NEC MT1065 Manual

NEC videoprojektorer MT1065

Læs gratis den danske manual til NEC MT1065 (65 sider) i kategorien videoprojektorer. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om NEC MT1065, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/65

Portable Projector

MT1065/MT1060

User’s Manual

English

Deutsch

Français

Italiano

Español

Svenska

E-2

Safety Cautions

Precautions

Please read this manual carefully before using your NEC MT1065/

MT1060 Projector and keep the manual handy for future reference. Your

serial number is located on the right side of your projector. Record it

here:

CAUTION

To turn off main power, be sure to remove the plug from power

outlet.

The power outlet socket should be installed as near to the

equipment as possible, and should be easily accessible.

CAUTION

TO PREVENT SHOCK, DO NOT OPEN THE CABINET.

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED NEC SERVICE PER-

SONNEL.

This symbol warns the user that uninsulated voltage within the

unit may be sufficient to cause electrical shock. Therefore, it is

dangerous to make any kind of contact with any part inside of

the unit.

This symbol alerts the user that important information con-

cerning the operation and maintenance of this unit has been

provided.

The information should be read carefully to avoid problems.

WARNING

TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO

RAIN OR MOISTURE.

DO NOT USE THIS UNIT’S GROUNDED PLUG WITH AN EXTEN-

SION CORD OR IN AN OUTLET UNLESS ALL THREE PRONGS

CAN BE FULLY INSERTED.

DO NOT OPEN THE CABINET. THERE ARE HIGH-VOLTAGE COM-

PONENTS INSIDE. ALL SERVICING MUST BE DONE BY QUALI-

FIED NEC SERVICE PERSONNEL.

DOC Compliance Notice

This Class B digital apparatus meets all requirements of the Canadian

Interference-Causing Equipment Regulations.

Acoustic Noise Information Ordinance-3. GSGV:

The sound pressure level is less than 70 dB (A) according

to ISO 3744 or ISO 7779.

This label is on the side of the remote control.

RF Interference

WARNING

The Federal Communications Commission does not allow any

modifications or changes to the unit EXCEPT those specified

by NEC Soluctions (America), Inc. in this manual. Failure to com-

ply with this government regulation could void your right to

operate this equipment. This equipment has been tested and

found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guar-

antee that interference will not occur in a particular installa-

tion. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio / TV technician for

help.

In UK, a BS approved power cable with moulded plug has a Black (five

Amps) fuse installed for use with this equipment. If a power cable is not

supplied with this equipment please contact your supplier.

Important Safeguards

These safety instructions are to ensure the long life of your projector

and to prevent fire and shock. Please read them carefully and heed all

warnings.

Installation

1. For best results, use your projector in a darkened room.

2. Place the projector on a flat, level surface in a dry area away from

dust and moisture.

To avoid premature lamp failure, do not tilt the front of the projector

up or down by more than 15 from level.°

3. Do not place your projector in direct sunlight, near heaters or heat

radiating appliances.

4. Exposure to direct sunlight, smoke or steam can harm internal com-

ponents.

5. Handle your projector carefully. Dropping or jarring can damage in-

ternal components.

6. Do not place heavy objects on top of the projector.

7. If you wish to have the projector installed on the ceiling:

a. Do not attempt to install the projector yourself.

b. The projector must be installed by qualified technicians in order

to ensure proper operation and reduce the risk of bodily injury.

c. In addition, the ceiling must be strong enough to support the

projector and the installation must be in accordance with any

local building codes.

d. Please consult your dealer for more information.

CAUTION

Do not look into the laser pointer while it is on and do not

point the laser beam at a person. Serious injury could re-

sult.

Important Information

Produkt Specifikationer

Mærke:	NEC
Kategori:	videoprojektorer
Model:	MT1065
Vekselstrømsindgangsspænding:	100 - 240 V
Vekselstrømsindgangsfrekvens:	50 - 60 Hz
Bredde:	334 mm
Dybde:	323 mm
Højde:	115 mm
Vægt:	5900 g
Produktfarve:	Sølv
Indbygget skærm:	Ingen
Produkttype:	Standard kasteprojektor
Wi-Fi:	Ingen
Understøttede videotilstande:	1080i, 1080p, 480i, 480p, 720p
Indbyggede højttaler(e):	Ja
Opbevaringstemperatur (T-T):	-10 - 50 °C
Format til analogt signal:	NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Udgangseffekt (RMS):	10 W
DVI-port:	Ja
Antal USB 2.0-porte:	2
Komponentvideo (YPbPr/YCbCr) indgang:	1
Ethernet LAN:	Ingen
Strømforbrug (standby):	1 W
Strømforbrug (typisk):	390 W
Driftstemperatur (T-T):	0 - 35 °C
Sammensat videoindgang:	1
Understøttede billedformater:	4:3
Støjniveau:	39 dB
Fjernbetjening inkluderet:	Ja
Strømkilde:	Vekselstrøm
Placering:	Desktop
Full HD:	Ingen
Antal indbyggede højttalere:	2
Lyd (L, R) indgang:	2
Kontrastforhold (typisk):	800:1
Horisontal scanningsområde:	15 - 100 kHz
Antal VGA-porte (D-sub):	2
Brændviddeområde:	- mm
Projektor lysstyrke:	3400 ANSI lumens
Projektionsteknologi:	3LCD
Projektor indbygget opløsning:	XGA (1024x768)
Skærmstørrelse kompatibilitet:	25 - 500 "
Projiceringsafstand:	- m
Vertikalt scanningsområde:	48 - 120 Hz
RS-232-porte:	1
Levetid for lyskilde:	2000 t
Lampeeffekt:	275 W
Levetid for lyskilde (økonomisk tilstand):	3000 t
Lyskilde type:	Lampe
Antal af S-video-indgange:	1
Seriel grænsefladetype:	RS-232
Støjniveau (økonomisk tilstand):	34 dB
Projektor lysstyrke (økonomisk tilstand):	2700 ANSI lumens
Pære-strøm (økonomisk funktion):	220 W
Antal Cardbus PCMCIA-slots:	2