NEC MultiSync LT154 Manual

NEC videoprojektorer MultiSync LT154

Læs gratis den danske manual til NEC MultiSync LT154 (28 sider) i kategorien videoprojektorer. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om NEC MultiSync LT154, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/28
MultiSync LT155/LT154
LCD Projector
User’s Manual
English
M
E
N
U
E
N
T
E
R
C
A
N
C
E
L
SEL
ECT
POWER
STATU
S
ON
/
S
TAND BY
SOUR
CE
AU
T
O
ADJ
US
T
PC
CARD
A
CC
ES
S
E – 2
IMPORTANT INFORMATION
Precautions
Please read this manual carefully before using your NEC MultiSync
LT155/LT154 Projector and keep the manual handy for future refer-
ence.
Your serial number is located under the name plate label on the bot-
tom of your MultiSync LT155/LT154. Record it here:
CAUTION
To turn o main power, be sure to remove the plug from
power outlet.
The power outlet socket should be installed as near to
the equipment as possible, and should be easily acces-
sible.
CAUTION
TO PREVENT SHOCK, DO NOT OPEN THE CABINET.
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED NEC SERVICE
PERSONNEL.
This symbol warns the user that uninsulated voltage
within the unit may be sufficient to cause electrical shock.
Therefore, it is dangerous to make any kind of contact
with any part inside of the unit.
This symbol alerts the user that important information
concerning the operation and maintenance of this unit
has been provided. The information should be read care-
fully to avoid problems.
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
DO NOT USE THIS UNIT’S GROUNDED PLUG WITH AN EXTEN-
SION CORD OR IN AN OUTLET UNLESS ALL THREE PRONGS CAN
BE FULLY INSERTED.
DO NOT OPEN THE CABINET. THERE ARE HIGH-VOLTAGE COM-
PONENTS INSIDE. ALL SERVICING MUST BE DONE BY QUALI-
FIED NEC SERVICE PERSONNEL.
DOC Compliance Notice
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
3. GSGV Acoustic Noise Information Ordinance:
The sound pressure level is less than 70 dB (A) according to ISO 3744
or ISO 7779.
RF Interference
WARNING
The Federal Communications Commission does not allow any
modications or changes to the unit EXCEPT those specied by
NEC Technologies in this manual. Failure to comply with this gov-
ernment regulation could void your right to operate this equip-
ment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. How-
ever, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following mea-
sures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
In UK, a BS approved power cable with moulded plug has a Black (ve
Amps) fuse installed for use with this equipment. If a power cable is not
supplied with this equipment please contact your supplier.
C A U T I O N
LASER RADIATION-
DO NOT STATE INTO BEAM
RADIACION LASER
NO MIRE AL RAYO
PRODUCTO LASER CLASSE2
LASER-STRAHLUNG
NICHT IN DEN STRAHL
BLICKEN ! LASER KLASSE2
RAYONNEMENT LASER NE PAS
REGARDER DANS LE FAISCEAU
APPAREIL A LASER DE CLASSE2
EN60825-1 : 1994 + A11 : 1996 MADE IN CHINA
WAVE LENGTH: 650nm
MAX. OUTPUT: 1mW
CLASS 2 LASER PRODUCT
REMOTE
CONTROL
MODEL:
RD-367E
7N900012
• IBM is a registered trademark of International Business Machines
Corporation.
• Macintosh and PowerBook are registered trademarks of Apple Com-
puter, Inc.
• Other product and company names mentioned in this user's manual
may be the trademarks of their respective holders.
This label is located on the back of the remote control.

Produkt Specifikationer

Mærke: NEC
Kategori: videoprojektorer
Model: MultiSync LT154

Har du brug for hjælp?

Hvis du har brug for hjælp til NEC MultiSync LT154 stil et spørgsmål nedenfor, og andre brugere vil svare dig


videoprojektorer NEC Manualer

NEC

NEC PA1505UL Manual

30 August 2025
NEC

NEC PA1705UL Manual

29 August 2025
NEC

NEC P502HLJD-2 Manual

2 August 2025
NEC

NEC PE506WL Manual

1 August 2025
NEC

NEC ViewLight NP-UM352WJL Manual

1 August 2025
NEC

NEC X171Q-B Manual

18 Juli 2025
NEC

NEC NP-ME403U Manual

15 Juli 2025
NEC

NEC NP-PV710UL Manual

15 Juli 2025
NEC

NEC NP-PA804UL Manual

18 Februar 2025
NEC

NEC NP-NC1202L Manual

24 December 2024

videoprojektorer Manualer

Nyeste videoprojektorer Manualer

Panasonic

Panasonic PT-RZ370 Manual

12 September 2025
Philips

Philips PicoPix PPX3414 Manual

12 September 2025
Christie

Christie D13WU2 Manual

11 September 2025
Christie

Christie Captiva DWU500S Manual

11 September 2025
Christie

Christie D13HD2-HS Manual

11 September 2025
Viewsonic

Viewsonic PA504W Manual

11 September 2025
Christie

Christie Boxer 4K30 Manual

11 September 2025
Christie

Christie Crimson WU31 Manual

11 September 2025
Optoma

Optoma ZU707T Manual

11 September 2025
Christie

Christie 4K22A-HS Manual

11 September 2025