Midland MicroMobile MXAT01VP Manual

Midland Radio MicroMobile MXAT01VP

Læs nedenfor 📖 manual på dansk for Midland MicroMobile MXAT01VP (1 sider) i kategorien Radio. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
5900 Parretta Drive KANSAS CITY, MO 64120
PHONE: (816) 241 8500 5713- FAX: (816) 241-
EMAIL: mail@midlandradio.com
WEBSITE: midlandusa.com
Midland Radio Corporation
midlandusa.com
10 16/ /2022
MXAT01 NMO Mount Assembly Diagram
1. The MXAT01 NMO mount is designed for mounting brackets or surfaces up to 1/2" thick.
2. The MXAT01 NMO mount is designed to be installed in a 1/2" hole, commonly used for 3/8” stud mount
CB antennas.
3. Part C should be adjusted so the center conductor on the Part D NMO interface extends 9/32” to 5/16”
beyond the mounting surface, or just above the top surface of Part A when installed.
4. Use the hex head on the Part D NMO interface to hold it in position while Part A is installed and tightened.
5. Part A is installed on top of the bracket or mounting surface with the wrench flats up and the O-ring
down. The rubber O-ring on the bottom of part A acts as a seal to prevent water entering the mounting
s - urface hole. Maximum torque: 32 lb ft.
6. The hex head can also be used to hold the NMO interface in position while tightening the PL259
connector, Part F, by hand.
7. The center conductor of Part D should end up 1/32” to 1/16” proud of Part A to properly interface with
the MXAT01 antenna. Tighten the antenna by hand, to just snug.


Produkt Specifikationer

Mærke: Midland
Kategori: Radio
Model: MicroMobile MXAT01VP

Har du brug for hjælp?

Hvis du har brug for hjælp til Midland MicroMobile MXAT01VP stil et spørgsmål nedenfor, og andre brugere vil svare dig




Radio Midland Manualer

Radio Manualer

Nyeste Radio Manualer