Nemco 6004-4 Manual

Nemco Lys 6004-4

Læs gratis den danske manual til Nemco 6004-4 (2 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Nemco 6004-4, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Operating and Maintenance Instructions

Model: -4 (Powder Coat) Infra-red Bulb Warmer With Portable Clamp 6004

INTRODUCTION

1. Please read instructions before using this appliance.

2. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and

injury.

3. Clean machine thoroughly before and after all uses following cleaning instructions below.

ELECTRICAL REQUIREMENTS

1. Plug warmer into a grounded outlet with correct voltage and sufficient power capacity. Refer to the product label (serial plate) on

the warmer for voltage and wattage requirements.

SAFETY INSTRUCTIONS

1. Warning! All power must be disconnected at power source before any service procedure is performed.

2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as

drapes and other furnishings, away from appliance.

3. Extreme caution is necessary when any appliance is used by or near children and whenever the appliance is left unattended.

4. Always unplug appliance when not in use and before cleaning, adjusting or maintaining this machine. To disconnect appliance,

turn controls off and remove plug from outlet.

5. Do not operate any appliance with a damaged cord or plug, after the appliance malfunctions, has been dropped, or damaged.

Return appliance to an authorized service facility for examination, electrical or mechanical adjustment, or repair.

6. Do not use outdoors. This appliance is not intended for use in wet or moist locations. Never locate appliance where it may fall

into water.

7. Connect to properly grounded outlets only. Avoid the use of extension cords. Do not run cord under carpeting, runners, or the

like. Arrange cord away from traffic area and where it will not be tripped over.

8. To prevent a possible fire, it is recommended that the unit is placed on a non-combustible surface.

9. This appliance has electrical parts. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.

PREPARATION

1. Position warmer near the power outlet, at least 5 inches away from any wall.

2. Secure CLAMP ASSEMBLY to counter or table.

3. Slide warmer onto CLAMP ASSEMBLY and tighten THUMB SCREW to secure warmer to CLAMP ASSEMBLY.

4. If warmer fails to work properly when first operated call NEMCO customer service at 1-800-782-6761.

OPERATION

1. Plug CORD into a grounded outlet.

2. Place food products in a pan located directly under the BULB for best results.

3. Adjust FLEXIBLE STEM ASSEMBLY. Do not aim lamp in any direction other than the surface of the table on which the

appliance is mounted. Maintain a distance of at least 13” between lamp and surface of table. Always maintain a distance of at

least 5” between the hood and any wall.

4. Turn warmer off when not in use.

5. Unplug the warmer before changing BULB. To disconnect warmer, turn switch to off and remove plug from power source.

CLEANING

NOTE: Proper maintenance plays an important part in the life span and functioning of the warmer.

1. Turn warmer off and unplug the CORD before cleaning.

2. Clean warmer with a damp sponge and mild soap. Do not immerse in water or other liquid.

TROUBLESHOOTING

Lights not On

Check if unit is plugged in and power switch turned to “ON” position

Check power at receptacle

Check if Bulb has blown

Loose Sockets

Turn o power and check if socket is loose or broken. Remove light bulb and tighten

socket screws as necessary.

Loose Hoods

Turn o power and check if hood is loose. Remove light bulb and tighten hood screws as

necessary

Unit Blows Fuse or Circuit

Breaker

Check to make sure circuit is not overloaded.

NEMCO FOOD EQUIPMENT 301 Meuse Argonne, Hicksville, OH 43526

Phone: (419) 542-7751 Fax: (419) 542-6690 Toll free: 1-800-782- 6761

www.nemcofoodequip.com

45876

3/11/11

Service Part List

Model: 6004-4 (Powder Coat) Infra-red Bulb Warmer with Portable Clamp

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Lys
Model:	6004-4

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 6004-4 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lys Nemco Manualer

Nemco 6008 Manual

14 Juni 2025

Nemco 6000A-2B Manual

14 Juni 2025

14 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

13 Juni 2025

Nemco 6000A-1A Manual

13 Juni 2025

Lys Manualer

Nyeste Lys Manualer

ServIt 423BLPT2 Manual

14 Juni 2025

Satco 60-7280 Manual

14 Juni 2025

Honeywell HWL-02E Max Manual

14 Juni 2025

ServIt 423BLS5 Manual

14 Juni 2025

Tracer Blanca Manual

14 Juni 2025

Satco 60-6432 Manual

14 Juni 2025

Satco 60-7128 Manual

14 Juni 2025

ServIt 423BLPT4 Manual

14 Juni 2025

Satco 60-7142 Manual

14 Juni 2025

Honeywell HWT-05B02 Manual

14 Juni 2025