Manitowoc IYT0620A Manual

Manitowoc Ismaskine IYT0620A

Læs gratis den danske manual til Manitowoc IYT0620A (6 sider) i kategorien Ismaskine. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Manitowoc IYT0620A, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

Restoring Ice Machine

to Service

Subject: Indigo NXT Ice Machines

AIR-COOLED, WATER-COOLED, REMOTE AIR-COOLED &

QUIETQUBE ICE MACHINES

1 of 6

Document Number: MSC-017 4/20

MANITOWOC ICE MACHINE DIVISION

2110 SOUTH 26TH STREET, MANITOWOC, WI 54220

844-724-CARE

WWW.MANITOWOCICE.COM

RESTORING TO SERVICE PROCEDURES

1. Remove front panel.

Use a Phillips screwdriver to

loosen the screw(s) securing

the door. Do not remove

screw(s) completely; they

are secured to prevent loss.

2. Make sure ice machine

off.

Turn the ice machine OFF

by pressing the power

button.

3. Disconnect main

power at the service

disconnect or breaker.

WARNING

Do not begin cleaning

other parts of the ice

machine until line voltage is

disconnected from the ice

machine and if applicable

dispenser.

4. Empty ice bin, if not

already empty.

Use an ice scoop to remove

all ice from the storage bin

or dispenser.

5. Remove top cover and

evaporator dust cover

(when used).

Lift top cover to remove,

then lift and remove

evaporator dust cover.

6. Remove water curtain

or splash shield.

Remove water curtain

Gently flex the curtain in the

center and remove it from

the right side.

Slide the left pin out.

Manitowoc recommends a Factory Authorized Service company or Distributor Authorized Service Dealer perform

thorough preventative maintenance prior to restoring service of the Manitowoc ice machine, storage bin or

dispenser. Section 4 (Maintenance) of the Installation, Operation and Maintenance manual should be followed to

ensure proper cleaning and sanitizing steps are completed.

Water system components including the water inlet valve, water pump and dump valve may require removal for

inspection or replacement depending on the potable water quality and the length of time the components had no

use. Water cooled ice machines may require the condenser be cleaned and the refrigeration water regulating valve

evaluated for proper performance. Air-cooled condensers should be cleaned. This is also a good time to replace

water filtration, replenish AuCS chemical and replace the Luminice bulb if these Manitowoc accessories are used.

2 of 6

Document Number: MSC-017 4/20

Subject: Restoring Ice Machine to Service Procedures

Remove splash shield

48” models.

Lift the splash shield up and

forward to remove.

Remove splash shields (2)

Dual Evaporator Models.

Grasp the top center of

splash shields. Lift up and

then out.

7. Remove water trough

Depress tabs on right and

left side of the water trough.

Allow front of water trough

to drop as you pull forward

to disengage the rear pins.

Refer to Step 12 for Dual

Evaporator Trough Removal.

8. Remove the water

level probe.

Pull the water level probe

straight down to disengage.

Lower the water level probe

to obtain access. The water

level probe can be descaled

and sanitized at this point

without complete removal.

If complete removal is

desired, disconnect the ice

thickness control wire from

the control board.

NOTE: Some models allow

disconnection of the wire

lead from the water level

probe. Lower the water

level probe until the wiring

connector is visible, then

disconnect the wire lead

connector from the water

level probe and remove

from the ice machine.

Refer to Step 11 for Dual

Evaporator Water Pump and

Water Level Probe Assembly

Removal.

9. Remove the water

pump.

Grasp pump and pull

straight down on pump

assembly until disengaged

and the electrical connector

is visible. Disconnect

the electrical connector.

Remove the water pump

assembly from ice machine.

Refer to Step 11 for Dual

Evaporator Water Pump and

Water Level Probe Assembly

Removal.

Produkt Specifikationer

Mærke:	Manitowoc
Kategori:	Ismaskine
Model:	IYT0620A

Har du brug for hjælp?

Hvis du har brug for hjælp til Manitowoc IYT0620A stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ismaskine Manitowoc Manualer

Manitowoc IYT0620A Manual

13 Juni 2025

Manitowoc RFP0620A Manual

6 Juni 2025

Manitowoc RNP0320A Manual

3 Juni 2025

Manitowoc RFP0320A Manual

3 Juni 2025

Manitowoc CNF0201 Manual

4 September 2024

Manitowoc RNF1020C Manual

4 September 2024

Manitowoc JC-1395 Manual

4 September 2024

Manitowoc K-00068 Manual

4 September 2024

Manitowoc SPA-160 Manual

4 September 2024

Manitowoc D-320 Manual

4 September 2024

Ismaskine Manualer

Nyeste Ismaskine Manualer

Rival 8806 Manual

14 Juni 2025

Avantco KMC-H-422-A Manual

14 Juni 2025

Follett HCC1410ABT Manual

14 Juni 2025

Follett HCC1010ABS Manual

14 Juni 2025

Carpigiani LB 502 Manual

14 Juni 2025

Follett HCC1010AHT Manual

14 Juni 2025

Carpigiani LB-302 RTX Manual

14 Juni 2025

Hoshizaki KMD-705MAJ Manual

13 Juni 2025

Carnival King ICS250 Manual

13 Juni 2025

Carpigiani LB-1002 RTX Manual

13 Juni 2025