----
* 60 mm x 265 mm (Note 1)
-----
25 mm x 212 mm 52 mm x 212 mm -----
45° (left and right) -----
* 60 mm x 185 mm (Note 2)
-----
----- 52 mm x 163 mm -----
57° (right) -----
* 60 mm x 145 mm (Note 3)
-----
No load speed (min-1
) 2,200
Dimensions (L x W x H) 655 mm x 430 mm x 454 mm
Net weight 12.7 kg
Rated voltage D.C.18 V
(Note)
* mark indicates that a wood facing with the following thickness is used.
1: When using a wood facing 20 mm thickness
2: When using a wood facing 15 mm thickness
3: When using a wood facing 10 mm thickness
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
END014-3
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come to
a complete stop.
･ When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
･ Do not place hand or fingers close to the
blade.
･ Only for EU countries
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment, 2006/66/EC on
batteries and accumulators and waste
batteries and accumulators and their
implementation in accordance with
national laws, electric equipment and
battery pack that have reached the end
of their life must be collected separately
and returned to an environmentally
compatible recycling facility.
ENE076-1
Intended use
The tool is intended for accurate straight and miter
cutting in wood.
Cd
Ni-MH
Li-ion
